steering wheel Citroen C6 DAG 2007 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2007, Model line: C6 DAG, Model: Citroen C6 DAG 2007 1.GPages: 216, PDF Size: 7.61 MB
Page 6 of 216
II
99
1
12
6
8
14
13
2
3
5
7910
15
16
1718
4
11
IN BRIEF
1. Controls - Windows / Rear view mirrors / Child
safety
2. Driver's seat adjustment controls and memories
3. Controls - Lighting / Direction indicators / Rear
foglamps / Voice recognition
4. Horn
5. Instrument panel
6. Head-up display cavity
7. Ignition switch
8. Controls - Wipers
9. Controls - Radio controls under the steering wheel
10. Controls at the steering wheel - Speed limiter and
Cruise control
11. Driver's airbag
12. Gear lever
13. Electric parking brake
14. Automatic gearbox SPORT/SNOW mode controls
15. Steering column adjustment
16. Head-up display controls
17. F u e l fl a p c o n t r o l
18. O d d m e n t s t r a y / F u s e b o x a c c e s s fl a p
D A S H B O A R D
Page 8 of 216
II
1111
A
B
C
EFD
G21
IN BRIEF
FRONT SEATS
C. Adjustment of the backrest angle.
D. Adjustment of the backrest lum-bar support.
E. Seat height and slide adjust-ments.
F. Adjustment of the seat cushion angle.
G. Memorisation of dashboard adjustments:
- Driver's seat.
- Steering wheel.
- Exterior rear view mirrors.
- Head-up display.
You have the possibility to mem-orise two driving positionsusing buttons 1 and 2.
ELECTRICAL ADJUSTMENTS
While the vehicle is stationary, unlock the steering wheel by push-ing the lever forward.
Adjust the height and the reach of the steering wheel, then lock the position by pulling the lever upwards.
MANUAL STEERING COL-UMN ADJUSTMENT
A. Adjustment of the backrest angle.
B. Controls for the heated seats.
282927
G E T T I N G S T A R T E D
Page 9 of 216
I
12
12
IN BRIEF
While the vehicle is stationary, adjust the height or the reach of the steering wheel by moving the control:forward or rearward to adjust the reach,
up or down to adjust the height.
Page 21 of 216
24
II
S I G N A L L I N G
DIRECTION INDICATORS
Left, downwards.
Right, upwards.
For a change of direction, move the control stalk beyond the tight spot. Stops automatically with the return of the steering wheel.
Visible alert / headlamp fl a s h
Pull the control towards you.
T h e h e a d l a m p fl a s h c a n b e m a d e even with the ignition switched off.
Horn
Press at the centre of the steering wheel.
HAZARD WARNING LAMPS
This operates all the direction indi-cators simultaneously.
Only use them to indicate dan-ger, for an emergency stop or for driving in abnormal conditions.
The hazard lamps can also be used with the ignition switched off.
SOUND SIGNAL FOR HEAD-LAMPS LEFT ON
This operates when the driver's door is opened, ignition off, to indi-cate that the vehicle lamps are still on.
It stops when you close the door, switch off the lamps or switch on the ignition.
This signal does not operate if the automatic lighting of headlamps or the guide-me-home lighting are active.
EMERGENCY OPERATION OF HAZARD WARNING LAMPS
A sudden deceleration of the vehi-cle causes the hazard lamps to come on automatically.
They will cease to operate auto-matically, or manually if you press the hazard lamps button on the dashboard.
The direction indicators cannot operate if the hazard warning lamps are on.
Page 24 of 216
27
II
S T E E R I N G C O L U M N A D J U S T M E N T – S E A T
B E L T H E I G H T A D J U S T M E N T
MANUAL ADJUSTMENT OF THE STEERING WHEEL FOR HEIGHT AND REACH
While the vehicle is stationary, unlock the steering wheel by push-ing the lever forward.
Adjust the height and the reach of the steering wheel, then lock the position by pulling the lever upwards.
ELECTRICAL ADJUSTMENT OF THE STEERING WHEEL FOR HEIGHT OR REACH
While the vehicle is stationary, adjust the height or the reach of the steering wheel by moving the control:forward or rearward to adjust the reachup or down to adjust the height.
The steering wheel adjustment is memorised with the driving posi- t i o n ( S e e “ M e m o r i s a t i o n ” ) .
Page 27 of 216
30
II
21
M
M E M O R I S A T I O N
DRIVING POSITIONS MEMO-RISED VIA BUTTONS 1 AND 2
To memorise a driving position:a. Place the igntion key in “Drive” p o s i t i o n ( s e c o n d p o s i t i o n ) .b. Make your adjustments of the seat, the steering wheel, the rear view mirrors and the Head-up Display.c. Press successively on button M then on button 1 ( fi r s t d r i v i n g p o s i t i o n ) o r 2 (second driving p o s i t i o n ) .
T h e m e m o r i s a t i o n i s c o n fi r m e d b y a sound signal.Note: The memorisation of a new driving position cancels and replaces the previous one.
The memorisation function allows to make the following dashboard adjustments:Driver's seat
Steering wheel
Exterior rear view mirrorsExteriorHead-up display.
See “Steering wheel adjustment”, “Rear view mirrors” and “Head-up Display”.
You have the possibility to memo-rise two driving positions using buttons 1 and 2.
Page 43 of 216
46
II
S T E E R I N G L O C K – I G N I T I O N – S T A R T E R
NEVER REMOVE THE IGNITION KEY BEFORE THE ENGINE HAS COME TO A COMPLETE STOP.
IT IS ESSENTIAL ALWAYS TO DRIVE WITH THE ENGINE RUNNING, SO AS TO RETAIN STEERING AND BRAKING ASSISTANCE (risk of the steering lock engaging and loss of safety features).
When stationary, having removed the key, carefully turn the steering wheel if you wish to lock the steering.
S: STEERING LOCK
To unlock the steering, gently move the steering wheel while turning the key, without exerting undue force.
When you remove the key, turn your steering wheel to lock the steering. The key can only be removed when in position S.
M: DRIVE POSITION
The steering is unlocked (by turn-ing the key in position M, if neces- s a r y m o v e t h e s t e e r i n g w h e e l ) .
STARTING AND STOPPING THE ENGINE
See “Driving”.
ECONOMY MODE
In order not to discharge the bat-tery while the engine is stopped, your vehicle goes automatically into economy mode after a max-imum of 30 minutes. Economy mode is indicated by a message on the screen.
The electrical components relating to comfort and also the headlamps (not sidelamps or hazard warning l a m p s ) c u t o u t a u t o m a t i c a l l y . T o reactivate them, it is necessary to start the engine.
Depending on your vehicle ver-sion, the following warning lamps are tested:
If one of these warning lamps does not light up, this indicates a mal-function.
D: STARTING
Release the key as soon as the engine starts. Never turn it while the engine is running.
Page 63 of 216
66
II
T R I P C O M P U T E R
T y r e d e fl a t i o n a l e r t
The SERVICE warning lamp comes on and a vehicle outline is displayed.
T h e l o c a t i o n o f t h e w h e e l ( s ) c o n c e r n e d i s c l e a r f r o m t h e v e h i c l e o u t l i n e , o n w h i c h t h e a f f e c t e d w h e e l ( s ) w i l l b e fl a s h -ing. Check the tyre pressures as soon as possible.
Colour screen CNaviDrive colour display
T y r e v e r y d e fl a t e d
T y r e d e fl a t e d
Stop immediately, avoiding any sudden actions with the steering wheel or the brakes.
C h a n g e t h e w h e e l w i t h t h e a f f e c t e d t y r e ( w h e t h e r p u n c t u r e d o r v e r y d e fl a t e d ) , t h e n h a v e t h e t y r e r e p a i r e d a n d all the pressures checked at the earliest opportunity.
The wheel with a damaged tyre (either in the boot or under repair) can no longer be detected (information given by the vehicle outline or by a message) nor is the spare wheel able to be detected.
Puncture
The “STOP” a n d t y r e ( s ) p u n c t u r e d w a r n i n g l a m p s l i g h t u p , a n d a v e h i c l e o u t l i n e i s d i s p l a y e d . T h e l o c a t i o n o f t h e w h e e l ( s ) c o n c e r n e d i s c l e a r f r o m t h e v e h i c l e o u t l i n e , o n w h i c h t h e a f f e c t e d w h e e l ( s ) w i l l b e fl a s h i n g .
Colour screen CNaviDrive colour display
Page 72 of 216
74
II
B R A K E S
ABS system
The ABS system enhances your safety by preventing the wheels from locking in the event of sudden braking or in conditions of poor road adherence. It enables you to retain control of the steering.
The functioning capability of all the electrical components essential to the ABS is monitored electronically before and during your journey. The ABS warning lamp lights up when you switch on the ignition: it should go out after a few seconds.
If the monitoring warning lamp does not go out, that means that the ABS has disconnected because there is a fault. Also, the fact that the monitoring warning lamp comes on durin g the journey shows that the ABS system is inactive. I n b o t h c a s e s , t h e n o r m a l b r a k i n g s y s t e m r e m a i n s e f fi c i e n t , e x a c t l y a s o n a v e h i c l e w i t h o u t A B S . H o w e v e r , i n o r d e r for the security associated with the correct functioning of the ABS to be restored, the vehicle should be examined as soon as possible by a CITROËN dealer.for the security associated with the correct associated with the
O n r o a d s w i t h p o o r a d h e r e n c e ( c h i p p i n g s , s n o w , i c e e t c . ) , i t i s a l w a y s i m p e r a t i v e t o d r i v e w i t h p r u d e n c e .
SYSTEM OF EMERGENCY BRAKING ASSISTANCE
The emergency braking assistance system helps you to attain the requ ired braking pressure more rapidly, thus to reduce the stopping distance. It operates as a function of the speed of action on the brake pedal, decreasing the resistance to this action. To prolong this action of the emerg ency braking assistance system, simply keep your foot on the brake pedal.
If the Electronic Parking Brake is off, the lighting of this wa rning lamp in conjunction with the STOP w a r n i n g l a m p i n d i c a t e s t h a t t h e b r a k e fl u i d l e v e l i s l o w o r t h a t t h e b r a k i n g d i s t r i b u t o r i s m a l -functioning. It is essential to stop the vehicle. Contact a CITROËN dealer as soon as possible. w a r n i n g l a m p i n d i c a t e s t h a t t h e b r a k e fl u i d l e v e l i s l o w o r t h a t t h e b r a k i n g d i s t r i b u t o r i s m a l - w a r n i n g l a m p i n d i c a t e s t h a t t h e b r a k e fl u i d l e v e l i s l o w o r t h a t t h e b r a k i n g d i s t r i b u t o r i s m a l -
Page 73 of 216
75
II
A
E L E C T R O N I C S T A B I L I T Y P R O G R A M M E
The ESP system offers increased driving safety but is not in place to encourage the driver to take addi-tional risks or to drive at excessive speeds.
The functioning of this system is subject to compliance with the manufacturer’s recommendations o n w h e e l s ( t y r e s a n d r i m s ) , b r a k e parts and electronic components, as well as with the assembly and repair procedures approved by CITROËN.repair procedures repair procedures
After any collision, have this system checked by a CITROËN dealer.After any collision, have this system collision, have this
ELECTRONIC STABILITY PROGRAMME (ESP) AND TRACTION CONTROL (ASR)
These systems are closely associated with ABS and additional to it. In the event of a loss of control of the vehicle by the driver, the ESP system acts automatically on one or more wheels and also on the engine to bring the vehicle back on trajectory. The ASR system optimises traction and prevents wheel spin by acting on the brakes of the driving wheels as well as on the engine. It also improves steering stability during acceleration.
OPERATION
When either the ESP or the ASR system is brought into operation the warning lamp “ESP/ASR ” fl a s h e s .
DEACTIVATION
I n e x c e p t i o n a l c o n d i t i o n s ( v e h i c l e s t u c k i n s n o w , s o f t g r o u n d , e t c . ) i t m a y prove useful to deactivate the ESP/ASR systems to allow the wheels to spin and thus regain traction.
Press on button A, the “ESP/ASR” warning lamp, as well as the lamp on the button A, light up. The ESP/ASR systems are no longer active.
The ESP/ASR systems will activate again:Automatically after the ignition has been switched off.
Automatically when you drive at above approx. 50 km/h (approx. 3 0 m p h ) .Manually with another press on button A.
OPERATIONAL ANOMALY
Should there be a system malfunction, the “ESP/ASR” warning lamp will light up.
Contact a CITROËN dealer to have the system checked.