stop start CITROEN DS3 CABRIO 2018 Handbook (in English)

4
Instruments and controls3
Dashboard fuses
4
Rear view mirror
Courtesy lamp
Active City Brake
5
Monochrome screen A
Monochrome screen C
Audio system
Touch screen tablet
Adjust date and time
6
Ventilation
Heating
Manual air conditioning
Automatic air conditioning
Front demisting/defrosting
Rear screen demisting/defrosting
7
Manual gearbox
Electronic gearbox (ETG)
Automatic gearbox
Stop & Start
8
Centre armrest
Parking brake
9
Glove box
10
Emergency or Assistance call
Hazard warning lamps
1
Door mirror controls
Electric window controls
2
Bonnet opening control
Over view

15
Engine oil
pressureFixed.
There is a fault with the engine oil
lubrication circuit. You must stop as soon as it is safe to do so.
Park, switch off the ignition and contact the dealer
network or a
qualified workshop.
Warning/indicator lamp
StateCause Action/Observations
Maximum
coolant
temperature Fixed.
The temperature of the cooling
system is too high. You must stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up the level, if necessary.
If the problem persists, contact the dealer network or
a


qualified workshop.
Battery charge Fixed. The battery charging circuit has
a
fault (dirty or loose terminals, slack
or cut alternator belt, etc.). The warning lamp should go off when the engine is
started.
If it does not go off, contact the dealer network or
a


qualified workshop.
Door(s) open
Fixed, if the speed is
below 6 mph (10 km/h).A door or the boot is still open. Close the door or boot.
Fixed and accompanied
by an audible signal
if the speed is above
6
mph (10 km/h).
Seat belt not
fastened/
unfastened Fixed, then flashing,
accompanied by an
increasing audible
signal. The driver or front passenger has
not fastened or has unfastened their
seat belt.
Pull the strap then insert the tongue into the buckle.
01
Instruments

22
Warning/indicator lampStateCause Action/Observations
Passenger's
airbag system Fixed.
The control switch, located in
the glove box, is set to the " OFF"
position.
The passenger's front airbag is
deactivated.
You can install a "rearward" facing
child seat, unless there is a
fault with
the airbags (airbag warning lamp on). To activate the passenger front airbag, turn the
control to the "
ON" position.
In this case, do not fit a
child seat in the "rear ward"
facing position.
Stop & Star t Fixed.
When the vehicle stops (red lights, traffic
jams, etc.) the Stop & Start system puts
the engine into STOP mode.The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want
to move off.
Flashes for a

few
seconds, then goes
of f. STOP mode is temporarily
unavailable.
or
START mode is triggered
automatically. For more information on Stop & Star t
, refer to the
corresponding section.
Left-hand
direction
indicator Flashing with audible
signal.
The lighting control stalk has been
moved down.
Right-hand
direction
indicator Flashing with audible
signal.
The lighting control stalk has been
moved up.
Automatic
wiping
Fixed.
The wiper control stalk has been
pushed down. Automatic front wiping is activated.
01
Instruments

39
Reset trip
With touch screen tablet
Display of information
- Current information showing:
• t he range,
•

t
he current fuel consumption,
•

t
he distance remaining or the
Stop & Start time counter.
-

T
rip "1" with:
•

t
he distance travelled,
•
t

he average fuel consumption,
•
t

he average speed,
for the first trip.
-

T
rip "2" with:
•

t
he distance travelled,
•
t

he average fuel consumption,
•
t

he average speed,
for the second trip.
F

T

he next press then returns you to the
normal display. F
W hen the required trip is displayed, press
the button on the end of the wiper control
stalk for more than two seconds.
Tr i p s " 1" and " 2" are independent but they are
used in the same way.
For example, trip 1
can be used for daily figures
and trip 2
for monthly figures.
F

P
ress the MENU button, then select
" Driving ", to display the different tabs.
F

S
elect the desired tab using your finger.
-

T
he "Current " or "Instantaneous " tab with:
•

t
he range,
•

t
he current fuel consumption,
•

t
he Stop & Start time counter. -
T he "
Tr i p 1 " tab with:
• t he distance travelled,
•
t

he average fuel consumption,
•
t

he average speed,
for the first trip.
-

T
he "Tr i p 2 " tab with:
•

t
he distance travelled,
•
t

he average fuel consumption,
•
t

he average speed,
for the second trip.
Reset trip
F When the desired trip is displayed, press the reset button.
Tr i p s " 1" and " 2" are independent but they are
used in the same way.
For example, trip 1
can be used for daily figures
and trip 2
for monthly figures.
01
Instruments

40
A few definitions
Range
(miles or km)
The distance which can still be
travelled with the fuel remaining
in the tank (at the average fuel
consumption seen over the last
distance travelled).
This value may fluctuate if a
change
of driving style or terrain results in
a

significant change in the current fuel
consumption.
When the range falls below around 20
miles
(30

km), dashes are displayed. After filling with
at least 5

litres of fuel, the range is recalculated
and is displayed if it exceeds around 60
miles
(10 0


k m).
If dashes instead of figures continue to be
displayed when driving, contact the dealer
network or a
qualified workshop.
Current fuel consumption
(mpg or km/l or l/100 km)
C alculated during the last few
seconds. This function is only displayed from
around 20 mph (30 km/h).
Average fuel consumption
(mpg or km/l or l/100 km)
C alculated since the last time the
trip recorder was reset to zero.
Average speed
(mph or km/h)
Calculated since the last time the
trip recorder was reset to zero.
Distance travelled
(miles or km)
Calculated since the last time the
trip recorder was reset to zero.
Distance remaining to travel
(miles or km)
This is the distance remaining to
travel before the final destination is
reached. It can be input by the user.
If the distance is not entered, dashes
are displayed instead of numbers.
Stop & Start time counter
(minutes/seconds or hours/minutes)
If your vehicle is fitted with Stop &
Start, a time counter adds up the
time spent in STOP mode during
a


j o u r n ey.
It is reset to zero every time the
ignition is switched on using the key.
Date and time adjustment
With monochrome screen A
F Press the MENU button.
F S elect "Display settings" using the buttons
" 5 " or " 6".
F

P
ress " OK" to confirm the selection.
F

S
elect the "Year" function using the buttons
" 5 " or " 6".
F

P
ress " OK" to confirm the selection.
F

D
efine the desired value using the buttons
" 7 " or " 8".
F

P
ress " OK" to confirm the selection.
F

R
estart the procedure for the settings
"Month", "Day", "Time", and "Minutes".
01
Instruments

45
Lost keys
Go to a member of the dealer network, taking
with you the vehicle's registration certificate,
your personal identification documents and if
possible, the label bearing the key code.
The member of the dealer network will be able
to look up the key code and the transponder
code required to order a
new key.
Do not throw away the remote control
batteries, they contain metals which are
harmful to the environment.
Take them to an approved collection
point. Anti-theft protection
Do not make any modifications to the electronic
engine immobiliser system; this could cause
malfunctions.
Remote control
The high frequency remote control is a
sensitive
system; do not handle it while it is in your pocket
as there is a
possibility that it may unlock the
vehicle without you being aware of it.
Do not repeatedly press the buttons of your
remote control out of range and out of sight of
your vehicle. You may stop it from working and
the remote control would have to be reinitialised.
No remote control can operate when the key is
in the ignition switch, even when the ignition is
switched off, except for reinitialisation.
Locked vehicle
Driving with the doors locked could make it
difficult for the emergency services to enter the
vehicle in an emergency.
As a
safety precaution, never leave children
alone in the vehicle, except for a
very short
period.
In all cases, it is essential to remove the key
from the ignition switch when leaving the
vehicle. Second-hand vehicle
Have the pairing of all of the keys in your
possession checked in the dealer network, to
ensure that only your keys can be used to open
and start the vehicle.
F
S
lide the discharged battery out of its
location.
F

S

lide the new battery into its location,
observing the original direction of fit.
F

C

lip in the unit then the chrome finisher.
F

R

einitialise the remote control.
02
Access

51
Unlocking the passenger door
F Pull the interior door opening control.
Convertible roof
Your vehicle is equipped with an electrically
operated convertible roof.Electrically operated opening
and closing
The roof is opened and closed by pressing the
control located on the courtesy lamp, in the
opening direction 1 and the closing direction 2 .
The roof manoeuvres can be per formed:
-

w
ith the engine running, or
-

w
ith the ignition on. To maintain the level of charge in the
battery, it is advisable to operate the roof
with the engine running
.
Depending on the level of charge of the
battery, if the roof is operated with the
ignition switched on, starting the engine
may cause the roof to stop moving. To
continue moving the roof, repeat the
command after you have started the
engine.
Manoeuvre zones
You have two manoeuvre zones:
Zone A: horizontal manoeuvre zone, in
manual or automatic mode.
Zone B: vertical manoeuvre zone, in
automatic mode only.
02
Access

52
Roof positions
Position 0:Roof completely closed.
Position 1: Stop position during automatic
closure of the roof.
Position 2: Roof open horizontally.
Position 3: Roof completely open.
Before operating the roof, make sure that
no-one inside or outside the vehicle is
exposed to any risk related to moving the
roof or the rear screen and that no objects
hinder this operation.
Opening
Manual mode
F In zone A , press and hold the control
without passing the point of resistance to
open the roof.
F

T
he roof stops when you release the
control. The roof can only be opened in zone B in
automatic
mode.
Automatic mode
F In zone A , press the control beyond the
point of resistance to start opening the roof.
During the automatic roof opening in zone
A , pressing the control stops the roof.
02
Access

54
If the roof is not locked correctly, repeat
the closure command with the engine
running.
If the problem persists, contact the dealer
network or a qualified workshop.
The closure of the roof in zone B can only
be done in automatic mode.
Automatic mode
F In position 3, press the control to start
closing the roof.
When the roof is completely open, the
screen is placed on the rear shelf.
Do not place any object on the screen. During a
manoeuvre in zone B
, stopping
the roof is not possible.
Pressing the control inverts the direction
of movement whatever the direction of the
press on the control.
This "anti-panic" function allows a

rapid
reversal of the roof 's direction of
movement in case of emergency.
F
R
elease the control: the roof closure will
continue to position 2 . The complete closure of the roof in zone A
can only be done in manual
mode.
Keep the control pressed down until the
roof is heard to lock.
If the roof is not locked correctly, repeat
the closure command with the engine
running.
If the problem persists, contact the dealer
network or a qualified workshop.
F
Be
tween positions 2 and 1
, pressing the
control beyond the point of resistance
allows automatic closure of the roof to
position 1 .
F

Be
tween positions 1 and 0, press the
control and keep it pressed until the roof is
completely closed.
02
Access

55
During the automatic roof closure in zone
A (position 2 to position 1), pressing the
control stops the roof.
Acoustic air deflector
An acoustic air deflector is available in order to
improve the acoustic comfort of the occupants
of the vehicle in certain driving conditions
(high speed), by limiting currents in the
passenger compartment that are caused by air
displacement. When the roof opens, the deflector may deploy
if it is not fixed.
When the roof is closed, the deflector refolds
automatically.
F

W
ith the roof open, this deflector may be
folded manually and fixed in its centre:
press vertically on the cross member close
to the lever at the top of the deflector, and
clip this lever into the notch.
F
T
o release and deploy the deflector
manually: press vertically on the cross
member close to the lever to unclip it from
the notch and pull it slightly towards you.
Operating the roof while
driving
The roof opening and closing command
operates at up to about 75 mph
(120


km/h).
Above this speed, a message on the
screen will inform you that the roof
manoeuvre is impossible (speed too high).
If a

roof manoeuvre has been started when the
speed of the vehicle is less than around 75
mph
(120
km/h), exceeding this speed threshold will
result in the following situations, depending on
the type of manoeuvre under way:
-

a m
anoeuvre under way in zone A is
stopped,
-

a
n opening manoeuvre under way in zone B
is allowed to complete,
-

a c
losing manoeuvre under way in zone
B is stopped and the complete opening
of the roof to position 3
is per formed
automatically,
-

a
n opening or closing manoeuvre in zone B
following an "anti-panic" function is allowed
to complete.
A new roof manoeuvre will be possible
once the speed of the vehicle is less than
around 75
mph (120 km/h).
02
Access