stop start Citroen C4 PICASSO RHD 2013 1.G User Guide

1
49
Monitoring
Warning / indicator lampStateCauseAction / Observations
Battery charge fixed. The battery charging circuit has a fault (dirty or loose terminals, slack or cut alternator belt, ...). The warnin
g lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a
qualified workshop.
Maximum coolant temperature

fixed red. The temperature of the cooling system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up the level, if necessary.
If the problem persists, contact a CITROËN dealer or qualified workshop.
Directionalheadlamps
flashing. The directional headlamps system has a fault. Have it checked by a CITROËN dealer or a qualified
workshop.
Door(s) open
*
fixed, associated with
a message identifying
the door, if the speed is
below 6 mph (10 km/h).
A door or the boot is still open. Close the door or boot.

fixed, associated with a
message identifying the
door, and accompanied
by an audible signal
if the speed is above
6 mph (10 km/h).
*

Only with the type 1 instrument panel.
Engine oilpressure

fixed. There is a fault with the engine
lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a CITROËN
dealer or a qualified workshop.

50
Monitoring
Under-inflationfixed.The pressure in one or more wheelsis too low. Check the pressure of the tyres as soon as possible.
This check should preferably be carried out when the
tyres are cold.
You must reinitialise the system after the adjustment
of one or more tyre pressures and after changing one or more wheels.

+
flashing then fixed, accompanied by the Service warning lamp.The s
ystem has fault: the tyrepressures are no longer monitored.Check the tyre pressures as soon as possible.
Have the system checked by a CITROËN dealer or a
qualified workshop.
Warning / indicator lampStateCauseAction / Observations
Foot on thebrake pedal*fixed. The brake pedal is not pressed. With an electronic gearbox, press the brake pedal to start the engine (lever in position N ).
If you wish to release the parking brake withoutpressing the brake pedal, this warning lamp will
remain on.
With an automatic gearbox, press the brake pedal to move the gear selector out of position P.P
flashing. With an electronic gearbox, if you hold the vehicle on an incline using
the accelerator for too long, the clutch overheats. Use the brake pedal and/or the parkin
g brake.
Foot on theclutch*fixed. In the STOP mode of Stop & Start,changing to START mode is refused
because the clutch pedal is not fully down.You must declutch full
y to allow the change to engineSTA R T m o d e .
*
Only with the type 1 instrument panel

60
Monitoring
Tr ip computer, a few definitions

Range
(miles or km)
The distance which can still be
travelled with the fuel remainingin the tank (related to the average fuel consumption over the last few miles (kilometres) travelled).


This value may vary following a changein the style of driving or the relief,resulting in a significant change in thecurrent fuel consumption.
When the ran
ge falls below 20 miles (30 km),
dashes are displayed. After filling with at least 5 litres of fuel, the range is recalculated and is
displayed when it exceeds 60 miles (10 0 km).

If dashes are displayed continuously while driving in place of the digits,
contact a CITROËN dealer or a qualified workshop.
This function is only displayed from 20 mph (30 km/h).
Current fuel consumption
(mpg or l/100 km or km/l) Calculated over the last few seconds.
Average fuel consumption
(mpg or l/100 km or km/l) Calculated since the last trip computer reset.
Average speed
(mph or km/h)Calculated since the last trip computer reset.


Distance travelled
(miles or km)
Calculated since the last trip
computer reset.

Stop & Start time counter
(minutes / seconds or hours /
minutes)
If your vehicle is fitted with Stop & Star t, a timecounter calculates the time spent in STOP mode during a journey.
It resets to zero every time the ignition isswitched on with the STA R T/STOP button.

77
2
Access

Motorised opening


Unlocking and opening the tailgate with the electronic key /
remote control

Unlocking and opening the tailgate with the Keyless Entryand Starting system

Openin
g the tailgate
)
Make a long press on this button.
)Press button Aon the tailgate, with theelectronic key in the area of coverage.



When selective locking is activated, the electronic key must be near the rear of the vehicle.


By default, the tailgate openscompletely or alternatively to the
memorised position.

)After complete unlocking of the vehicle, press control Aon the tailgate.
The instruction is confirmed by an audiblesignal.
Motorised closing
There are two possibilities:)
Press and release the exterior
control A.or
- by pressing one of thesetwo buttons,

The motorised tailgate has an anti-pinch system that interrupts closing if it encounters an obstacle.
Operation of the tailgate can be interrupted at any time:

After interruption of an operation,another press on one of the controlsresumes the movement, with the exception of a press on the remote control button, which only allows opening.

or
- by pressing the exterior control A.
Memorising an opening
position

Where height is restricted (garage with a low
ceiling, ...) it is possible to limit and memorise
the opening angle of the tailgate.
Thi
s memorisation is done as follows:


- open the tailgate to the desired position,

- press button
B
or the exterior control A
for more than 3 seconds.
Memorisation of the maximum opening position of the tailgate is confirmed by an audible signal.
To cancel the memorised position:


- stop t
he tailgate in an intermediate position,

- press button B
or the exterior control A
for more than 3 seconds.
)
Press and then release button B.

81
2
Access

Reactivation of the interior volumetric monitoring
)Deactivate the exterior perimeter monitoring by unlocking the vehicle usingthe remote control or the Keyless Entry andStarting system.
The indicator lamp in the button goes off.
)Reactivate the full alarm system by locking
the vehicle using the remote control or the
"Keyless Entry and Star ting" system.
The indicator lamp in the button flashes once
per second again.
Tr iggering of the alarm
This is indicated by sounding of the siren and flashing of the direction indicators for
thirty seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times in
succession.When the vehicle is unlocked using the remotecontrol or the Keyless Entry and Startingsystem, rapid flashing of the indicator lampin the button informs you that the alarm was
triggered during your absence. When the
ignition is switched on, this flashing stops immediately.
Failure of the remote control
To deactivate the monitoring functions:
) Unlock the vehicle using the key (integral
with the remote control) in the driver's door lock. ) Open the door; the alarm is triggered. )
Switch on the ignition; the alarm stops. The
indicator lamp in the button goes off.




Locking the vehicle without
activating the alarm
)
Lock or deadlock the vehicle using the key (integral with the remote control) in thedriver's door lock.




Operating fault


When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault in the system.
Have it checked by a CITROËN dealer or a qualified workshop.



Automatic activation *



2 minutes after the last door or the boot is closed, the system is activated automatically. )
To avoid triggering the alarm on enteringthe vehicle, first press the unlocking button on the remote control or unlock the vehicleusing the Keyless Entry and Starting system.

* Accordin
g to country.

89
3
Comfort
)Press the control to obtain the desired lumbar support.




Electric lumbar adjustment
You can deactivate the massage
function at any time by pressing this
switch, its indicator lamp goes off.



DeactivationActivation
Massage function
This function provides the front occupants
with a lumbar massage. It only operates when
the engine is running or in STOP mode of the Stop & Start system.
)
Press this switch.




Adjustment of intensity
Press this button to select one of
the two levels of massage intensityoffered.

Its indicator lamp comes on and the massagefunction is activated for a period of 1 hour.
During this time, massage is performed in6 cycles of 10 minutes (6 minutes of massage followed by 4 minutes break).
After one hour, the function is deactivated, the
indicator lamp goes off.

135
4
Driving








Starting-switching off the engine with the electronic key
)Place the gear selector lever at Nfor
vehicles with an electronic gearbox, Por Nfor vehicles with an automatic gearbox or neutral with a manual gearbox. )Inser t the electronic key in the reader.)Press the brake pedal for vehicles with an electronic or automatic gearbox, or
fully declutch for vehicles with a manualgearbox.

Starting the engine
For Diesel vehicles, intemperatures below zero theengine will not star t until the preheater warning lamp has gone off.
If this warning lamp comes on after pressing "STA R T/STOP", you should hold the brake or clutch pedal down
until the warning lamp goes off and do not press the START/STOP buttonagain.



If one of the star ting conditions is notmet, a reminder message appears in the instrument panel screen. In somecircumstances, it is necessary to turnthe steering wheel slightly while pressingthe "STA R T/STOP" button to assistunlocking of the steering; a messagewarns you when this is needed.
)
Briefly press the " START/STOP"button.
The steering column unlocks and
the engine star ts more or less
immediatel
y (see the advice for
Diesel versions).

136
Driving
Electronic key left in the reader
If the electronic key is left in the reader,on opening the driver's door a message appears to warn you. In the event o
f an emergency only,
the engine can be switched off
without any conditions. To do this,press the "STA R T/STOP" button for about three seconds.
In this case the steering column locks
as soon as the vehicle stops

Emergency stop
)Immobilise the vehicle. )Place the gear selector lever at Nfor
vehicles with an electronic gearbox, Por Nfor an automatic gearbox, or neutral with amanual gearbox.
Switching off the engine

If the vehicle is not immobilised, the engine will not stop.

)
Briefly press the " START/STOP
"button
The engine stops and the steering column locks.
)Remove the electronic key from the reader.

137
4
Driving








Starting-switching off the engine with the "Keyless Entry and
Starting" system
)Place the gear selector lever at Nfor
vehicles with an electronic gearbox, Por Nwith an automatic gearbox, or neutral witha manual gearbox. )With the electronic key inside the vehicle (it is not necessary to put it in the reader), press the brake pedal for vehicles withan electronic or automatic gearbox, or fully declutch for vehicles with a manual
gearbox.
For Diesel vehicles, intemperatures below zero theengine will not star t until thepreheater warning lamp hasgone off. If this warning lamp comes onafter pressing "STA R T/STOP", you should hold the brake or clutch pedal down until thewarning lamp goes off and donot press the START/STOP button again.

Starting the engine
If one of the star ting conditions is not met, a reminder message appears inthe instrument panel screen. In somecircumstances, it is necessary to turn the steering wheel slightly while pressing the "STA R T/STOP" button to assist unlocking of the steering; a message warns you when this is needed.
)
Briefly press the " START/STOP"button.
The steering column locks and
the engine star ts more or less
instantly (see the advice for
Diesel versions).
The presence in the defined zone of theelectronic key for the "Keyless Entry and Starting" system is essential. For safety reasons, do not leave this zone with the vehicle running.


If the electronic key is not detected in the zone, a message is displayed. Movethe electronic key into the zone so thatthe engine can be started.

138
Driving
Emergency starting

When the electronic key is in the defined zone
and your vehicle does not star t after pressing
the "STA R T/STOP" button: ) Place the gear selector at N
for vehicles
with an electronic gearbox, P or N
for
vehicles with an automatic gearbox or
neutral
for vehicles with a manual gearbox.
) With the electronic key inside
the vehicle, press the " START/
STO
P " button.
The engine stops and the steering column locks.
)Immobilise the vehicle. )Place the gear selector lever at Nfor
vehicles with an electronic gearbox, Por Nwith an automatic gearbox, or neutral with
a manual gearbox.
Switching off the engine

If the vehicle is not immobilised, the engine will not stop.

Do not leave your vehicle with theelectronic key still inside.
)Inser t the electronic key in the reader.)Press the brake pedal on vehicles with anelectronic or automatic gearbox, or fully
declutch with a manual gearbox.)Press the "STA R T/STOP" button.
The engine starts.