battery Citroen DS3 DAG 2009.5 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2009.5, Model line: DS3 DAG, Model: Citroen DS3 DAG 2009.5 1.GPages: 244, PDF Size: 7.12 MB
Page 20 of 244
Warning lamps
When the engine is running or the vehicle is being driven, the switching on of one of the following warning lamps indicates a fault which requires action on the par t of the driver.
Any fault resulting in the switching on of a warning lamp must be investigated fur ther by reading the associated message on the multifunction screen. If you encounter any problems, do not hesitate to contact a CITROËN dealer.
Warning lampis onCauseAction/Obser vations
STOP fixed, associated with another warning lamp and accompanied by an audible signal.
It is associated with the braking system or the engine coolant temperature.
Stop as soon as it is safe to do so. Park, switch off the ignition and call a CITROËN dealer.
Ser vice
temporarily. A minor fault has occurred for which there is no specific warning lamp. Identify the fault by reading the message shown on t he screen, such as, for example: - the engine oil level, - the screenwash level, - the remote control battery, - saturation of the par ticle emission filter (Diesel). For any other faults, contact a CITROËN dealer.
fixed. A major fault has occurred for which
there is no specific warning lamp.
Identify the fault by reading the message shown on t he
screen and contact a CITROËN dealer.
Page 23 of 244
33Instruments and controls
Warning lampis onCauseAction/Obser vations
Engine oil
pressure
fixed. There is a fault with the engine
lubrication system.
Stop as soon it is safe to do so.
Park, switch off the ignition and contact a CITROËN dealer.
Batter y charge fixed. The battery charging circuit has a fault (dir ty or loose terminals, slack or cut alternator belt, ...).
This lamp should switch off when the engine is star t ed. If it does not switch off, contact a CITROËN dealer.
Door(s) open
fixed if the speed is below 6 mph (10 km/h).
A door or the boot is still open. Close the door or boot. fixed and accompanied by an audible signal if the speed is above
6 mph (10 km/h).
Page 27 of 244
37Instruments and controls
5 seconds after the ignition is switched on, the distance recorder resumes its normal operation. The spanner remains lit.
The distance remaining may be weighted by the time factor, depending on the driver's driving habits.
Therefore, the spanner may also come on if you have exceeded the two year ser vice inter val.
Service indicator zero reset
After each ser vice, the ser vice indicator must be reset to zero. The procedure for resetting to zero is as follows: switch off the ignition, press and hold the trip distance recorder zero reset button, switch on the ignition; the distance recorder display begins a countdown, when the display indicates "=0" , release the button; the spanner disappears.
Following this operation, if you wish to disconnect the battery, lock the vehicle and wait at least five minutes for the zero reset to be taken into account.
Retrieving the service information
You can access the ser vice information at any time. Press the trip distance recorder zero reset button. The ser vice information is displayed for a few seconds, then disappears.
Service overdue
For 5 seconds after the ignition is switched on, the spanner flashes to indicate that the ser vice must be carried out as soon as possible. Example: the ser vice is overdue by 300 km. For 5 seconds after the ignition is switched on, the display indicates: