change wheel Citroen C4 AIRCROSS RHD 2012 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2012, Model line: C4 AIRCROSS RHD, Model: Citroen C4 AIRCROSS RHD 2012 1.GPages: 332
Page 25 of 332

.
23
Familiarisation
Limit the causes of excess
consumption
Spread loads throughout the vehicle; placethe heaviest items in the bottom of the boot,as close as possible to the rear seats.Limit the loads carried in the vehicle and reduce wind resistance (roof bars, roof rack, bicycle carrier, trailer...). Use a roof box inpreference.Remove roof bars and roof racks after use.  
 
 At the end of winter, remove snow tyres and refit your summer tyres.
Observe the recommendations
on maintenance 
Check the tyre pressures regularly, when cold, referring to the label in the door aper ture, driver's side.
Carry out this check in par ticular:-  before a long journey,-   at each change of season,-  after a long period out of use.  Don't forget the spare wheel and the tyres onany trailer or caravan. 
Have your vehicle ser viced regularly (engine oil, oil filter, air filter...) and obser ve the schedule of operations recommended by themanufacturer.
 
 
When refuelling, do not continue after the3 rd 
 cut-off of the nozzle to avoid any over flow.
 
 At the wheel of your new vehicle, it is only after the first 1 800 miles (3 000 kilometres) that you will see the fuel consumption settledown to a consistent average. 
Page 89 of 332

87
3
Comfort
   
 
 
 
 
Rear view mirror 
 Adjustable mirror providing a central rear ward view.
  Equipped with an anti-dazzle system, which darkens the mirror glass and reduces the nuisance to
the driver caused by the sun, headlamps from other vehicles... 
   
 
Manual day/night model
   
Ad
justment
 ) 
 Adjust the mirror so that the glass is directed correctly in the "day" position.  
 
 
 As a safety measure, the mirrors should be adjusted to reduce the "blind spot".
 
 
In order to ensure optimum visibilityduring your manoeuvres, the mirror lightens automatically when reverse gear is engaged.  
 
 
 
Day / night position 
 ) 
 Pull the lever to change to the "night" anti-dazzle position. ) 
 Push the lever to change to the normal 
"day" position.
Automatic day/night model
By means of a sensor, which measures the 
light from the rear of the vehicle, this system automatically and progressively changes
between the day and night uses. 
   
 
 
 
 
 
 
 
Steering wheel adjustment 
 )When stationary, lower the control lever to yrelease the steering wheel adjustment mechanism. ) 
  Adjust the height and reach to suit your 
driving position. )    Pull the control lever to lock the steering 
wheel adjustment mechanism.  
 
As a safety precaution, these operations should only be carried out while the vehicle is stationary.   
Page 110 of 332

108
Driving
   
For Diesel vehicles, when the engine is cold star ting does not take place until thepre-heater warning lamp has gone off.  
 
 
If one of the star ting conditions is not met, a reminder message appears inthe instrument panel screen. In somecircumstances, it is necessary toturn the steering wheel slightly whilepressing the "START/STOP" buttonto assist unlocking of the steering; a message warns you when this isneeded. 
The presence of the electronic keyin the defined zone is essential. For 
reasons of safety, do not leave this area when the engine is running.  
 
 
Switching off using 
the electronic ke
y 
   
If the vehicle is not immobilised, theengine will not stop.  
This message is displayedwhen the driver's door isopened and the vehicle is not 
in "OFF" mode.
 )Press the "STA R T/STOP" button again to change to "OFF" mode.
 )Immobilise the vehicle. 
 )Place the gear lever in neutral for vehicles fitted with a  manual gearbox , or on  Pfor 
vehicles fitted with a  CVT gearbox .  )With the electronic key inside the vehicle, press the " START/STOP 
" button.
  The engine stops. 
  The steering locks when a door is opened or on
locking the vehicle. Each attempt at star tin
g takes around 
15 seconds. If the en
gine does not star t, press
the "START/STOP 
" button once more to tryagain.
The presence of the electronic key inthe vehicle is essential for switching on the ignition and star ting only. Oncethe engine has started,  make surethat the electronic key remains with the vehicle until the end of the journey: other wise you would not be able to lock the vehicle.  
  
Page 178 of 332

176
Practical information
Removing a wheel 
Parking the vehicle 
Immobilise the vehicle where it does not block traffic: if possible, park the vehicle on level, stable and non-slippery ground.
  Apply the parking brake, switch off theignition and engage first gear to lock the wheels.If necessary, place a chock under the wheel diagonally opposite the wheel tobe changed. Never go underneath a vehicle raisedusing a jack; use a stand.
 
 
List of operations 
 )If your vehicle is equipped with security 
wheel bolts (equipment available as an accessory) fit the security socket 5on the 
wheelbrace 1to slacken the security bolt.  )Slacken the other bolts using the 
wheelbrace 1only.