trip computer Citroen C8 2008 1.G Owner's Manual

 I
IN BRIEF
1.
Volumetric alarm deactivation
switch.
2. Cruise control / speed limiter
controls.
3. Lighting, direction indicator
controls.
4. Driver’s airbag. Horn.
5. Multifunction display.
6. Radio controls under steering
wheel.
7. Screen wipe / screen wash /
trip computer controls.
8. Gear lever.
9. Ignition.
10. Headlamp height adjustment.
11. a/ ESP/ASR activation/
deactivation button.
b/ Parking assistance activation/deactivation button.
12. Steering column adjustment
control.
D A S H B O A R D

33
II
M U L T I F U N C T I O N D I S P L A Y
D i s p l a y C
Main menu
Press control
A to display the
“Main menu” for the multifunction
screen. Using this menu, you have
access to the following functions:
The driver is advised not to
manipulate the controls described
below while driving.
1 -
Time.
2 - Ambient temperature
3 - Date and Display zone
If the outside temperature is
between +3°C and -3°C, the
temperature display lashes (risk
of ice).
Note: The outside temperature
displayed may be higher than the
actual temperature if the vehicle is
standing in bright sunshine.
Radio-CD
(See radio-CD handbook)Trip computer, giving
you:
- Distance to your
destination.
- Access to log of alerts (list of the alerts that have been previously
signalled).
- Access to the status of functions, for example activation/
deactivation of automatic
headlamp lighting, daytime-
running lamps, ESP, windscreen
wipe.
Personalisation -
Coniguration , allowing
you to activate or
deactivate:
- the triggering of rear wipe
- the automatic guide-me-home lighting
- the automatic lighting of hea- dlamps
- automatic lighting of daytime- running lamps
Also to choose:
- Brightness, the time, the date, units.
- The display language.
Note : activation/deactivation of
automatic lighting of daytime-run-
ning lamps is available depending
on the country of marketing.
Controls
A
- Access to the “Main menu”
B - Scrolling in the display
menus.
C - Validation and Selection in
the menus, of the function
chosen or value modiied
D - Cancellation of the operation
or return to the previous
display.
E - Selection of the type of
information you wish to see
permanently displayed (date,
radio-CD, trip computer) on
the right of the screen

34 II
M U L T I F U N C T I O N D I S P L A Y
D i s p l a y C
PERSONALISATION and
CONFIGURATION
To activate/deactivate rear
screen wipe when engaging
reverse gear :
- Press
A.
- Select the “Personalisation- Coniguration” icon using B,
then conirm your choice by
pressing C.
- Then select the vehicle parame- ters sub-menu.
Conirm by pressing C.
- Using B, select rear screen
wipe.
Conirm by pressing C.
- Then by pressing C, select/de-
select rear screen wipe to acti -
vate/deactivate.
- Validate using “OK” on the dis-
play.
TRIP COMPUTER
To enter the distance to be
travelled in the trip computer:
- Press on
A.
- Use B to select the trip computer
icon, then conirm with a press
on C.
- Select your entry of distance, using B. Conirm your choice
with a press on C.
- To choose the distance, select the igure to be modiied, using B,
then conirm with a press on C.
- Use B to adjust the value then
validate with a press on C.
- Validate on “OK” on the display.
To access the log of alerts in
the trip computer:
- Press on A.
- Use B to select the trip computer
icon, then conirm with a press
on C.
- Select the log of alerts.
- When the list is displayed, scroll down by pressing B.
- Press on D, to return to the
permanent display.
To access the status of
functions, proceed in a similar
manner. To activate/deactivate the
automatic guide-me-home
lighting:
- Press on
A.
- Use B to select the icon
“Personalisation - Coniguration”
then conirm your choice with a
press on C.
- Then select the sub-menu for vehicle parameters. Conirm
your choice with a press on C.
- Using B, select lighting and
signalling. Conirm your choice
with a press on C.
- Then with a press on C, select/
deselect guide-me-home lighting
to activate or deactivate it. After
activation, choose the duration:
press on C then use B to select
the duration and press on C.
- Validate on “OK” on the display.
To activate/deactivate the au-
tomatic lighting of headlamps,
proceed in a similar manner.

3 II
NaviDrive display
Display C
T R I P C O M P U T E R
Range
This indicates the mileage that can still be travelled
using the fuel remaining in the tank.
When the distance remaining to be travelled is less
than around 30 km (approx. 20 miles), only three
dashes are visible.
Instantaneous fuel consumption
This is calculated from consumption over the previous
2 seconds. This function is only available when
travelling at over 30 km/h (approx. 20 mph).
Distance travelled
It indicates the distance travelled since the trip computer
was last reset to zero.
Average fuel consumption
The average fuel consumption is calculated from the
last reset of the computer.
Average speed
The average speed is obtained, from the last reset of
the computer, by dividing the distance covered by the
time taken (ignition on).
Distance remaining to be travelled
To enter it, see Multifunction display.

3 II
M U L T I F U N C T I O N D I S P L A Y
N A V I D R I V E C O L O U R S C R E E N
Controls
A -
Access to the “Main menu”
B - Scrolling in the display
menus.
C - Validation and Selection in
the menus, of the function
chosen or value modiied
D - Cancellation of the operation
or return to the previous
display
E - Selection of the type of
information you wish to see
permanently displayed (date,
radio-CD, trip computer) on
the right of the screen
Main menu
Press control A to display the
“Main menu” for the multifunction
screen. Using this menu, you have
access to the following functions: Trafic information
(See NaviDrive handbook)
Vehicle diagnostics
(See NaviDrive handbook)
Telematics
(See NaviDrive handbook)
Coniguration
, for adjusting
various parameters (date,
time, units)
(See NaviDrive handbook)
Map
(See NaviDrive handbook)
Video
(See NaviDrive handbook)
Navigation/guidance
(See NaviDrive handbook)
Audio
(See NaviDrive handbook)
The driver is advised not to
manipulate the controls described
below while driving.
1 -
Outside temperature
2 - Directory
3 - Date
4 - Telephone
5 - Time.
If the outside temperature is
between +3°C and -3°C, the
temperature display lashes (risk
of ice).
Note: The outside temperature
displayed may be higher than the
actual temperature if the vehicle is
standing in bright sunshine.

3 II
NaviDrive display
Display C
T R I P C O M P U T E R
Range
This indicates the mileage that can still be travelled
using the fuel remaining in the tank.
When the distance remaining to be travelled is less
than around 30 km (approx. 20 miles), only three
dashes are visible.
Instantaneous fuel consumption
This is calculated from consumption over the previous
2 seconds. This function is only available when
travelling at over 30 km/h (approx. 20 mph).
Distance travelled
It indicates the distance travelled since the trip computer
was last reset to zero.
Average fuel consumption
The average fuel consumption is calculated from the
last reset of the computer.
Average speed
The average speed is obtained, from the last reset of
the computer, by dividing the distance covered by the
time taken (ignition on).
Distance remaining to be travelled
To enter it, see Multifunction display.

37
II
Displays C and NaviDrive
The trip computer gives access to 3 types of instantaneous informat ion:
- Range
- Instantaneous consumption
- Distance remaining to be travelled.
It also gives you access to 3 types of information for two Journeys 1 and 2:
- Distance travelled
- Average consumption
- Average speed.
The journeys
Journeys 1 and 2 are identical but independent of each other. For example,
you can use Journey 1 for daily calculations and Journey 2 for mont hly
calculations.
To reset a journey to zero
When the desired journey is displayed, give a long press on th e end of the
wiper stalk.
To select the different types of
information and displays, briely
press the end of the windscreen
wiper control.
To reset trip computer informa-
tion to zero
, press continuously
for a few seconds on the end of
the stalk when one of the informa -
tion types is displayed.
- Distance travelled.
- Average fuel consumption.
- Average speed.
A press on the “ MODE” button
brings up a permanent display of
the trip computer information. T R I P C O M P U T E R

3 II
NaviDrive display
Display C
T R I P C O M P U T E R
Range
This indicates the mileage that can still be travelled
using the fuel remaining in the tank.
When the distance remaining to be travelled is less
than around 30 km (approx. 20 miles), only three
dashes are visible.
Instantaneous fuel consumption
This is calculated from consumption over the previous
2 seconds. This function is only available when
travelling at over 30 km/h (approx. 20 mph).
Distance travelled
It indicates the distance travelled since the trip computer
was last reset to zero.
Average fuel consumption
The average fuel consumption is calculated from the
last reset of the computer.
Average speed
The average speed is obtained, from the last reset of
the computer, by dividing the distance covered by the
time taken (ignition on).
Distance remaining to be travelled
To enter it, see Multifunction display.

66
A
D ESCRIPTIO N O F TH E CO NTRO LS
ADDITIONAL CONTROL (C ONLY)
The “ESC” buttonShor t press: Cancel the current operation or delete a superimposed display.L o n g p r e s s: Ret u r n t o t h e p e r m a n e nt display.
The “MENU” buttonShor t press: At any time, access to the Main menu.Long press: At any time, access to the Help menu.In certain countries, this control is deacti-vated while the vehicle is moving.
The “MUSIC” buttonShor t press: Display of shortcut menu for the current audio source.
The “TEL” buttonShor t press: Display of shortcut menu for the telephone function, and to pick up an incoming call.
The “NAV” buttonShor t press: Display of the shortcut menu for the navigation function.
The “MAIN” buttonShor t press: Display of general informa-tion.
To access certain functions without needing to use the NaviDrive buttons, or to access the shortcut menus for certain functions.
The control AThis has two functions:By rotation, it allows you:To move in the display in order to choose a function, a parameter or a value.To decrease or to increase a value you wish to adjust.To scroll through the components you can select when a list is displayed.To modify the scale of the map on the screen.By pressing, it allows you:To access shortcut menus for certain functions of the application, displayed on the right hand side of the screen.To validate the function chosen or the value modifi ed.To select a parameter such as “lectadjust” or “list”, to be able to modify it.
The “MODE” buttonShor t press: For selection of the type of information to be displayed on the right of the screen (Radio, Navigation, Trip computer, etc.).Long press: Display of general informa-tion.

88
Press on the end of the lighting control stalk to start voice recognition and say "Help" or " What can I say " to display the list of voice commands that are available.
CD playerDetail page 3
CD player
RandomDetail page 2ListTrack number1-20Previous trackNext trackScanDetail page 2Detail page 2
FolderRepeatNextPreviousJukeboxDetail page 3Detail page 3
Jukebox
RandomDetail page 2Detail page 2ListTrack number1-20Previous trackNext trackScanDetail page 2Detail page 2
FolderRepeatNextPreviousCD changerDetail page 42
CD changer
Disc number1-5Detail page 42Detail page 42Previous discNext discRandomDetail page 2Detail page 2ListTrack number1-20Detail page 42Detail page 42Previous trackDetail page 42Detail page 42Next trackDetail page 42Detail page 42RepeatScanDetail page 2
Display
AudioDetail page 2NavigatorDetail page 12Trip computerTelephoneDetail page 45
Telephone
Voice mailDetail page 45Redial
Adress book“Pre-recorded label”Detail page 45
Call“Pre-recorded label”Detail page 47
MessageDisplayDetail page 4ReadDetail page 4
Navigator
StopDetail page 12
Adress book“Pre-recorded label”Detail page 13
Restar tDetail page 12
ShowDestinationDetail page 25VehicleDetail page 25Zoom outDetail page 1Zoom inDetail page 1Guide to“Pre-recorded label”
Traf fi c InfoDisplayDetail page 25ReadDetail page 25RadioDetail page 31
Radio
AutostoreDetail page 32ListDetail page 32Memor y1- Detail page 31PreviousDetail page 31NextDetail page 31
L I S T A N D S T R U C T U R E O F V O I C E
C O M M A N D S
HOW TO ACCESS THE LIST OF PRE -RECORDED VOICE COMMANDS ?