towing Citroen C4 AIRCROSS RHD 2012 1.G Owner's Manual

89
3
Comfort
In order for these systems to be fully effective, follow the operation and maintenance guidelines below: )
To obtain an even air distribution, take care not to obstruct the exterior air intake grilles
located at the base of the windscreen, the nozzles, the vents and the air outlets, as wellas the air extractor located in the boot. )
Do not cover the sunshine sensor, located on the dashboard; this is used for regulation of the digital air conditioning system. )
Operate the air conditioning system for at least 5 to 10 minutes, once or twice a monthto keep it in per fect working order. )
Ensure that the passenger compar tment filter is in good condition and have the filter elements replaced regularly. We recommend the use of a combined passenger compartment filter. Thanks to its special active additive, it contributes to the purification of the air breathed by theoccupants and the cleanliness of the passenger compartment (reduction of allergic symptoms, bad odours and greasy deposits).)
To ensure correct operation of the air conditioning system, you are also advised to haveit checked regularly as recommended in the ser vicing booklet. )
If the system does not produce cold air, switch it off and contact a CITROËN dealer or a qualified workshop.











Recommendations for ventilation and air conditioning


If after an extended stop in sunshine, the interior temperature is very high, firstventilate the passenger compartment for
a few moments. Put the air flow control at a setting high enough to quickly change the air in the passenger compartment.

The air conditioning system does notcontain chlorine and does not present any danger to the ozone layer.

The condensation created by the air conditioning results in a dischargeof water under the vehicle which is perfectly normal.


When towing the maximum load on a steep gradient in high temperatures, switching off theair conditioning increases the available engine power and so improves the towing ability.

105
3
Comfort
Stowing rings
There are four stowing rings in the boot for
securing luggage:
- two rings are located on the boot floor,
- two rings are located on the rear side
pillars.
T
o remove the shelf: )unhook the two cords, )raise the shelf slightly, then remove it.
There are several options
for storing the shelf:


- either upright behind the front seats,

- or flat at the base of the boot.

129
4
Driving

Visual assistance
Front par king sensors
Deactivation / Activation of thefront and rear parking sensors
The function is deactivated by pressing this
button. The indicator lamp in the button goes off.
Pressing this button again reactivates the
function. The indicator lamp in the button
comes on.

Operating fault

The front parking sensors are triggered when
an obstacle is detected in front, a gear isengaged (position Dfor vehicles with a CVT gearbox) and the speed of the vehicle remains
below 6 mph (10 km/h).
The front parking sensors are interrupted if
the vehicle stops for more than five seconds
in for ward
gear, if no fur ther obstacles are
detected or when the speed of the vehicle
exceeds 6 mph (10 km/h).
Remember to deactivate the system if towing a trailer or caravan.



In bad weather or in winter, ensure thatthe sensors are not covered with mud, ice or snow. When the vehicle is moving at a speed below 6 mph (10 km/h), cer tain soundsources (motorcycle, lorry, pneumatic drill, etc.) may trigger the audible signals of the parking sensor system.
In the event o
f an problem, when reverse gear
is engaged this lamp in the button flashes,
accompanied by an audible signal.This supplements the audiblesignal by displaying bars in the screen, in front of or behind the
vehicle.If one of the sensors is fault
y, it
flashes in the instrument panel
screen.
Contact a CITROËN dealer or a
qualified
workshop. Th
ese bars flash at the start of the manoeuvrethen become fixed from a certain distance between the vehicle and the obstacle.

145
6
Safety











Direction indicators
)Left: lower the lighting stalk passing thepoint of resistance.)Right: raise the lighting stalk passing thepoint of resistance.
"Motorway" function
)Press briefly upwards or downwards,
without going beyond the point of resistance; the direction indicators
will flash 3 times.


The function can be deactivated via the colour screen "Equipment" menu.







Hazard warning
lamps
A visual warning by means of the directionindicators to alert other road users to a vehiclebreakdown, towing or accident.)
Press this button, the direction indicators flash.
They can operate with the ignition off.
Automatic operation of
hazard warnin
g lamps
When braking in an emergency, depending on
the deceleration, the hazard warning lampscome on automatically.
They switch off automatically the first time youaccelerate. ) You can also switch them off by pressing
the button.







Horn
Audible warning system to alert other road
users to an imminent danger. ) Press the central part of the steeringwheel.
Use the horn moderately and only in thefollowing circumstances:


- immediate danger,

- approaching a location lackingvisibility.

152
Safety
The seat belt for the centre rear seat is fitted in
the roof.
It has three anchora
ge points and a reel.
Fitting the belt
)Pull out the belt and pass it through the beltguide A . )Pull on the strap and inser t the tongue Binto the left hand buckle. )Inser t the tongue C
into the right-hand buckle.)Check that each buckle has engaged bypulling on the strap.


Removing and stowing the belt
)
Press the red button on buckle C
, and then on the red button on buckle B.)
Guide the belt as it reels in, passing it
through the belt guide A.) Stow the tongue Cin the upper slot D
and
the tongue Bin the lower slot E.
Outer rear seat belts
Each outer rear seat is fitted with a three-point
in
ertia reel seat belt.

Fastening
)Pull the strap, then inser t the tongue in thebuckle.)Check that the seat belt is fastenedcorrectly by pulling the strap.



Unfastening
)Press the red button on the buckle.

174
Practical information























Changing a wheel
The tools are stored in the boot under the floor.
To gain access to them: )Open the boot.)Lift and remove the boot floor. )Ta k e out the tools.
Access to the tools

List of tools

All of these tools are specific to your vehicle. Do not use them for anything else.1.Wheelbrace.
Used to remove the wheel trim and the
wheel fixing bolts.
2. Jack.
Used to raise the vehicle.
3. Handle.
Used to operate the jack. 4.Removable towing eye.
See "Recovering the vehicle".
5
.Security wheel bolt socket (available as an
accessory).
Used to adapt the wheelbrace to thespecial "security" wheel bolts. Procedure for replacin
g a faulty wheel with the spare wheel using the tools supplied with the vehicle.

Wheel with trim
When removing the wheel , remove the trim first using the handle 3
, pulling atthe cutout.When refitting the wheel
, refit the trim starting by placing its cutout opposite the valve and press on its outer edgewith the palm of your hand.

196
Practical information





Recovering the vehicle



General
recommendations

Obser ve the legislation in force in your country.
Ensure that the weight of the towing vehicle is higher than that of the towed vehicle.
The person at the wheel of the towed vehicle must have a valid drivinglicence.
When towing a vehicle with all four wheels on the ground, always use anapproved towing bar; rope and strapsare prohibited.
When towing a vehicle with the engine off, there is no longer any power assistance for braking or steering.
In the following cases, you must always call on a professional recovery service:


- vehicle broken down on a motor way or fast road,

- 4 wheel drive vehicle,

- when it is not possible to put thegearbox into neutral, unlock the steering, or release the parking brake,

- towing with only two wheels on the ground,

- where there is no approved towing bar available...
Towing with the wheels on the groundis only possible on 2 wheel drive (2WD) versions.


Recovery of your vehicle


2 wheel drive (2WD) versions: towingwith the wheels on the ground
)Put the gear lever into neutral (position Nfor the CVT gearbox).)Unlock the steering by by turning the
ignition switch to the " ON
" position (or
t
o " ON " mode for vehicle fitted with the
"Keyless Entry and Star ting" system). )Release the parking brake. )Switch on the hazard warning lamps on both vehicles.)Move off gently and travel slowly for a shor t
distance only.
) Fit the towing bar to the towing eye on thechassis, located under the front bumper.

198
Practical information
) On the rear bumper, remove the cover by
pulling at the bottom using the jack handle 1 . )Screw in the towing eye 2fully using the
wheelbrace 3.)Install the towing bar. )Switch on the hazard warning lamps on both vehicles.)Move off gently and travel slowly for a shor t distance only.
To w i ng another vehicle
Access to the tooling
The towing eye and the tools are stored under
the boot floor. To gain access to them: )open the boot,
)lift and remove the boot floor, )take the towing eye and the tools required.
List of tools1. Jack handle. 2.
To w i ng eye.
3.Wheelbrace.

199
7
Practical information





Towing a trailer, a caravan...
We recommend the use of genuineCITROËN towbars and their harnesses that have been tested and approved from the design stage of your vehicleand that the fitting of the towbar is entrusted to a CITROËN dealer or a qualified workshop.If the towbar is not fitted by a CITROËN dealer, it is imperative thatit is fitted following the manufacturer'sinstructions.
Your vehicle is primaril
y designed for
transporting people and luggage, but it mayalso be used for towing a trailer. Drivin
g with a trailer subjects the towing vehicle
to more significant stress and its driver must be
particularly careful.

200
Practical information
Driving advice
Distribution of loads
)Distribute the load in the trailer so that theheaviest items are as close as possible to
the axle and the nose weight approaches the maximum permitted without exceeding it.
Air density decreases with altitude, thus reducing engine performance. Above
1 000 metres, the maximum towing load must
be reduced by 10 % of the GTW and so on for every 1 000 metres of altitude.
Refer to the "Technical Data" section for details
of the weights and towing loads which apply to your vehicle.
Side wind
)Take into account the increased sensitivity
to side wind.

Cooling

To w i ng a trailer on a slope increases the
temperature of the coolant.
As the fan is electricall
y controlled, its cooling capacity is not dependent on the engine speed.)
To lower the engine speed, reduce your speed.
The maximum towing load on a long slope
depends on the gradient and the outside
tem
perature.
In all cases, pay attention to the coolant
temperature.
) If this message is displayed, stop your vehicle as soon as it is safe to do so.


Braking

To w i ng a trailer increases the braking distance.


Tyres
)Check the tyre pressures of the towingvehicle and of the trailer, obser ving the recommended pressures.



Lighting
)Check the lighting and signalling on the
trailer.
I
f the message flashes slowly, wait for the engine to cool before topping up the level, if necessary.
If the messa
ge flashes rapidly, contact a CITROËN dealer or a qualified workshop
without delay.