key battery Citroen DS3 2014 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2014, Model line: DS3, Model: Citroen DS3 2014 1.GPages: 376, PDF Size: 12.55 MB
Page 66 of 376
DS3_en_Chap03_ouvertures_ed01-2014
Following disconnection of the vehicle battery, replacement of the remote control battery or
i
n the event of a remote control malfunction,
y
ou can no longer unlock, lock or locate
y
our vehicle.
F
F
irst of all, use the key in the lock to unlock
o
r lock your vehicle.
F
T
hen, reinitialise the remote control.
If
the problem persists, contact a CITROËN
d
ealer as soon as possible.
Remote control problem
Reinitialisation
F Switch off the ignition.
F T urn the key to position 2 (Ignition).
F
P
ress the closed padlock immediately for a
f
ew seconds.
F
S
witch off the ignition and remove the key
f
rom the ignition switch.
The
remote control is fully operational again.
changing the battery
Battery ref.: CR1620 / 3 volts.F U nclip the casing by inserting a coin at the
n
otch and rotating.
F
S
lide the flat battery out of its location.
F
S
lide the new battery into its location
observing
the original direction.
F
C
lip the casing in place, then the chrome
f
inisher.
F
R
einitialise the remote control.
If the battery is flat, you are
informed
by lighting of this warning
l
amp in the instrument panel, an audible signal
a
nd a message in the multifunction screen.
F
U
nfold the key.
F
R
elease the chrome finisher by pressing
on
lug A.
F
M
aintain pressure on lug A and remove the
c
hrome finisher by sliding it off at 45°.
Page 72 of 376
DS3_en_Chap03_ouvertures_ed01-2014
Activation
F Press button A for more than two seconds.
A confirmation message appears on the
m
ultifunction screen, accompanied by an
a
udible
s
ignal.
deactivation
F Press button A again for more than
two seconds.
A
confirmation message appears on the
m
ultifunction screen, accompanied by an
a
udible
s
ignal. To
lock or unlock the doors mechanically in the
e
vent of a central locking system failure or flat
b
attery.
Emergency control
Locking the driver's door
F Insert
the key in the lock, then turn it to the r
ight.
Unlocking the driver's door
F Insert the key in the lock, then turn it to t
he left.
Locking the passenger's door
F Remove the black cap, on the edge of the d
oor, using the key.
F
I
nsert the key in the cavity, then turn it fully.
F
R
emove the key and refit the cap.
Unlocking the passenger's door
F Pull the interior door opening control.
In the event of a fault with the central
locking
system,
you
must
disconnect
t
he
battery
to
lock
the
boot
and
s
o
ensure
the
complete
locking
of
t
he vehicle.
Driving
with
the
doors
locked
may
m
ake
access
more
difficult
for
the
em
ergency
ser
vices
i
n
a
n
em
ergency.
Page 73 of 376
71
DS3_en_Chap03_ouvertures_ed01-2014
boot
Opening
F After unlocking the vehicle using the r
emote control or the key, press the
o
pening control and raise the tailgate.
closing
F Lower the tailgate using the interior grab han
dle.
If
the tailgate is not closed correctly:
-
when the engine is running , this
warning lamp comes on, accompanied b
y a message on the multifunction
s
creen for a few seconds,
- when the vehicle is moving (speed above 6 mph (10 km/h)), this warning lamp comes
o
n, accompanied by an audible signal and
a
message on the multifunction screen for
a
few seconds. System
for mechanical unlocking of the boot
i
n the event of a battery or central locking
m
alfunction.
Tailgate release
Unlocking
F Fold back the rear benchseat to gain a
ccess to the lock from inside the boot.
F
I
nsert a small screwdriver into hole A of the
lock
to unlock the tailgate.
Access
Page 120 of 376
DS3_en_Chap06_conduite_ed01-2014
Stop & StartThe Stop & Start system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...). The engine restarts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect
for urban use, the Stop & Start system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.
Operation
Going into engine STOP mode
For your comfort, during parking manoeuvres, STOP mode is not
a
vailable for a few seconds after
coming
out of reverse gear.
STOP
mode does not affect the
f
unctionality of the vehicle, such as for
example,
braking, power steering...
Never
refuel with the engine in STOP
m
ode; you must switch off the ignition
w
ith the key.
The "E
cO
"
warning
lamp
comes
o
n
in
the
instrument
panel
and
the
e
ngine
goes
into
standby:
-
w
ith a manual gearbox , at speeds below
12
mph
(20
km/h),
when
you
put
the
gear
l
ever into neutral, and you release the
clutch
pedal.
-
w
ith a 5 or 6-speed electronic gearbox ,
when
stationary
or
at
speeds
below
5
mph
(
8
km/h)
(depending
on
version),
when
you
p
ress
the
brake
pedal
or
put
the
gear
lever
i
n position N .
A
time
counter
calculates
the
sum
o
f
the
periods
in
STOP
mode
d
uring
a
journey.
It
rests
itself
t
o
zero
every
time
the
ignition
is
s
witched
on
with
the
key. STOP
mode is not invoked when:
- t he driver's door is open,
-
t
he driver's seat belt is not fastened,
-
t
he vehicle has not exceeded 6 mph
(10
km/h) since the last engine start using
t
he key,
-
t
he engine is needed to maintain a
c
omfortable temperature in the passenger
c
ompartment,
-
d
emisting is active,
-
s
ome special conditions (battery charge,
e
ngine temperature, braking assistance,
a
mbient temperature...) where the engine is
n
eeded to assure control of a system.
Special cases: STOP mode not
available
The "EcO" warning lamp flashes for a
few seconds then goes off.
This operation is perfectly normal.
Page 122 of 376
DS3_en_Chap06_conduite_ed01-2014
The system is reactivated automatically at every new start using the key.
Reactivation
This system requires a battery with a special specification and technology (reference
n
umbers available from a CITROËN dealer or a
q
ualified
w
orkshop).
Fitting
a battery not listed by CITROËN
i
ntroduces the risk of malfunction of the
s
ystem.
In
the
event
of
a
fault
with
the
system,
the
"
E
cO O
FF"
switch
warning
lamp
flashes
then
c
omes
on
continuously.
Have
it
checked
by
a
CITROËN
dealer
or
a
q
ualified
w
orkshop.
In
the
event
of
a
fault
in
STOP
mode,
the
v
ehicle
may
stall.
All
of
the
instrument
panel
w
arning
lamps
come
on.
It
is
then
necessary
t
o
switch
off
the
ignition
and
start
the
engine
a
gain
using
the
key.
Operating fault Maintenance
Before doing anything under the b
onnet, deactivate the Stop & Start
system
to avoid any risk of injury
r
esulting from automatic operation of
S
TART mode.
The
Stop & Start system makes use
o
f advanced technology. All work
o
n this type of battery must be done
b
y a CITR
oË
N dealer or a qualified
workshop.
Press the "EcO O
FF"
switch
again.
The
system
is
active
again;
this
is
confirmed
b
y
the
switch
warning
lamp
going
off,
a
ccompanied
by
a
message
in
the
screen.
Page 360 of 376
DS3_en_Chap14_index-recherche_ed01-2014
Exterior
Remote control key 60 - 65
- ope ning/closing
-
a
nti-theft protection
-
s
tarting
-
battery Lighting
controls
1
32-137
Headlamp
adj
ustment
1
38
Changing
bu
lbs
2
15-219
-
f
ront lamps
-
fo
glamps
-
d
irection indicator repeaters
Wiper
controls
1
39 -142
Changing
a wiper
blade
235 Door
mirrors
8
1
Doors
6
8 -70
-
ope
ning/closing
-
c
entral locking
-
em
ergency
c
ontrol
Electric windows
6
6 - 67
Fuel
tank
1
90 -191
Misfuel
prevention
1
92
ac
cessories
242-243
Hill start assist
1
21
Braking
assistance
1
54-155
Trajectory
control
1
55 -156
Tyre pressures
2
05, 272
Under-inflation detection
1
50-153
b
oot
71
Temporary
pu
ncture
r
epair kit
2
02-206
Changing
a wheel
2
07-213
-
tools
-
r
emoving/refiting
Snow chains
2
14
Changing
bu
lbs
2
20-222
-
r
ear lamps
-
3
D rear lamps
-
3
rd brake lamp
-
n
umber plate lamps
Rear
parking sensors
1
26 -127
Reversing camera
1
28
Towbar
23
8-239
Towing
23
6-237