Citroen C4 PICASSO RHD 2012 1.G Owner's Manual

IX
169
DRIVING
PARKING SENSORS
This system indicates the proximity
of an obstacle (person, vehicle, tree,
gate, etc.) which comes within the
fi eld of detection of sensors located
in the bumper.
Certain types of obstacle (stake,
roadworks cone, etc.) detected ini-
tially will no longer be detected at
the end of the manoeuvre due to the
presence of blind spots.


Visual assistance
This supplements the audible signal
by displaying bars in the multifunc-
tion screen which move progressively
nearer to the vehicle. When the ob-
stacle is near, the "Danger" symbol is
also displayed in the screen.

Audible assistance
The proximity information is given
by an intermittent audible signal, the
frequency of which increases as the
vehicle approaches the obstacle.
The sound emitted by the speaker
(right or left) indicates the side on
which the obstacle is located.
When the distance between the
vehicle and the obstacle becomes
less than approximately thirty centi-
metres, the audible signal becomes
continuous.


This function cannot, in any circum-
stances, take the place of the vigi-
lance and responsibility of the driver.



Rear parking sensors

The system is switched on by engag-
ing reverse gear. This is accompanied
by an audible signal.
The system is switched off when you
exit reverse gear.

IX
170
DRIVING






Front parking sensors

In addition to the rear parking sensors,
the front parking sensors are triggered
when an obstacle is detected in front
and the speed of the vehicle is still be-
low 6 mph (10 km/h).
The front parking sensors are inter-
rupted if the vehicle stops for more
than three seconds in forward gear,
if no further obstacles are detected
or when the speed of the vehicle ex-
ceeds 6 mph (10 km/h).
The sound emitted by the speaker
(front or rear) indicates whether the
obstacle is in front or behind.



Deactivation/Activation of the
front and rear parking sensors
The function is deactivated by press-
ing this button. The indicator lamp in
the button comes on.
Pressing this button again reacti-
vates the function. The indicator
lamp in the button goes off.



The function will be deactivated au-
tomatically if a trailer is being towed
or a bicycle carrier is fi tted (vehicle
fi tted with a towbar or bicycle car-
rier recommended by CITROËN).



Operating fault

In the event of a malfunction
of the system, when reverse
gear is engaged this warn-
ing lamp is displayed in the
instrument panel and/or a message
appears in the screen, accompanied
by an audible signal (short beep).
Contact a CITROËN dealer or a
qualifi ed workshop.


In bad weather or in winter, ensure
that the sensors are not covered
with mud, ice or snow. When re-
verse gear is engaged, an audible
signal (long beep) indicates that the
sensors may be dirty.
When the vehicle is moving at a
speed below 6 mph (10 km/h), cer-
tain sound sources (motorcycle,
lorry, pneumatic drill, etc.) may trig-
ger the audible signals of the parking
sensor system.

IX
171
DRIVING
PNEUMATIC SUSPENSION

Grand
C4 Picasso

C4 Picasso

The pneumatic rear suspension en-
hances driving comfort by maintain-
ing a constant body height whatever
the vehicle load.

Operation



- If there is an increase in vehicle
load, a sinking of the rear of
the vehicle is detected and the
pneumatic springs infl ate in or-
der to compensate for the extra
weight.

- If there is a decrease in load, a
rising of the rear of the vehicle is
detected and so the pneumatic
springs defl ate to return the ve-
hicle to its nominal height.

- If the vehicle has been unused
for a long period, the pneumatic
springs may infl ate if necessary
when you unlock or open a door,
so as to return the vehicle to its
nominal height.
If you do not reactivate the system
manually, automatic height correc-
tion will be activated as soon as the
vehicle starts to move. During height
correction, the service warning lamp
comes on and a message on the
screen reminds you not to exceed
6 mph (10 km/h).
The automatic correction does not
function if the doors or the boot are
open.
The automatic correction operates
even if your vehicle is in power
economy mode.
Activation/Deactivation
The automatic height correction can
be deactivated:


)
press button B
located on the
left hand boot interior trim for ap-
proximately two seconds,

)
release the button when you
hear a beep. Deactivation is con-
fi rmed by the lighting of the indi-
cator lamp in button B
.

In the event of a system fault,
alert messages, always in asso-
ciation with the service warning
lamp, will appear in the instru-
ment panel . Contact a CITROËN
dealer or a qualifi ed workshop.

You must deactivate the system in
the following circumstances:


- when working under the vehicle,

- when changing a wheel,

- when transporting the vehicle on
a lorry or ferry.
To reactivate automatic height cor-
rection:


)
press button B
again for approxi-
mately two seconds,

)
release the button when you hear
a beep. Activation is confi rmed
by the extinction of the indicator
lamp in button B
.

IX
172
DRIVING

Loading/unloading
assistance

Grand
C4 Picasso

C4 Picasso

The pneumatic suspension has an
additional function: the possibility to
raise or lower the height of the rear
of the vehicle when stationary, in or-
der to facilitate loading/unloading of
the boot.
Increasing the height of the boot
fl oor


)
Press continuously the top con-
trol A
, which is located in the
boot, on the left-hand side.
This action will be accompanied by
an audible signal. You can stop the
movement at any time by releasing
the control.
3 beeps will confi rm that the move-
ment has gone as far as it can.

Returning to the normal height



)
Press briefl y the bottom of con-
trol A
twice.


Decreasing the height of the boot
fl oor


)
Press continuously the bottom of
control A
.
This action will be accompanied by
an audible signal. You can stop the
movement at any time by releasing
the control.
3 beeps will confi rm that the move-
ment has gone as far as it can.
Returning to the normal height



)
Press briefl y the top of control A

twice.
Driving with the boot in a
low position may damage
underbody components.

Particular points



- If you start the vehicle without
having returned it to the normal
height, automatic correction will
activate as soon as the vehicle
starts to move. During the cor-
rection, the service warning
lamp comes on and a message
on the screen reminds you not to
exceed 6 mph (10 km/h).

- Loading assistance does not
function in the following circum-
stances:


- If button B
is illuminated,

- in power economy mode,

- when you fi
rst use the function,
press control A
for two seconds
to initialise the system. The sys-
tem will respond normally to sub-
sequent operation of the control.

173
CHECKS

PARTNERS IN PERFORMANCE
AND PROTECTING THE
ENVIRONMENT

Innovation in the search for
performance
For over 40 year, the TOTAL Research and
Development departments have developed
for CITROËN, lubricants to match the
latest technical innovations on CITROËN
vehicles, both for competition and for every-
day motoring.
For you, this is an assurance that you will
obtain of the best performance for your
engine.

Optimum protection for your
engine
By having your CITROËN vehicle
serviced with TOTAL lubricants,
you are contributing towards
improving the life and perfor-
mances of your engine, while
also protecting the environment.

prefers

X
174
CHECKS

Opening


)
At the front of the bonnet, push
the exterior safety catch B
to the
left and raise the bonnet.

)
Unclip the stay C
from its housing.

)
Fix the stay in the notch to hold
the bonnet open.


Closing



)
Take the stay out of the support
notch.

)
Clip the stay in its housing.

)
Lower the bonnet then slam it
closed at the end of its travel.

)
Pull on the bonnet to check that
it is fully closed.
The location of the interior release
lever prevents opening of the bon-
net while the left hand door is
closed.
This operation must only be carried
out when the vehicle is stationary.
Avoid opening the bonnet in strong
winds.
When the engine is hot, take care
when handling the exterior safety
catch and the bonnet stay (risk of
burns).


)
Open the left hand front door.

)
Pull the interior release lever A
,
located at the bottom of the door
frame.





Before doing anything un-
der the bonnet, switch off
the Stop & Start system
to avoid any risk of injury result-
ing from an automatic change to
START mode.

X
175
CHECKS
BLEEDING THE DIESEL FUEL
FILTER

Protective cover


Removal


)
Remove the protective cover by
unclipping fi rst point 1
, then 3

and 4
.

)
Unclip point 2
pulling towards
you, then lift.

Refi tting


)
Clip point 2
fi rst.

)
Lower the cover, centring it.

)
Clip points 1
and 4
, pushing ver-
tically and slightly rearwards.

)
Clip point 3
, pushing vertically.



Bleeding water from the fuel
filter
Bleed the fi lter regularly (at every oil
change).
To evacuate the water, slacken the
bleed screw or the water-in-Diesel
sensor, which is located at the base
of the fi lter.
Persist until water ceases to fl ow
out.
Then retighten the bleed screw or
the water-in-Diesel sensor.

X
176
CHECKS
RUNNING OUT OF FUEL(DIESEL)

1.6 litre HDi engine

Detach the protective cover for ac-
cess to the priming pump.


2.0 litre HDi engine

Detach the protective cover for ac-
cess to the priming pump.


Priming the fuel system

In the event of running out of fuel:


)
after fi lling (minimum 5 litres),
squeeze the manual priming
pump repeatedly, until some re-
sistance is felt,

)
then operate the starter, gently
pressing the accelerator until the
engine starts.
If the engine fails to start at the
fi rst attempt, wait 15 seconds before
trying again.
If the engine fails to start after a few
attempts, repeat the procedure from
the beginning. When the engine is
idling, accelerate gently to complete
the purge of the circuit.

HDi engines are of a highly
technical nature.
All maintenance and repairs must
be done only by a CITROËN dealer
or a qualifi ed workshop.

X
177
CHECKS
PETROL ENGINES
The covers and caps provide access for checking the levels of the various fl uids and for replacing certain components.


1.
Power steering fl uid reservoir.

2.
Screenwash and headlamp
wash reservoir.

3.
Coolant header tank.
4.
Air fi lter.

5.
Brake fl uid reservoir.

6.
Battery/Fuses.
7.
Fusebox.

8.
Engine oil fi ller cap.

9.
Engine oil dipstick.

X
178
CHECKS

*
According to engine.
DIESEL ENGINES

The covers and caps provide access for checking the levels of the various fl uids, for replacing certain components and
for priming the fuel system.


1.
Power steering fl uid reservoir.

2.
Screenwash and headlamp
wash reservoir.

3.
Coolant header tank

4.
Brake fl uid reservoir.

5.
Battery/Fuses.
6.
Fusebox.

7.
Air fi lter.

8.
Engine oil fi ller cap.

9.
Engine oil dipstick.

10.
Priming pump * .

11 .
Bleed screw * . As the Diesel fuel system
is pressurised, any work on
this system is prohibited.