seats Citroen DS3 RHD 2013 1.G Owner's Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2013, Model line: DS3 RHD, Model: Citroen DS3 RHD 2013 1.GPages: 356, PDF Size: 10.28 MB
Page 147 of 356

145
Child safety
ISOFIX child seat recommended by CITROËN and approved for
your vehicle
This child seat can also be used on seats which are not fitted with ISOFIX mountings.
In this case, it must be attached to the vehicle seat using the three point seat belt. Follow the instructions for fitting the child seat given in the seat manufacturer's installation guide.
ISOFIX child seat with TOP TETHER
RÖMERDuo Plus ISOFIX(size category B1 )
Group 1: from 9 to 18 kg
Installed only in the "forward-facing" position.
Is attached to the rings A , as well as the ring B, referred to as the TOP TETHER, using an upper strap.
Three seat body angles: sitting, reclining, lying.
Page 148 of 356

Installing ISOFIX
child seats
ISOFIX mountings.
In the case of the universal and semi-universal ISOFIX child seats, the child seat's ISOFIX size category, determined by a letter between Aand G , is
indicated on the child seat next to the ISOFIX logo.
IUF: seat suitable for the installation of an I sofix U niversal seat, "F
orward facing" and secured usingthe "TOP TETHER" upper strap. IL- SU:
seat suitable for the installation an I sofix S emi-U
niversal seat which is:
- "rear ward facing" fitted with a "Top Tether" upper strap or a stay,
- "forward facing" fitted with a stay,
- baby cot fitted with a "Top Tether" upper strap or a stay.
For the securing of the "Top Tether" upper strap, refer to the "ISOFIX Mountings" section.X: seat which is not suitable for the installation of an ISOFIX child seat or cot of the weight group
indicated.
Weight of the child and indicative age
Less than 10 kg(group 0)Up to 6 months approx
Less than 10 kg(group 0) Less than 13 kg (group 0+)Up to 1 year approx
From 9 to 18 kg (group 1)From 1 to 3 years approx
Type of ISOFIX child seatInfant car seat"rear facing""rear facing""for ward facing"
ISOFIX size categoryFGCDECDABB1
Universal and semi-universal ISOFIX child seats which can be installed on the outer rear seatsXXIL-SUXIL- SUIUFIL-SU
Remove and stow the head restraint before installing a child seat with abackrest on a passenger seat. Refit the head restraint once the child seat has been removed.
Page 157 of 356

Safety
Seat belts
Front seat belts
The front seat belts are fitted with apretensioning and force limiting system.
This system improves safety in the frontseats in the event of a front or side impact.
Dependin
g on the severity of the impact, thepretensioning system instantly tightens the seat
belts against the body of the occupants.
The pretensioning seat belts are active when
the i
gnition is on.
The force limiter reduces the pressure of the
seat belt on the chest of the occupant, so
improving their protection.Fastening
) Pull the strap, then inser t the tongue in thebuckle. )
Check that the seat belt is fastened correctly by pulling the strap.
Unfastening
)
Press the red button on the buckle. )
Guide the seat belt as it is reeled in.
Seat belt not fastened / unfastened warning lamp
When the ignition is switched on,
this warning lamp comes on in the
instrument panel, if the driver and/or
the front passenger has not fastened their seat belt.
From approximately 12 mph (20 km/h)this warning lamp flashes for two minutes
accompanied by an audible signal of increasingvolume. Once these two minutes have elapsed,
this warning lamp remains on until the driver
and/or the front passenger fastens their seat belt.