wiring Citroen C5 2017 (RD/TD) / 2.G Owner's Manual

49
C5_en_Chap02_ouverture_ed01-2016
Alarm*
- exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet...
- interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compartment or
moves inside the vehicle.
- tilt
The system checks for any change in the
attitude of the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or knocked.
Locking the vehicle with full
alarm system
Activation
* Depending on the country of sale.
Self-protection function
The system checks for the putting out of
service of its components.
The alarm is triggered if the battery, the
central control or the siren wiring are
put out of service or damaged.
For all work on the alarm system,
contact a CITROËN dealer or a
qualified workshop.
System which protects and provides a deterrent
against theft and break-ins. It provides the
following types of monitoring:
F

Switch off the ignition and get out of the
vehicle.
F Press the locking button on the remote control.
The monitoring system is active: the indicator lamp
in the button flashes once per second.
After the locking button on the remote control
is pressed, the exterior perimeter monitoring is
activated after a delay of 5 seconds and the interior
volumetric and anti-tilt monitoring after a delay of
45 seconds.
If an opening (door, boot...) is not closed fully, the
vehicle is not locked but the exterior perimeter
monitoring will be activated after a delay of
45
seconds at the same time as the interior
volumetric and anti-tilt monitoring.
2
Access

221
C5_en_Chap08_en-cas-de-panne_ed01-2016
Side repeaters
The side repeater is sealed.
If the bulb is faulty, replace the side repeater.
Contact a CITROËN dealer or a qualified
workshop.
Front foglamps
F Disconnect the connector D.
F R emove the bulb by per forming a quarter
of a turn.
F

R
eplace the bulb.
F

R
efit the connector D .
F

R
efit the headlamp unit in the bumper.
F

R
efit the lamp screws.
F

P
osition the cover using its guides and refit
the screws. When refitting, take care not to trap
the electrical
wiring.
Bulbs:
H8
F
R
emove the fixing screw of cover A using a
torx tool, tip the cover over and remove.
F

R

emove the fixing screw of lamp B using a
torx tool, then pull on the lamp to remove it
from the bumper.
8
In the event of a breakdown