CITROEN DS3 CABRIO DAG 2016 Handbook (in English)

139
DS3_en_Chap05_visibilite_ed01-2015
Operating fault
If an automatic wiping fault occurs, the wipers will   operate   in   intermittent   mode.
Have
  it   checked   by   a   CITROËN   dealer   or   a  
q

ualified
 w
orkshop.
To retain the effectiveness of the flat
wiper
  blades,   it   is   advisable   to:
-
 
h
andle   them   with   care,
-
 
c
lean   them   regularly   using   soapy  
w

ater,
-
 
n
ot   use   them   to   hold   a   sheet   of  
c

ardboard   against   the   windscreen,
-
 
r
eplace   them   at   the   first   signs   of  
w

e a r.
Do
  not   cover   the   rain   sensor,   linked  
w

ith the sunshine sensor and located in
the centre of the windscreen behind the
rear
  view   mirror.
Switch
  off   the   automatic   wiping   when  
u

sing   an   automatic   car   wash.
In winter, it is advisable to wait until the
windscreen
  is   completely   clear   of   ice  
b

efore   activating   the   automatic   wiping.This position allows the wiper blades to
be
  lifted   for   winter   parking,   cleaning   or  
r

eplacement   without   damaging   the   bonnet.
In
  the   minute   following   switching   off   of   the  
i

gnition,   any   action   on   the   wiper   stalk   positions  
t

he   wipers   vertically.
To
  park   the   wipers   after   this   has   been   done,
 s

witch   on   the   ignition   and   operate   the   wiper   stalk.
Vertical windscreen wiper
position
Visibility

DS3_en_Chap05_visibilite_ed01-2015
A. Courtesy lamp
B. Map reading lamps
Courtesy lam p
In this position, the courtesy lamp c
omes   on   gradually:
Courtesy lamp
- when  the   vehicle   is   unlocked,
-  w hen   the   key   is   removed   from   the   ignition,
-

w
hen a door is opened,
-
 
w
hen   the   remote   control   locking   button   is  
a

ctivated,   in   order   to   locate   your   vehicle.
It
  switches   off   gradually:
-
 
w
hen   the   vehicle   is   locked,
-
 
w
hen   the   ignition   is   switched   on,
-
 
3
0   seconds   after   the   last   door   is   closed.
Permanently
  off.
Permanent
 l

ighting.
With the "permanent lighting" mode, the duration of lighting   varies,   depending   on   the   circumstances:
- with the ignition off, approximately ten minutes,
- in energy economy mode, a pproximately   thirty   seconds,
- with the engine running, unlimited.
Map reading lamps
F With  the   ignition   on,   press   the  c
orresponding s witch.

141
DS3_en_Chap05_visibilite_ed01-2015
Interior mood lightingThe dimmed passenger compartment lighting improves visibility in the vehicle when the light 
i s   poor.
Switching on
At night, the illumination of footwells and the central   dashboard   storage   compartment   comes  
o

n   automatically   when   the   sidelamps   are  
s

witched   on.
Switching off
The interior mood lighting switches off automatically   when   the   sidelamps   are  
switched
  off.
It
  can   be   switched   off   manually   using   the  
i

nstrument   panel   lighting   rheostat   button.
F
 
W
ith   the   lighting   on,   press   several   times   on  
t

he   left   hand   button   of   the   instrument   panel  
t

o   progressively   reduce   the   dashboard  
l

ighting   level.
F
 
P
ress   again   to   reduce   the   lighting   level  
t

o   the   minimum   and   switch   off   the   interior  
m

ood
 l
ighting. This
  comes   on   automatically   when   the   boot   is  
o

pened   and   goes   off   automatically   when   the  
b

oot   is   closed.
Boot lamp
The lighting time varies according to the c ircumstances:
-
 
w
hen   the   ignition   is   off,
 a

pproximately   ten minutes,
-
 
i
n   energy   economy   mode,
 a

pproximately   thirty seconds,
-
 
w
hen   the   engine   is   running,   no   limit.
Visibility

Safety

DS3_en_Chap06_securite_ed01-2015

Direction
indicators
F Left:  lower   the   lighting   stalk   beyond   the  p
oint   of   resistance.
F
 
R
ight:   raise   the   lighting   stalk   beyond   the  
p

oint   of   resistance.
Three flashes of the direction
indicators
F Press briefly upwards or downwards, without   going   beyond   the   point   of  
r

esistance;   the   direction   indicators   will  
f

lash   3   times.
Hazard warning lam ps
A visual warning by means of the direction i
ndicators to alert other road users to a vehicle
breakdown,
  towing   or   accident.
F

P
ress this button, the direction indicators
flash.
They
  can   operate   with   the   ignition   off.
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on the   deceleration,   the   hazard   warning   lamps  
c

ome   on   automatically.
They
  switch   off   automatically   the   first   time   you  
a

ccelerate.
F
 
Y
ou   can   also   switch   them   off   by   pressing  
t

he   button.

145
DS3_en_Chap06_securite_ed01-2015
Horn
Audible warning to alert other road users to an imminent d anger.
F
 
P
ress   one   of   the   spokes   of   the   steering  
w

heel.
Emergency o r 
a

ssistance call
This system allows you to make an emergency o
r   assistance   call   to   the   emergency   services  
o

r   to   the   dedicated   service   (operated   by  
C

ITROËN   Assistance).
For
  more   information   on   the   use   of   this  
f

unction,   refer   to   the   "Audio   and   telematics"  
s

ection.
Safety

Under-inflation detection
System which automatically checks the pressures of the tyres while driving.
T he   under-inflation   detection   system  
d

oes   not   replace   the   need   for   vigilance  
o

n   the   part   of   the   driver.
This
  system   does   not   avoid   the   need   to  
c

heck   the   tyre   pressures   (including   the  
s

pare   wheel)   every   month   as   well   as  
b

efore   a   long   journey.
Driving
  with   under-inflated   tyres  
i

mpairs   road   holding,   extends   braking  
d

istances   and   causes   premature  
t

yre wear, particularly under arduous
condition
  (high   loading,   high   speed,  
lon

g
 jo
urney).The inflation pressures defined for
your vehicle can be found on the tyre
pressure
  label.
See
  the   "Identification   markings"  
s

ection.
Tyre
  pressures   should   be   checked  
w

hen   the   tyres   are   "cold"   (vehicle  
s

topped   for   1   hour   or   after   a   journey   of  
l

ess   than   6   miles   (10   km)   at   moderate  
s

peeds).
Other wise
  (when   hot),   add   0.3   bar   to  
t

he   pressures   shown   on   the   label.
Driving
  with   under-inflated   tyres  
i

ncreases   fuel   consumption.
The
  system   monitors   the   pressures   in   the   four  
t

yres,   once   the   vehicle   is   moving.
It
  compares   the   information   given   by   the   four  
w

heel speed sensors with reference values,
which must be reinitialised ever y time the
tyre pressures are adjusted or a wheel
changed .
The
  system   triggers   an   alert   as   soon   as   it  
d

etects a drop in the inflation pressure of one
or
  more   tyres.

147
DS3_en_Chap06_securite_ed01-2015
The alert is maintained until the system is r einitialised.
The loss of pressure detected does not
always
 
cause
 
visible
 
bulging
 
of
 
the
 
tyre.
 
D

o
 
not
 
satisfy
 
yourself
 
with
 
just
 
a
 
visual
 
c

heck. Before
  reinitialising   the   system,   ensure  
t

hat the pressures of the four tyres are
correct for the use of the vehicle, as
given
  on   the   tyre   pressure   label.
The
  under-inflation   detection   system  
d

oes   not   give   a   warning   if   a   pressure   is  
i

ncorrect   at   the   time   of   reinitialisation.
Under-inflation alert
This is given by fixed illumination of this   warning   lamp,   accompanied   by  
a

n   audible   signal   and   the   display   of   a  
m

essage.
F
 
R

educe   speed   immediately,   avoid  
e

xcessive   steering   movements   and   sudden  
b

raking
F
 
S

top
 
the   vehicle   as   soon   as   it   is   safe   to   do   so.F
 I f   you   have   a   compressor   (such   as   the   one  
i

n   the   temporary   puncture   repair   kit),   check  
t

he   pressures   of   the   four   tyres   when   cold.  
I

f   it   is   not   possible   to   carry   out   this   check  
s

traight   away,   drive   carefully   at   reduced  
s

peed.
or
F

I
n the event of a puncture, use the
temporary
  puncture   repair   kit   or   the   spare  
w

heel   (depending   on   equipment).
Reinitialisation
It is necessary to reinitialise the system every time   one   or   more   tyre   pressure   is   adjusted,   and  
a

fter   changing   one   or   more   wheels.
A
  label   on   the   middle   pillar,   left   hand   side,   gives  
a

  reminder   of   this.
Safety

Reinitialisation of the system is done in the vehicle configuration menu, with the vehicle stationary and the ignition on.
Monochrome screen A
F Press the MEn U button for access to the
main   menu.
F

P
ress the " 5" or " 6" button to select
the Veh conf ig
 

menu,   then   confirm   by  
p

ressing   the   OK
 
button.
F

P
ress the " 5" or " 6" button to select the
" Reinit inflat ",
  menu,   then   confirm   by  
p

ressing   the   OK
 
button.
 A

  message   is   displayed   to   confirm   the  
in

struction.
F
 
C
onfirm   by   pressing   the   OK
 
button.
Monochrome screen C
F Press the MEnU button for access to the
main   menu.
F

P
ress the " 5" or " 6" button to select the
" Personalisation-configuration "
  menu,  
t

hen   confirm   by   pressing   the   OK
 
button.
F

P
ress the " 5" or " 6" button to select the
"
def

ine vehicle parameters "
  menu,   then  
c

onfirm   by   pressing   the   OK
 
button.F
P ress the "
5" or " 6" button to select
the " Tyre pressures "
  menu,   then   the  
"R

einitialisation"
  menu,   then   confirming  
b

y   pressing   the   OK
 
button.
 A

  message   confirms   the   reinitialisation.