dashboard warning lights Citroen C5 2008 (RD/TD) / 2.G Owner's Manual

103
III2
5
1
3
4
6
7
8
9
With the engine off, programmable heating preheats the coolant cir-cuit in order to optimise the engine operating temperature prior to starting.
The programmable heating sys-tem can be started immediately or delayed thanks to its programming function.
Digital programmer
The heating system’s programmer is located on the right-hand side of the dashboard.
1. Time or remaining functioning time.
2. Increase (time).
3. Select programme.
4. Programme number selected.
5. Immediate start-up of heating.
6. Time adjustment and reading warning lamp.
7. Reduce (time).
8. Heating mode warning lamp.
9 Programmable heating system warning lamp.
LED lit : Activated.
LED off : Deactivated.


P R O G R A M M A B L E H E A T I N G
( D E P E N D I N G O N C O U N T R Y )
Immediate start-up
Press button 5.
The screen displays a default duration of 60 minutes, you are advised to adjust this to a duration of 30 minutes maximum (see section “ adjusting the operating duration ”). The warning lamp 8 lights up and remains lit for the whole duration of the system’s operation. The duration of the system’s operation disappears after 10 seconds.
Stopping the heating
Press button 5.
The warning lamp 8 and the screen go out.
With the engine idle or the vehicle stationary, it is nor-mal to hear a high-pitched whistling noise and to notice some smoke / emis-sions.

105
III
34
2
3
8
76
Selection and activation of a programmed time
Press button 3 until the programme number corresponding to the required programmed time is dis-played. The chosen pre-selected time is automatically activated after 10 seconds if no other but-tons have been pressed.
To confi rm that the mode is acti-vated, symbols 4 and 8 fl ash until the heating starts up.
When the heating starts up, the warning lamp 9 lights up on the dashboard and the programmer screen.
P R O G R A M M A B L E H E A T I N G
Adjusting the operating durationPress button 3 and hold it down. Press button 2 or 7 at the same time. Release button 3. The time and symbol 6 are displayed.Press again on button 3 and hold it down. Press button 2 or 7 at the same time. Release button 3. The operating duration and symbol 8 is displayed.Adjust the operating duration with button 2 or 7.
Note : The operating duration is memorised when the time indicated disappears or by pressing button 3.
Adjusting the remaining operating duration
When heating mode is activated, the remaining operating time can be modifi ed within the range of 10 to 60 minutes using buttons 2 or 7.
Note :The pre-selected start-up time can be modifi ed or cancelled by following the instructions previ-ously given above.
In the event of a battery discon-nection, the programmer must be re-set (hours, minutes etc.)


Always switch off the additional heating when filling up with fuel, to prevent any risk of fi re or explosion.
To avoid any risk of intoxica-tion or asphyxiation, the addi-tional heating must not be used, even for short periods, in an enclosed area such as a garage or workshop not equipped with a system for the extraction of exhaust gases.
Do not park the vehicle over infl ammable materials (e.g. dry grass, dead leaves or paper) as this could present a fi re risk.
The programmable heating sys-tem is supplied by the vehicle’s fuel tank. Before use, ensure that the remaining fuel level is suffi cient. If you are using the reserve fuel tank, we strongly advise you not to use the pro-grammable heating system.