driver seat adjustment Citroen C4 PICASSO 2016 2.G Owner's Manual

75
C4-Picasso-II_en_Chap03_ergonomie-confort_ed01-2016
Front seats
Manual adjustments
Forwards-backwards
F Raise the control bar and slide the seat for wards   or   backwards.
When the seat is in the desired position, push
it
  for wards   and   backwards   without   raising   the  
c

ontrol   bar   to   check   that   it   has   latched.
Driver's seat backrest angle
F Turn  the   knob   to   adjust   the   seat   backrest.
As
 
a
 
safety
 
measure,
 
seat
 
adjustments
 
should   only   be   done   when   stationary.
Driver's seat height
F Pull the control upwards to raise or push
it downwards to lower, as many times as
necessary,
  to   obtain   the   desired   position.
Seat
 
consisting
 
of
 
a
 
seat
 
cushion,
 
a
 
seat
 
backrest
 
and
 
a
 
head
 
restraint
 
which
 
can
 
all
 
be
 
adjusted
 
to
 
adapt   your   position   for   ease   of   driving   and   comfort.
Before
 
moving
 
the
 
seat
 
backwards,
 
ensure
 
that
 
there
 
is
 
nothing
 
that
 
might
 
prevent
 
the
 
full
 
travel
 
of   the   seat,   so   as   to   avoid   the   risk   of   jamming  
t

he
 
seat
 
caused
 
by
 
the
 
presence
 
of
 
objects
 
on
 
the
 
floor
 
behind
 
the
 
seat
 
or
 
rear
 
passengers.
 
If
 
the
  seat   jams,   stop   the   movement   immediately.
3
Ease of use and comfort

77
C4-Picasso-II_en_Chap03_ergonomie-confort_ed01-2016
Front seats
Electric adjustments
Forwards-backwards
(driver's seat)
F Push the control for wards or rear wards to slide   the   seat.
Seat backrest angle
F Tilt the control for wards or rear wards to adjust   the   angle   of   the   seat   backrest.
Seat cushion height and angle
F Operate the rear part of the control upwards or downwards to obtain the
desired
 h

eight.
F

O
perate the front part of the control
upwards or downwards to obtain the
desired
 a

ngle.
To avoid discharging the battery, carry out these   adjustments   with   the   engine   running.
Before moving the seat backwards, ensure that there is nothing that might prevent the full travel of the seat, so as to avoid the risk of jamming the   seat   caused   by   the   presence   of   objects   on   the   floor   behind   the   seat   or   rear   passengers.   If   the   seat   jams,   stop   the   movement   immediately.
3
Ease of use and comfort

78
C4-Picasso-II_en_Chap03_ergonomie-confort_ed01-2016
System which registers the electrical settings of   the   driver's   seat   and   door   mirrors.   It   enables  
y

ou   to   store   and   recall   two   positions   using   the  
b

uttons   on   the   side   of   the   driver's   seat.
Storing driving positions
Storing a position
Using buttons M / 1 / 2
F Switch  on   the   ignition.
F  A djust   your   seat   and   the   door   mirrors.
F

P
ress button M , then press button 1 or 2
within
  four   seconds.
An
  audible   signal   indicates   that  
t
he   position   has  
b

een   stored.
Storing
  a   new   position   cancels   the   previous  
p

osition.
Recalling a stored position
Ignition on or engine running
F Press button 1 or 2 to recall the corresponding p osition.
An
  audible   signal   confirms   that   adjustment   is  
c

omplete.
You can interrupt the current movement by
pressing
  button   M, 1 or 2
  or   by   using   one   of   the  
s

eat   controls.
A stored position cannot be recalled while
driving.
Recalling
  stored   positions   is   deactivated  
4

5 seconds   after   switching   off   the   ignition.
Ease of use and comfort

81
C4-Picasso-II_en_Chap03_ergonomie-confort_ed01-2016
Heated seats control
F Use  the   adjustment   wheel   to   switch   on   and  s
elect   the   level   of   heating   required:
0 :
  Off.
1 :
  Low.
2 :
  Medium.
3 :
  High.
With
  the   engine   running,   the   front   seats   can   be  
h

eated
 s
eparately.
Before
 
operating
 
the
 
leg
 
rest,
 
ensure
 
t

hat
 
nothing
 
could
 
inter fere
 
with
 
its
 
m

ovement.Electric passenger seat
F Push   the   control   for wards   or   backwards   to  u
nfold   or   fold   away   the   leg   rest.
The movement stops when you release the
control.
Front armrest
Height adjustment
F Fully   lower   the   armrest.
F R aise it to the required position (low,
intermediate
  or   high).
F
 
O
nce   in   the   high   position,   lift   to   release   it  
a

nd   return   it   to   the   low   position.
Comfort system for the driver and front
passenger.
3
Ease of use and comfort

100
C4-Picasso-II_en_Chap03_ergonomie-confort_ed01-2016
"Rear" function
F Press  this   button   to   activate   /  d
eactivate   the   "Rear"   function.
From
 
the
 
secondary   page   of   the   Air
conditioning
 m
enu:
This
 
function   gives   rear   passengers   access   to  
t

he
 
adjustment   controls   and   allows.
-

t

he distribution of air conditioned air to the
vents for the 2
nd row of seats,
-
t
he distribution of ambient air to the vents
for
 
the
 
3
rd row of seats.
F
T
urn the upper wheel to open or close the
rear
  vent.
F
 
T
urn   the   lower   knob   to   reduce   (to   the   left)  
o

r   increase   (to   the   right)   the   air   flow.
Settings for passengers in
the 2nd row of seats"Mono" function
The comfort setting for the passenger's side c
an   be   indexed   to   the   driver's   comfort   setting  
(

mono-zone).
From
  the   secondary   page   of   the   Air
conditioning
 m

enu:
F
 
P
ress   this   button   to   activate   /  
d

eactivate   the   "Mono"   function.
The function is deactivated automatically when
the
 p

assenger
 u
ses
 t
heir
 t
emperature
 se
tting
 b

uttons.
Ease of use and comfort

232
C4-Picasso-II_en_Chap06_securite_ed01-2016
The driver must ensure that passengers use the seat belts correctly and that they are all
fastened
  before   setting   off.
Wherever you are seated in the vehicle,
always fasten your seat belt, even for short
journeys.
Do
  not   interchange   the   seat   belt   buckles   as  
t

hey   will   not   fulfill   their   role   fully.
The seat belts are fitted with an inertia reel
permitting
  automatic   adjustment   of   the  
l

ength   of   the   strap   to   your   size.   The   seat   belt  
i

s   stowed   automatically   when   not   in   use.
Before and after use, ensure that the seat
belt
  is   reeled   in   correctly.
The lower part of the strap must be
positioned
  as   low   as   possible   on   the   pelvis.
The upper part must be positioned in the
hollow
  of   the   shoulder.
The inertia reels are fitted with an automatic
locking
  device   which   comes   into   operation   in  
t

he   event   of   a   collision,   emergency   braking  
o

r   if   the   vehicle   rolls   over.   You   can   release  
t

he   device   by   pulling   the   strap   firmly   and  
t

hen   releasing   it   so   that   it   reels   in   slightly.Recommendations for children
Use a suitable child seat if the passenger is less than 12 years old or shorter than one
and
  a   half   metres.
Never use the same seat belt to secure more
than
  one   person.
Never
  allow   a   child   to   travel   on   your   lap.
For more information on Child seats , refer
to
  the   corresponding   section.
In
 
order
 
to
 
be
 
effective,
 
a
 
seat
 
belt
 
must:
-
 b
e
 
tightened
 
as
 
close
 
to
 
the
 
body
 
as
 p
ossible,
-

b

e pulled in front of you with a smooth
movement,
 
checking
 
that
 
it
 
does
 
not
 
t

wist,
-

b

e used to restrain only one person,
-
 
n

ot
 
bear
 
any
 
trace
 
of
 
cuts
 
or
 
fraying,
-

n

ot be converted or modified to avoid
affecting
 it

s
 p

erformance.
In the event of an impact
Depending on the nature and
seriousness of the impact , the
pretensioning
  device   may   be   deployed  
b

efore   and   independently   of   the   airbags.  
D

eployment of the pretensioners is
accompanied
  by   a   slight   discharge   of  
h

armless   smoke   and   a   noise,   due   to   the  
a

ctivation   of   the   pyrotechnic   cartridge  
i

ncorporated   in   the   system.
In
  all   cases,   the   airbag   warning   lamp   comes  
o

n.
Following
  an   impact,   have   the   seat   belts  
s

ystem   checked,   and   if   necessary   replaced,  
b

y a CITROËN dealer or a qualified
workshop.
In accordance with current safety
regulations,
 
for
 
all
 
repairs
 
on
 
your
 
vehicle's
 
s

eat
 
belts,
 
go
 
to
 
a
 
qualified
 
workshop
 
with
 t
he
 
skills
 
and
 
equipment
 
needed,
 
which
 
a
 C
ITROËN
 
dealer
 
is
 
able
 
to
 
provide.
Have
 
your
 
seat
 
belts
 
checked
 
regularly
 
by
 
a

 
CITROËN
 
dealer
 
or
 
a
 
qualified
 
workshop,
 
p

articularly
 
if
 
the
 
straps
 
show
 
signs
 
of
 
d

amage.
Clean the seat belt straps with soapy
water
 
or
 
a
 
textile
 
cleaning
 
product,
 
sold
 
by
 
C

ITROËN
 
dealers.
After
 
folding
 
or
 
moving
 
a
 
seat
 
or
 
rear
 
bench
 
s

eat, ensure that the seat belt is positioned
and
 
reeled
 
in
 
correctly.
Advice
Safety