service Citroen C5 2008 (RD/TD) / 2.G Owner's Manual

41
II
A
2121
I N S T R U M E N T P A N E L
Engine oil temperature gauge
Under normal operating condi-tions, the bars should be within section 1.
In severe operating conditions, the bars may extend into section 2.
In this event, slow down, and if nec-essary, stop the engine and check the levels (see chapter - Mainte-nance - “Levels”).
Fuel gauge
On horizontal ground, the lighting of the fuel low warning lamp warns you that you are using the reserve tank.
A message alert is displayed on the instrument panel.
Coolant temperature indicator
Under normal operating condi-tions, the bars should be within section 1.
In severe operating conditions, the bars may extend into section 2, the engine coolant temperature warn-ing lamp A and the STOP warning lamp will light up, stop immedi-ately.Switch off the ignition. The cooling fan may continue to operate for a certain time. Allow the engine to cool down while tak-ing the precautions indicated in chapter - Maintenace - “Levels”.
Contact a CITROËN dealer.
If the SERVICE warning lamp lights up, check the levels (see chapter - Maintenance - “Levels”).

31
II
STOP warning lamp
When the warning lamp comes on, you must stop the vehicle and switch off the engine. Contact a CITROËN dealer.switch off the engineswitch off
Parking brake
The permanent lighting of this warning lamp confi rms that the parking brake is applied.
If this warning lamp fl ashes, it indi-cates a fault with its application or release. Consult a CITROËN cates a fault with its application cates a fault with its application
dealer as soon as possible.
See “Brakes”.
With the engine running, and when displayed at the same time as the STOP warning lamp, it indi-cates that the brake fl uid level is too low.
If this warning lamp comes on, stop immediately and contact a CITROËN dealer.stop immediately and contact stop immediately and contact
See “Brakes”.
Battery charge
This warning lamp comes on temporarily when the engine is switched on. If it remains on permanently, contact a CITROËN dealer.remains on permanently, remains on permanently,
In the event of a battery failure, the application of the electronic parking brake when the engine is switched off is not guaranteed. You must therefore apply the parking brake before switching off the engine.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
SERVICE
This warning lamp remains on perma-nently, as long as the fault displayed on the instru-ment panel screen is present (for serious faults).
Consult a CITROËN dealer as soon as possible.
This warning lamp remains on only for a short time for faults that are minor.
Contact a CITROËN dealer.
ESP/ASR
Operating
If either of the ESP or ASR systems is active, the warning lamp fl ashes.
For a malfunction
With the engine running, the light-ing of this warning lamp along with a message on the instrument panel screen, the lighting of the SERVICE warning lamp and a sound signal, indicates a system fault.
Contact a CITROËN dealer.
Deactivation
The lighting of this warning lamp and the light on the ESP deactiva-tion button confi rms that the sys-tem is deactivated.
See “Dynamic stability control” (ESP).
Coolant temperature
It comes on for a few sec-onds each time you switch on the ignition.
If this warning lamp comes on, engine running, it tells you that the coolant temperature is rising abnormally.
This warning lamp is linked with the STOP warning lamp.
It is essential to stop the vehi-cle.
Check the coolant level.
If the level is too low, contact a CITROËN dealer.If the level is too low, contact If the level is too low, contact

33
II
The simultaneous lighting of the SERVICE warning lamp and the display of the message “Particle fi lter (FAP) additive level too low” on the instrument panel screen indicates that the additive needs to be topped up.
Contact a CITROËN dealer as soon as possible.
I N S T R U M E N T P A N E L
P A R T I C L E F I L T E R
In addition to the catalytic converter, this fi lter contributes actively to the preserving of air quality, by collecting the polluting particles that have not been burnt off. Black exhaust fumes are thus eliminated.
Clogging of the particle fi lter
Clogging is caused by the particle fi lter starting to be saturated (owing to exceptionally long periods spent driving in urban conditions : low speeds, traffi c jams, etc.).
In order to regenerate the fi lter you are advised to drive as soon as pos-sible, when traffi c conditions allow, at a speed of 60 km/h (approx. 37 mph) or more for at least 5 min-utes. If the problem persists, con-tact a CITROËN dealer.utes. If the problem persists, con-utes. If the problem persists, con-
Note: If the vehicle has been run-ning for long periods at very low speeds or at idle, vapour emis-sions may be seen coming from the exhaust under acceleration. These have no consequences for the running of the vehicle or for the environment.
DIESEL additive level
The simultaneous lighting of the SERVICE warning lamp and the display of the message “Risk of saturation of particle fi lter (FAP)” on the instrument panel screen indicates an increased risk of satu-ration.
Contact a CITROËN dealer as soon as possible.

37
II
Maintenance indicator
It informs you when the next routine service is due in accordance with the vehicle servicing schedule in the Main-tenance Guide. This information is dependent on two parameters: the mileage covered, and the time elapsed since the last visit
Functioning if the distance to the next service is less than 3000 km (approx. 1900 miles)
When switching on the ignition, a message is displayed on the instrument panel screen for a few seconds. It indicates to you the remaining distance before the next service.
Example: there remain up to the next service: 1900 miles.
A few seconds after the ignition is switched on, the message disap-pears.
Functioning if the distance to the next service is less than 1000 km (approx. 600 miles)
When switching on the ignition, a message is displayed on the instrument panel screen for a few seconds. It indicates to you the remaining distance before the next service.
Example: there remain up to the next service: 500 miles.
A few seconds after the ignition is switched on, the message disap-pears, then the maintenance sym-bol (spanner) remains lit.
Operation if the service interval has been passed
When switching on the ignition, a message is displayed on the instrument panel screen for a few seconds. It indicates to you that the service interval has been exceeded.
The routine service on your vehicle needs to be carried out as soon as possible.
A few seconds after the ignition is switched on, the message disap-pears, then the maintenance sym-bol (spanner) remains lit.
I N S T R U M E N T P A N E L
M A I N T E N A N C E I N D I C A T O R

61
II
BDC
A
BC
A
E
1234
M U L T I F U N C T I O N D I S P L A Y
T E L E M A T I C S
Controls
A. Access to the telematics multi-function display menu.
B. Cancellation of the operation or return to the previous display.
C. Scrolling through the menus of the telematics multifunction dis-play. Validation using steering wheel controls.
D. Validation using radio panel.
E. Selection of the type of informa-tion presented on the telemat-ics multifunction display (date, radio/CD/CD MP3/CD changer/jukebox, navigation information, telephone).
Traffi c information
See NaviDrive instructions.
Navigation/guidance
See NaviDrive instructions.
Audio
See NaviDrive instructions.
Main Menu
Press on button A to display the telematics multifunction display “Main Menu”. This menu gives you access to the following functions:
Telephone and telematic services
See NaviDrive instructions.
Map
See NaviDrive instructions.
1 Outside temperature.
2 Date.
3 Telephone.
4 Time.
When the outside temperature is between +3 °C and –3 °C, the temperature display fl ashes (risk of ice).
Note: The outside temperature displayed may be higher than the actual temperature if the vehicle is stationary in bright sunlight.
The driver is advised not to use the controls described opposite whilst driving.
Confi guration,
allows you to adjust various settings (date, time...).
Video Menu,
allows you to adjust vari-ous video settings.

69
II
3
5
4
2
1
C R U I S E C O N T R O L
To cancel the functionPress on button 5.
Select the cruise control func-tion.
Or stop the engine.
The speed that was chosen is no longer memorised.
If there is a malfunction, a mes-sage is displayed accompanied by a sound signal and lighting of the SERVICE warning lamp.
Contact a CITROËN dealer.

71
II
3
5
4
2
1
A
S P E E D L I M I T E R
Suspension or resumption of maximum speed
Press on button 3.
Temporary override of the maximum speed
The accelerator pedal has an end-of-travel switch. In order to exceed the memorised maximum speed at any time, you can press the pedal all the way down. While the speed is being exceeded, the speed dis-played in zone A will fl ash. You have only to release the accelera-tor pedal to return below the maxi-mum speed, to restore the func-tion.
Remark: the speed will also fl ash if the speed limiter is not able to prevent the vehicle from exceeding the programmed speed (e.g. on a steep descent or under excessive acceleration).
To reactivate the speed limiter, release the accelerator to slow to a speed lower than the programmed speed.
To cancel the functionPress on button 5.Select the speed limiter func-tion.
Or stop the engine.
The speed that was chosen is no longer memorised.
If there is a malfunction, a mes-sage is displayed accompanied by a sound signal and lighting of the SERVICE warning lamp.
Contact a CITROËN dealer.

72
II
A
Defl ation detection
This function warns you of tyres that are defl ated or punctured.
Automatic detection
Sensors monitor the tyre pres-sures while driving. In the event of an anomaly, a message will appear on the instrument panel screen.
Driver request detection
You can check the tyre pressures at any given moment. To do so, press on button A (CHECK) ; the information will be displayed on the instrument panel screen.
Display of tyres in good condition
Automatic detection:
A message indicates to you which tyre is defl ated.
Driver request detection:
The vehicle outline indicates the defl ated tyre(s).
The message is accompanied by the SERVICE warning lamp light-ing up and a beep.
Check the tyre pressures as soon as possible.
T Y R E D E F L A T I O N D E T E C T I O N
Tyre defl ation alert
The system indicates to you that the tyres are correctly infl ated.
This information is only available on the request of the driver.
Press on Check
Press on Check
Automatic detection

73
II
T Y R E D E F L A T I O N D E T E C T I O N
Wheel not detected
The defl ation detection system is a driving aid, but which does not absolve the driver from the need to be vigilant and responsible.
This system does not dispense with the requirement to check the tyres on a regular basis (see “Vehicle identifi cation”), to make sure that the vehicle is behaving correctly and to avoid premature tyre wear arising from driving too fast etc.
Do not forget to check the pres-sure in the spare wheel.
Any repair or replacement of a tyre on a wheel that is equipped with a sensor must be carried out by a CITROËN dealer.Any repair or replacement of a tyre on a wheel that is equippel tha
The system may suffer from temporary interference caused by radio transmissions on neighbouring frequencies.
Automatic detection:
A message indicates to you which tyre is punctured.
Driver request detection:
The vehicle outline indicates the punctured tyre(s).
The message is accompanied by the STOP warning lamp lighting up and a beep.
Puncture
Automatic detection:
A message indicates to you which wheel is not detected.
Driver request detection:
The vehicle outline indicates the wheel(s) which is/are not detected.
Press on Check
Automatic detection
Press on Check
Automatic detection
Note:If you have fi tted a wheel/wheels not equipped with tyre defl a-tion detection (e.g. snow tyres), contact a CITROËN dealertion detection (e.g. snow tyres), (e.g. snow .
The message is accompanied by the SERVICE warning lamp lighting up and a beep.Contact a CITROËN dealer to have the faulty sensor(s) replaced.

92
III
A
Locking/unlocking from the inside
With the doors and the boot closed, pressing button A allows you to control the electric central locking and unlocking.
It is still possible to open the doors from the inside.
If one of the doors is open or not properly closed, central locking will not work.
A C C E S S
Anti-theft protection
On starting the vehicle, the system automatically locks the doors as soon as you reach approximately 10 km/h.
Note: If a door is opened, this will automatically lock itself again when the vehicle reaches approximately 10 km/h (6 mph).
Activation/Deactivation of the anti-intrusion protection
After switching on the ignition, make a long press on the central unlocking control until a message is displayed and a beep is heard.
Selection of doors / boot
After having selected “Plip action / Driver” in the “Vehicle parameters / Comfort” menu of the instrument panel screen.
Pressing the remote control unlocks the passenger door.
A 2nd successive press unlocks all of the doors and the boot.
If you decide to drive with the doors locked, remember that in the event of an accident this renders access more diffi -cult for the emergency services.
The warning lamp associated with the control A signals 3 statuses:lt fl ashes when the ignition key is in the stop position or when the key is not detected and the doors are locked.
It lights up when the vehi-cle is locked with the ignition switched on.It goes out when the doors are not locked.
Note: Control A is inactive if the vehicle has been locked using the remote control or the key.