instrument panel Citroen C5 DAG 2007.5 (DC/DE) / 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2007.5, Model line: C5 DAG, Model: Citroen C5 DAG 2007.5 (DC/DE) / 1.GPages: 231, PDF Size: 8.02 MB
Page 5 of 231
I
8
9
10
1718
11
1
2
1213
14
153
5
8
6
4
7
16
19
20
21
IN BRIEF
1 Electric windows / Rear view mirrors / Child
safety controls
2 Memorisation of driver's seat and exterior rear
view mirror adjustments
3 Bonnet release
4 Controls at the steering wheel:
Speed limiter
Cruise control
5 Horn
6 Audio/telematic controls under steering wheel
7 Driver's airbag
8 Navigation controls
9 Driver's air vent
10 Instrument panel
11 Driver's air vent
12 Lighting control
13 Windscreen wiper / Screen wash controls
14 Ignition switch
15 ESP / Parking assistance controls
16 Steering column adjustment
17 Knees airbag
18 - Oddments tray
- F u s e b o x a c c e s s fl a p
19 Checks / Anti-intrusion alarm / Parking space
sensor controls
20 Lighting / Direction indicators / Foglamp / Voice
recognition controls
21 Manual headlamp height adjustment
-
-
D A S H B O A R D
Page 7 of 231
I
10
IN BRIEF
D A S H B O A R D
Audio
Instrument panel menuMultifunction display menu
Telephone
Cruise control and Speed limiter
44
The “SET +, PAUSE, VOL+, MUTEThe “The “” buttons are located so that you can use them without needing to take your eyes off the road.
Page 12 of 231
II
1515
2
3
4
1
5
2
3
4
1
5
IN BRIEF
D R I V I N G
This system allows you to main-tain a constant vehicle speed pro-grammed by the driver.1. Selection of “CRUISE”: Activa-tion of cruise control.2/3.“SET”: Memorisation of the speed.2. “SET +”: Increase of the memorised speed.3. “SET -”: Reduction of the memorised speed.4. Suspension or resumption of mode.5. Deactivation.
Cruise controlSpeed limiter
This system allows you to choose a maximum speed that you do not wish to exceed.1. Selection of “LIMIT”: Activation of speed limiter mode.2. “SET +”: Increase of the maxi-mum speed.3. “SET -”: Reduction of the maxi-mum speed.4. Suspension or resumption of mode.5. Deactivation.
The chosen speed is memorised.
6567
Note: The chosen speed must be higher than 30 km/h (20 mph).
Cruise control is active on the higher gears of the gearbox. The chosen speed must be higher than 40 km/h (20 mph).
Instrument panel display
The speed limiter or cruise control mode is displayed on the instru-ment panel when selected.
Cruise control
Speed limiter
Page 15 of 231
I
18
E
D
FAJ
CI
B
H
G
IN BRIEF
Instrument panel
The hazard lamps can also be used with the ignition switched off.
M O N I T O R I N G
A. Fuel gauge and low fuel warning lamp.B. Cruise control/speed limiter information.C. Coolant temperature.D. Speed indicator.E. Instrument panel.F. Mileage recorder.
G. Trip mileage recorder reset button.H. Rev counter. I. Engine oil temperature.J. Display of automatic gearbox information.
Note:When the ignition is switched on, the orange and red warning lamps light up.
When the engine is running, these warning lamps should go out.
If any warning lamps remain lit, refer to the relevant page.
Page 16 of 231
II
1919
A
IN BRIEF
M O N I T O R I N G
T y r e d e fl a t i o n d e t e c t i o n
This function allows you to display the log of alerts.
Press on button A. The following messages appear consecutively on the instrument panel screen:Tyre pressure check.
Maintenance indicator reminder.
Display of message alerts.Oil level check.
Page 28 of 231
43
II
A
2121
I N S T R U M E N T P A N E L
Engine oil temperature gauge
Under normal operating condi-tions, the bars should be within section 1.
In severe operating conditions, the bars may extend into section 2.
In this event, slow down, and if nec-essary, stop the engine and check the levels (see chapter - Mainte-nance - “Levels”).
Fuel gauge
On horizontal ground, the lighting of the fuel low warning lamp warns you that you are using the reserve tank.
A message alert is displayed on the instrument panel.
Coolant temperature indica-tor
Under normal operating condi-tions, the bars should be within section 1.
In severe operating conditions, the bars may extend into section 2, the engine coolant temperature warn-ing lamp A and the STOP warning lamp will light up, stop immedi-ately.Switch off the ignition. The cooling fan may continue to operate for a certain time. Allow the engine to cool down while tak-ing the precautions indicated in chapter - Maintenace - “Levels”.
Contact a CITROËN dealer.
If the SERVICE warning lamp lights up, check the levels (see chapter - Maintenance - “Levels”).
Page 30 of 231
32
II
STOP warning lamp
When the warn-ing lamp comes on, you must stop the vehicle and switch off the engine. Contact a CITROËN dealer.switch off the engineswitch off
Parking brake
The permanent lighting of t h i s w a r n i n g l a m p c o n fi r m s that the parking brake is applied.
I f t h i s w a r n i n g l a m p fl a s h e s , i t i n d i -cates a fault with its application or release. Consult a CITROËN cates a fault with its application application
dealer as soon as possible.
See “Brakes”.
With the engine running, and when displayed at the same time as the STOP warning lamp, it indi- c a t e s t h a t t h e b r a k e fl u i d l e v e l i s too low.
If this warning lamp comes on, stop immediately and contact a CITROËN dealer.stop immediately and immediately
See “Brakes”.
Battery charge
This warning lamp comes on temporarily when the engine is switched on. If it remains on permanently, contact a CITROËN dealer.remains on permanens on
In the event of a battery failure, the application of the electronic parking brake when the engine is switched off is not guaranteed. You must therefore apply the parking brake before switching off the engine.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
SERVICE
This warning lamp remains on perma-nently, as long as the fault displayed on the instru-ment panel screen is present (for serious faults).
Consult a CITROËN dealer as soon as possible.
This warning lamp remains on only for a short time for faults that are minor.
Contact a CITROËN dealer.
ESP/ASR
Operating
If either of the ESP or ASR systems is active, the warning l a m p fl a s h e s .
For a malfunction
With the engine running, the light-ing of this warning lamp along with a message on the instrument panel screen, the lighting of the SERV-ICE warning lamp and a sound signal, indicates a system fault.
Contact a CITROËN dealer.
Deactivation
The lighting of this warning lamp and the light on the ESP deactiva- t i o n b u t t o n c o n fi r m s t h a t t h e s y s -tem is deactivated.
See “Dynamic stability control” (ESP).
Coolant temperature
It comes on for a few sec-onds each time you switch on the ignition.
If this warning lamp comes on, engine running, it tells you that the coolant temperature is rising abnormally.
This warning lamp is linked with the STOP warning lamp.
It is essential to stop the vehi-cle.
Check the coolant level.
If the level is too low, contact a CITROËN dealer.If the level is too
Page 32 of 231
34
II
The simultaneous lighting of the SERVICE warning lamp and the display of the message “ P a r t i c l e fi l t e r ( F A P ) a d d i -tive level too low” on the instrument panel screen indicates that the additive needs to be topped up.
Contact a CITROËN dealer as soon as possible.
I N S T R U M E N T P A N E L
P A R T I C L E F I L T E R
I n a d d i t i o n t o t h e c a t a l y t i c c o n v e r t e r , t h i s fi l t e r c o n t r i b u t e s a c t i v e l y t o t h e p r e s e r v i n g o f a i r q u a l i t y , b y c o l l e c t i n g t h e polluting particles that have not been burnt off. Black exhaust fumes are thus eliminated.
C l o g g i n g o f t h e p a r t i c l e fi l t e r
C l o g g i n g i s c a u s e d b y t h e p a r t i c l e fi l t e r s t a r t i n g t o b e s a t u r a t e d ( o w i n g t o e x c e p t i o n a l l y l o n g p e r i o d s s p e n t d r i v i n g i n u r b a n c o n d i t i o n s : l o w s p e e d s , t r a f fi c j a m s , e t c . ) .
I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d of 60 km/h or more for at least 5 minutes. If the problem persists, contact a CITROËN dealer. I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d
Note: If the vehicle has been running for long periods at very low speeds or at idle, vapour emissions may be seen coming from the exhaust under acceleration. These have no consequ ences for the running of the vehicle or for the environment.
The simultaneous lighting of the SERVICE warning lamp and the display of the message “Risk of saturation of par- t i c l e fi l t e r ( F A P ) ” on the instrument panel screen indicates an increased risk of saturation.
Contact a CITROËN dealer as soon as possible.
DIESEL additive level
Page 33 of 231
35
II
B
C
A
Range
This is the distance that can still be travelled on the amount of fuel remain-ing in the tank.
When the range is lower than 30 km (19 miles), only four dashes are dis-played.
Instantaneous consumption
This is the result from the consumption recorded within the last 2 seconds. This function is only available when travelling at over 30 km/h.
Instantaneous information
OPERATION
The trip computer is displayed on the instrument panel screen. I t gives you access to:2 types of instantaneous information:
Range.Instantaneous consumption.This information can be displayed in zone B of the instrument panel screen when you switch the ignition on, immediately after the display of oil level and/or maintenance information.The different information to be displayed is selected by rotating the con-trol knob A.
3 types of information for two journeys 1 and 2:
Average speed.Average consumption.The distance travelled.This information is displayed in zone C of the instrument panel by rotat-ing the control knob A.
Page 34 of 231
36
II
I N S T R U M E N T P A N E L
T R I P C O M P U T E R
Distance travelled
This is the distance that has been travelled since the last reset to zero of the Journey selected.
Journeys
Journeys 1 and 2 are independent of each other but identical in use. They allow you, for example, to assign journey 1for daily calculations and journey 2 for monthly calculations.
Reset a journey to zero
When the required journey is displayed, make a long press on th e left-hand control knob A on the steering wheel.
Return to the main instrument panel screen display
Successive rotations of the control knob A on the steering wheel allow you to return you to the main instrument panel screen display (vehicle speed), via the navigation information scree n, then the screen displaying only the total mile-age and the trip mileage (bottom of screen).
A second rotation of control knob A allows you to display the information for journey A2.
Average speed
This is calculated (since the last reset to zero of the trip computer) by dividing the dis-tance travelled by the time taken (with the engine running).
Average consumption
This is the relationship between the fuel consumed and the distance travelled since the last reset to zero of the selected journey.
Information for two journeys 1 and 2
A fi r s t r o t a t i o n o f c o n t r o l k n o b A on the steering wheel allows you to display the information for journey 1.