height CITROEN C4 PICASSO 2010 Owners Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2010, Model line: C4 PICASSO, Model: CITROEN C4 PICASSO 2010Pages: 352, PDF Size: 10.66 MB
Page 7 of 352
Downloaded from www.Manualslib.com manuals search engine 5
FAMILIARISATION
Panoramic sunroof
91
Opening rear screen
90
Pneumatic rear suspension
This enhances driving comfort and
maintains a constant body height,
whatever the vehicle load.
171
Exterior side spotlamps
These light up the zones facing the
driver’s and passenger’s doors.
98
Door mirrors
With electric foldback.
Automatically tilts in reverse gear.
76
EXTERIOR
Page 10 of 352
Downloaded from www.Manualslib.com manuals search engine 8
FAMILIARISATION
CITROËN
Grand C4 Picasso
Torch
Pneumatic rear
suspension
Allows the height of the rear
of the vehicle to be adjusted Access to
spare wheel
Temporary puncture repair kit
Depending on model, the kit is located either in the boot well or in the compartment under the left hand
second-row passenger (open the fl ap by turning the screw a quarter turn).
This kit is a complete system for a temporary repair; it is made up of a compressor and a sealant car-
tridge. Luggage cover blind Luggage cover in two
sections
Torch
111
11 2
187
171
183
116
CITROËN
C4 Picasso
BOOT
Refer also to the section "Practical information - § Changing a wheel".
186
Page 16 of 352
Downloaded from www.Manualslib.com manuals search engine 14
FAMILIARISATION
Adjusting the steering wheel
The steering wheel can be adjusted for
height and reach.
Release the steering wheel by pulling
lever A
towards you.
Adjust the position of the steering
wheel then lock it pushing the lever fully
back.
77
It automatically and progressively
changes between day use and night
use. This operates with the ignition switched on.
From the driver’s seat, select the door
mirror by moving control 1
to the left or
right, then adjust the door mirror as re-
quired in four directions using control 2
.
Demisting-defrosting of the door mirrors
is linked to that of the rear screen.
105
76
For safety reasons, these adjust-
ments must not be carried out whilst
driving.
This additional mirror 1
allows you to
monitor the rear passengers. It can be
tilted to eliminate dazzle.
Door mirror foldback
When the vehicle is parked, the door
mirrors can be folded back either man-
ually or automatically.
SITTING COMFORTABLY
Automatic photochromic rear
view mirror
Door mirror adjustment
77
Child surveillance mirror
Page 17 of 352
Downloaded from www.Manualslib.com manuals search engine 15
FAMILIARISATION
Front seats
Head restraint
Backrest angle
Seat height adjustment
Lumbar support
Forwards-backwards
adjustment
Armrest
Electric adjustments
Manual adjustments
68
Heated seat control
(lo-
cated on the inside of the
front seats)
67
1.
Adjustment of seat height, angle
and forwards-backwards position
2.
Adjustment of backrest angle and
lumbar support
3.
Driver: storing driving positions
The seats can also be adjusted on a
temporary basis:
- on opening one of the front doors,
- after switching on the ignition.
SITTING COMFORTABLY
Page 18 of 352
Downloaded from www.Manualslib.com manuals search engine 16
FAMILIARISATION
Adjusting the seat belt height
To adjust the seat belt, squeeze the
control and slide it in the direction re-
quired.
131
From the driver’s seat position, the con-
trols located on the door are used to op-
erate the electric windows.
86
)
Slide the blind on the visor to the
desired position by pushing at A
.
The blinds are extended on the sun
visor rails.
)
Fold the visor downwards, to pre-
vent being dazzled.
Panoramic sunroof blind
Opening (positions 1
to 9
)
Closing (position 0
)
The blind has an anti-pinch system.
91
SITTING COMFORTABLY
Electric windows controls
Sliding sun visors
105
Page 69 of 352
Downloaded from www.Manualslib.com manuals search engine III
67
COMFORT
FRONT SEATS
MANUAL ADJUSTMENTS
1. Forwards-backwards
adjustment
Raise the control bar, then slide the
seat to the position desired.
2. Lumbar support
Rotate the control until you attain
the position desired.
3. Seat height adjustment
Raise or lower the the control the
number of times necessary to obtain
the position desired.
4. Backrest angle
Operate the control and adjust the
angle of the backrest.
It is possible to incline the back-
rest 45° rearwards by tilting it until it
locks; to unlock it, lift the control.
5. Armrest
To adjust the position of the armrest,
pull it up and then fully down, and
then raise it to the desired position.
6. Head restraint
To raise it, pull it upwards. To lower
it, press on the control as well as on
the head restraint.
The adjustment is correct when the
top of the head restraint is level with
the top of the head.
It can also be adjusted for tilt (de-
pending on version).
To remove it, press on the unlocking
button and pull it upwards.
To adjust the head restraint for-
wards/backwards, move the base of
the head restraint to obtain the posi-
tion desired.
Never drive without the head re-
straints fi tted. They must be in
place and adjusted correctly.
Page 70 of 352
Downloaded from www.Manualslib.com manuals search engine III
68
COMFORT
FRONT SEATS
1. Adjustment of the
seat height and angle,
forwards-backwards
2. Adjustment of backrest
angle and lumbar support
The seats can also be adjusted elec-
trically for a short period:
- on opening one of the front
doors,
- after switching off the ignition.
Heated seats control
ELECTRIC ADJUSTMENTS
Raise or lower the front of
control to raise or lower the
front of the seat base (on
driver’s seat).
Raise or lower the rear of
control to raise or lower the
seat.
Action control forwards or
backwards to slide the seat
forwards/backwards. Push the top of control
forwards or backwards to
adjust the backrest angle.
Raise or lower control to
increase or decrease the
lumbar support.
With the engine running, the front
seats can be heated individually.
)
Use the corresponding adjust-
ment wheel, placed on the inner
side of each front seat, to switch
on and select the level of heating
required:
0
: Off.
1
: Low.
2
: Medium.
3
: High.
Page 79 of 352
Downloaded from www.Manualslib.com manuals search engine III
77
COMFORT
Rear view mirror
Adjustable mirror providing a central
rearward view.
Equipped with an anti-dazzle sys-
tem, which darkens the mirror glass:
this reduces the nuisance to the
driver caused by the headlamps
from following vehicles, low sun...
Manual day/night model
Adjustment
)
Adjust the mirror so that the
glass is directed correctly in the
"day" position.
Day/night position
)
Pull the lever to change to the
"night" anti-dazzle position.
)
Push the lever to change to the
normal "day" position.
By means of a sensor, which mea-
sures the light from the rear of the
vehicle, this system automatically
and progressively changes between
the day and night uses.
STEERING WHEEL ADJUSTMENT
The height and reach of the steer-
ing wheel can be adjusted to adapt
the driving position to the size of the
driver.
Adjustment
)
First, adjust the driver's seat to
the most suitable position.
)
When stationary
, pull the control
lever to unlock the steering wheel
adjustment.
)
Adjust for height and reach.
)
Push the control lever to lock the
steering wheel adjustment.
After locking, if you press fi rmly on
the steering wheel, a slight click may
be heard.
As a safety measure, the mirrors
should be adjusted to reduce the
"blind spot".
Automatic day/night model
As a safety precaution, these
operations must only be carried out
while the vehicle is stationary.
In order to ensure optimum visibility
during your manoeuvres, the mirror
lightens automatically when reverse
gear is engaged.
Page 100 of 352
Downloaded from www.Manualslib.com manuals search engine V
98
VISIBILITY
OF XENON HEADLAMPS
This system adjusts the height of the
xenon headlamp beams automati-
cally and when stationary, according
to the load in the vehicle, so as to
avoid causing a nuisance to other
road user.
If a malfunction occurs,
this warning lamp is dis-
played in the instrument
panel, accompanied by
an audible signal and a message in
the screen.
The system then places your head-
lamps in the lowest position.
Do not touch the xenon bulbs.
Contact a CITROËN dealer or a
qualifi ed workshop.
MANUAL ADJUSTMENT OFHEADLAMPS
To avoid dazzling other road users,
the height of the halogen bulb head-
lamps must be adjusted according
to the load in the vehicle. To do this,
turn the control, located below the
dashboard to the left of the driver, to
the appropriate position:
0.
1 or 2 people in the front seats.
-.
3 people.
1.
4 to 7 people.
-.
Intermediate setting.
2.
4 to 7 people + maximum autho-
rised loads.
-.
Intermediate setting.
3.
Driver + maximum authorised loads.
Initial setting is position " 0
".
EXTERIOR SIDE SPOTLAMPS
Switching on
The side spotlamps come on tempo-
rarily:
- when you unlock the vehicle,
- when you press the lighting button
on the remote control,
-
with the automatic guide-me-home
lighting, on switching off the ignition,
- when you remove the key from
the ignition,
- when you open a door,
- when you use the remote control
to locate the vehicle.
Page 133 of 352
Downloaded from www.Manualslib.com manuals search engine VIII
131
SAFETY
SEAT BELTS
Front seat belts
The front seat belts are fi tted with a
pretensioning system and force limiter.
This system improves safety in the front
seats in the event of a front impact.
Depending on the seriousness of the
impact, the pretensioning system in-
stantly tightens the seat belt against
the body of the occupant.
Fastening
)
Pull the belt down in front of you
in a steady movement, making
sure that it does not become
twisted.
)
Press the fastening into its buckle.
)
Check that it is properly secured
and that the automatic locking
mechanism operates correctly
by pulling sharply on the belt
strap.
)
The lap strap should be posi-
tioned as low down as possible in
the lap and as tight as possible.
)
The diagonal strap should be
positioned across the chest and
away from the neck.
Each belt has a reel that adjusts its
length automatically to the girth of
the seat occupant.
Height adjustment
The pretensioning seat belts are
active when the ignition is on.
The force limiter reduces the pres-
sure of the seat belt against the
chest of the occupant, so increasing
his protection.
When correctly adjusted, the seat
belt shoulder strap falls over the
middle of the shoulder.
)
To adjust the belt, squeeze the
control and slide it in the direc-
tion required.
Unfastening
)
To unfasten the belt, press on
the red button in the buckle.
The belt retracts automatically when
not in use.