buttons Citroen C5 2012 (RD/TD) / 2.G Owner's Manual

CONTENTS
Monochrome screen C 43
Colour screen (eMyWay) 45
II - MULTIFUNCTION SCREENS 43 Î 46
Ventilation 47
Mono-zone digital
air conditioning 49
Dual-zone digital
air conditioning 52
Programmable heating 56
Front seats 60
Rear seats 64
Mirrors 65
Steering wheel adjustment 66
47Î 66
Remote control key 67
Alarm 73
Electric windows 75
Doors 77
Boot 79
Sunroof (Saloon) 82
Panoramic sunroof (Tourer) 83
Fuel tank 84
Misfuel prevention (Diesel) 85
67 Î 85
Lighting controls 86
Automatic illumination
of headlamps 88
Headlamp adjustment 89
Directional lighting 90
Wiper controls 92
Automatic rain sensitive
windscreen wipers 93
Courtesy lamps 94
Interior mood lighting 96
86 Î97
Interior fi ttings 98
Mats 99
Front armrest 99
Boot fi ttings 101
VI -FITTINGS 98Î104
Instrument panels 26
Trip computer 29
Warning and indicator lamps 32
Adjustment buttons 42
FAMILIARISATION 4 Î 23
I - MONITORING 26 Î42
Child seats 105
ISOFIX child seats 109
Child lock 113
VII - CHILD SAFETY 105Î113
ECO-DRIVING 24 Î 25

10
FAMILIARISATION
INSTRUMENTS AND CONTROLS

Audio. Instrument panel menu. Multifunction screen menu.
Telephone. Cruise control and speed
limiter.

The " SET +, PAUSE, VOL+,
and MUTE
"
buttons have touch identifi cation to make
them easier to use. Activation of voice
recognition or reminder of
navigation guidance. MODE: selection of the type
of information displayed in
the multifunction screen.



148-149

I
42
MONITORING












Total distance recorder

System which measures the total
distance travelled by the vehicle
during its life.
The total and trip distances are dis-
played for thirty seconds when the
ignition is switched off, when the
driver's door is opened and when
the vehicle is locked or unlocked.

To conform to legislation in the
country you are crossing, change
the units of distance (miles or km)
via the confi guration menu.











Lighting dimmer

System for manual adjustment of
the brightness of the instruments
and controls in relation to the exte-
rior brightness.

Operation


)
Press button A
to decrease the
brightness of the instruments
and controls.

)
Press button B
to increase the
brightness of the instruments
and controls.

Deactivation
When the lighting is off, or in day
mode on vehicles fi tted with daytime
running lamps, pressing the buttons
does not have any effect.



Trip distance recorder

System which measures a distance
travelled during a day or other pe-
riod since it was reset to zero by the
driver.


)
With the ignition on, press the
button until zeros appear.

III
56
COMFORT
PROGRAMMABLE HEATING

The programmable heating operates
independently of the engine.
When the engine is off, it pre-heats
the coolant circuit in order to benefi t
from an optimum engine operating
temperature from the time the en-
gine is switched on.
The programmable heating system
is switched on using the long range
remote control. Activation can be im-
mediate or deferred by means of a
programming function.

Programming remote control

The heating system programming
remote control consists of the fol-
lowing buttons and displays:


1.
Scrolling functions menu but-
tons.

2.
Function indicators: clock, tem-
perature, operating time, pro-
grammed time, heater operation,
heating management symbols.

3.
Digital displays: time, tempera-
ture, duration of operation, pro-
grammed time or level of heating.

4.
Off button.

5.
On button.



Displays on the remote
control screen

Press the buttons 1
in succession to
display the functions.
The fi rst press of the left-hand or
right-hand button displays the time.
Next, the left-hand button permits
access to the programming time then
to the level of heating (C1 to C5).
The right-hand button permits ac-
cess to the passenger compartment
temperature then to the duration of
operation of the heater if it is to be
switched on immediately.

If a malfunction of the program-
mable heating system occurs,
contact a CITROËN dealer
or a

qualifi ed workshop

.




Displaying the functions


The passenger compartment tem-
perature information is only avail-
able when the engine is off.

III
57
COMFORT

Setting the time

Once the time has been displayed,
by means of the buttons 1
, press
buttons 4
and 5
simultaneously with-
in 10 seconds.

Immediate activation

Press button 5
(ON) until the mes-
sage "OK"
appears.
When the signal has been received,
the message "OK"
is displayed
along with the duration of operation. Press the buttons 1
to display the
duration of operation.
This symbol fl ashes.
Set the time using the buttons 1
.
Press buttons 4
and 5
simultane-
ously to save it.
This symbol is displayed (fi xed).

The heater starts and this
symbol is displayed.
To deactivate the function, press
button 4
(OFF) until the message
"OK"
appears.
This symbol is switched off.

When carrying out these opera-
tions, if the message "FAIL"
ap-
pears, the signal has not been
received. Repeat the procedure
after changing your location.



Setting the duration of
operation
This symbol is displayed.
Once the duration of operation has
been displayed, press buttons 4
and 5

simultaneously within 10 seconds.
This symbol fl ashes.
Set the duration by pressing the
buttons 1
(adjustment in steps of
10 mins and max value 30 mins).
Press buttons 4
and 5
simultaneous-
ly to save the duration of operation.
This symbol is displayed (fi xed).


The factory setting value is 30 minutes.

III
58
COMFORT

Programming the heating

You must programme your depar-
ture time in order for the system to
calculate the optimum heater start
time automatically.

Programming the departure time
Press the buttons 1
to display the
programming time.
Activation - deactivation
Once the programming time has
been displayed by means of the but-
tons 1
, press button 5
(ON) until the
message "OK"
appears.
This symbol is displayed.
Once the programming time has been
displayed, press buttons 4
and 5
si-
multaneously within 10 seconds.
This symbol fl ashes.
Set the time by pressing the buttons 1

and press buttons 4
and 5
simultane-
ously to save it.
This symbol is displayed (fi xed).

This symbol is displayed
when the heater starts.

HTM: Heat Thermo Management.

When the signal has been received,
the message "OK"
is displayed
along with the symbol "HTM"
.

To deactivate the programming,
press button 4
(OFF) until the mes-
sage "OK"
appears.

The symbol "HTM"
is switched
off.


When carrying out these opera-
tions, if the message "FAIL"
ap-
pears, the signal has not been
received. Repeat the procedure
after changing your location.
Switching off the heating
Press button 5
(ON).
The symbol "HTM"
remains
on.

Changing the level of heating
The system offers 5 levels
of heat-
ing (from the lowest level C1
to the
highest level C5
).
Once the level of heating has been
displayed by means of the buttons 1
,
press buttons 4
and 5
simultane-
ously.
The letter "C"
fl ashes.
Set the level of heating by pressing
the buttons 1
.
Press buttons 4
and 5
simultane-
ously to save the level selected. The
letter "C"
is displayed (fi xed).

The factory pre-sets are replaced
by the new settings entered. The
programmed times are stored until
the next time they are changed.
When the departure time is acti-
vated, the level of heating cannot
be changed. The departure time
must be deactivated fi rst.

III
63
COMFORT












Storing driving positions

System which stores the settings of
the driver's seat. Up to two positions
can be stored using the buttons on
the side of the driver's seat.
When storing a driving position, the
air conditioning settings are also
memorised.
Storing a position

Using buttons M / 1 / 2


)
Switch on the ignition.

)
Adjust your seat.

)
Press button M
, then press but-
ton 1
or 2
within four seconds.
An audible signal confi rms that
the settings have been stored.
Storing a new position cancels the
previous position.

Recalling a stored position

Ignition on or engine running


)
Briefl y press button 1
or 2
to re-
call the corresponding position.
An audible signal indicates the end
of the adjustment.
When the ignition is on, after a few
consecutive position recalls, the
function will be deactivated until the
engine is started, to prevent dis-
charging of the battery.
For your safety, avoid storing a
driving position while driving.
REAR HEAD RESTRAINTS

The rear head restraints can be re-
moved and have two positions:


- high, position for use,

- low, storage position.
To raise a head restraint, pull it up-
wards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high
position, push the lug and pull it up-
wards.
To r efi t it, engage the head restraint
rods in the holes taking care to re-
main in line with the seat back.
Never drive with the head restraints
removed, they must be in place
and correctly adjusted. To adjust the air conditioning, refer
to the "Air conditioning" section.

IV
72
ACCESS














Lost keys

Visit a CITROËN dealer with the ve-
hicle's registration document, your
personal identifi cation documents
and if possible the key code label.
The CITROËN dealer will be able to
look up the key code and the tran-
sponder code required to order a
new key.


Remote control

The high frequency remote control
is a sensitive system; do not operate
it while it is in your pocket as there
is a possibility that it may unlock the
vehicle, without you being aware
of it.
Do not repeatedly press the buttons
of your remote control out of range
and out of sight of your vehicle. You
run the risk of stopping it from work-
ing and the remote control would
have to be reinitialised.
The remote control does not operate
when the key is in the ignition switch,
even when the ignition is switched
off, except for reinitialisation.


Locking the vehicle

Driving with the doors locked may
make access to the passenger com-
partment by the emergency services
more diffi cult in an emergency.
However, the vehicle unlocks auto-
matically in the event of a serious
impact causing airbag deployment.
As a safety precaution (with children
on board), remove the key from the
ignition switch when you leave the
vehicle, even for a short time.


Anti-theft protection

Do not make any modifi cations to
the electronic engine immobiliser
system; this could cause malfunc-
tions.


When purchasing a second-
hand vehicle
Have the pairing of all of the keys
in your possession checked by a
CITROËN dealer, to ensure that
only your keys can be used to open
and start the vehicle.







Do not throw the remote con-
trol batteries away, they contain
metals which are harmful to the
environment.
Take them to an approved collection
point.

V
96
VISIBILITY
INTERIOR MOOD LIGHTING
Your vehicle is equipped with interior
mood lighting for the centre console
and the door handles.

Central console

The lamps are located on the roof
console, near the front interior lamp.
They illuminate the central console.

Lighting for door opening
controls

Operation
These lamps are activated with the
automatic illumination of headlamps,
when the ambient light is poor. They
are deactivated when the instrument
panel is off.
The intensity of the lighting varies
along with that of the instrument
panel.


)
Press buttons A
to increase or
reduce the intensity of the lighting.

This is located on the front and rear
interior door opening controls.

The rear door opening controls lighting
is deactivated if the child lock is on.

258
07RADIO
By alphabetical list
Pr
ess RADIOor LIST , select the station
of your choice and confi rm.
B
y automatic frequency search
Press or for the automatic searchfor a lower or higher radio frequency.
Or turn the thumb wheel at the steeringmounted controls.
B
y manual frequency search
Pr
ess or to adjust the radiofrequency step by step.Press the button on the numerical ke
ypad to recall a
preset station.
Or press then turn the thumb wheel at the steering
mounted controls.
SELECTING A STATION


The external environment (hill, building, tunnel, underground car park...) may interfere with the reception, including in RDS station tracking mode.
This phenomenon is a normal result of the way in which radio waves are transmitted and does not in any way indicate a fault with the audio system.

PRESETTING A STATION

After selecting a station, press one of the buttons
on the numerical keypad for 2 seconds to preset the current station.
An audible signal confi rms that the station has been preset.
The quality of reception is represented by the number of active waves in this symbol.