service reset Citroen DS3 DAG 2010 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2010, Model line: DS3 DAG, Model: Citroen DS3 DAG 2010 1.GPages: 253, PDF Size: 7.45 MB
Page 14 of 253
37Monitoring
System which informs the driver when the next ser vice is due, in accordance with the manufacturer's ser vicing schedule. The point at which the ser vice is due is calculated from the last indicator zero reset.It is determined by two parameters: - the distance travelled, - the time elapsed since the last ser vice.
Service indicator
Between 600 miles (1 000 km) and 1 800 miles (3 000 km) remain before the next service is due
For a few seconds after the ignition is switched on, the spanner symbolising the ser vice operations comes on. The distance recorder display line indicates the distance remaining before the next ser vice is due. Example: 1 700 miles/2 800 km remain before the next ser vice is due. For a few seconds after the ignition is switched on, the display indicates:
Less than 600 miles (1 000 km) remain before the next service is due
Example: 400 miles/900 km remain before the next ser vice is due. For a few seconds after the ignition is switched on, the display indicates:
A few seconds after the ignition is switched on, the distance recorder resumes its normal operation. The spanner remains on to indicate that a ser vice must be carried out soon. A few seconds after the ignition is switched on, the spanner goes off ; the distance recorder off
resumes its normal operation. The display then indicates the total and trip distances.
More than 1 800 miles (3 000 km) remain before the next service is due
When the ignition is switched on, no ser vice
information appears on the display.
Page 15 of 253
A few seconds after the ignition is switched on, the distance recorder resumes its normal operation. The spanner remains on .
The distance remaining may be weighted by the time factor, depending on the driver's driving habits.
Therefore, the spanner may also come on if you have exceeded the two year ser vice inter val.
Service indicator zero reset
After each ser vice, the ser vice indicator must be reset to zero. The procedure for resetting to zero is as follows: switch off the ignition, press and hold the trip distance recorder zero reset button, switch on the ignition; the distance recorder display begins a countdown, when the display indicates "=0" , release the button; the spanner disappears.
Following this operation, if you wish to disconnect the battery, lock the vehicle and wait at least five minutes for the zero reset to be taken into account.
Retrieving the service information
You can access the ser vice information at any time. Press the trip distance recorder zero reset button. The ser vice information is displayed for a few seconds, then disappears.
Service overdue
For a few seconds after the ignition is switched on, the spanner flashes to indicate that the ser vice must be carried out as soon as possible. Example: the service is overdue by 300 miles (km). For a few seconds after the ignition is switched on, the display indicates: