run flat Citroen C4 RHD 2013.5 2.G Owner's Manual

11
PRACTICAL INFORMATION
191

Removing the cartridge





Stow the black pipe.


Detach the angled base from the
white pipe.


Support the compressor vertically.


Unscrew the cartridge from the bottom.






Connect the compressor's electri-
cal connector to the vehicle's 12 V
socket.


Start the vehicle and let the engine
run.


Adjust the pressure using the com-
pressor (to infl ate: switch B
in po-
sition "I"
; to defl ate: switch B
in
position "O"
and press button C
),
according to the vehicle's tyre pres-
sure label or the accessory's pres-
sure label.


Remove the kit then stow it.


Beware of discharges of fl uid.
The expiry date of the fl uid is in-
dicated on the cartridge.
The sealant cartridge is designed
for single use; even if only partly
used, it must be replaced.
After use, do not discard the car-
tridge into the environment, take
it to an authorised waste dispos-
al site or a CITROËN dealer.
Do not forget to obtain a new
sealant cartridge, available from
CITROËN dealers or from a
qualifi ed workshop.



Checking tyre pressures /
inflating accessories

You can also use the compressor, with-
out injecting any product, to:


- check or adjust the pressure of your
tyres,

- infl ate other accessories (balls, bi-
cycle tyres...).





Turn the selector A
to the
"Air" position.


Uncoil the black pipe H
fully.


Connect the black pipe to
the valve of the wheel or accessory.
If necessary, fi t one of the adaptors
supplied with the kit fi rst.