Citroen DS3 RHD 2015 1.G Owner's Manual

219
Interior lighting
Interior lamp (1 / W5W)
Detach the cover of the interior lamp 1 with a
t hin   screwdriver,   close   to   the   button,   to   access  
t

he   failed   bulb.
Map reading lamps (2 / W5W)
Detach the cover of the interior lamp 1.   To  a
ccess   the   failed   bulb,   detach   the   partition   for  
t

he   reading   lamp   2  
c
oncerned.
Boot lamp (W5W)
Detach the unit by pushing it rear wards.
Footwell and central storage
illumination (W5W)
Detach the unit for access to the bulb.
Practical information

Changing a fuse
Installing electrical
accessories
Your vehicle's electrical system is designed   to   operate   with   standard   or  
o

ptional
 e
quipment.
Before
  installing   other   electrical  
e

quipment   or   accessories   on   your  
v

ehicle,   contact   a   CITROËN   dealer   or   a  
q

ualified
 w
orkshop.
CITROËN will not accept responsibility
for
  the   cost   incurred   in   repairing   your  
v

ehicle   or   for   rectifying   malfunctions  
r

esulting   from   the   installation   of  
a

ccessories   not   supplied   and   not  
r

ecommended   by   CITROËN   and  
n

ot   installed   in   accordance   with   its  
in

structions, in particular when the
combined
  consumption   of   all   of   the  
a

dditional   equipment   connected  
e

xceeds
 1
0
 mil
liamperes.
The
 
extraction
 
tweezer
 
and
 
the
 
spare
 
fuse
 
s

torage
 
locations
 
are
 
on
 
the
 
back
 
of
 
the
 
d

ashboard
 
fuse
 
box
 
cover.
For
 
access
 
to
 
them:
F
 
o

pen
 
the
 
glove
 
box
 
lid,
F
 
u

nclip
 
the
 
fusebox
 
cover
 
by
 
pulling
 
on
 
the
 
si

de,
F
 
r

emove
 
the
 
cover
 
completely,
F
 
r

emove
 
the
 
tweezer.
Access to the tools
Before changing a fuse, the cause of the failure m ust   be   identified   and   rectified.
F
 
I
dentify   the   faulty   fuse   by   checking   the  
c

ondition   of   its   filament.
Changing a fuse
good Failed
F
 
U

se
 
the   special   tweezer   to   extract   the   fuse  
f

rom
  its   housing.
F

A

lways replace the faulty fuse with a fuse
of
 
the   same   rating.
F
 
C

heck   that   the   number   marked   on   the  
b

ox,
  the   rating   marked   on   the   fuse   and   the  
t

ables   below   all   agree.

221
dashboard fusebox
The fusebox is loacted inside the glove box.
Access to the fuses
F Refer  to   the   paragraph   "Access   to   the  t
o o ls".
Fuse tables
Fuse n° R ating Functions
FH36 5 ATrailer
  relay   unit.
FH37 -Not
  used.
FH38 20 AHi-Fi
  amplifier.
FH39 -Not
  used.
FH40 40 ATrailer
  relay   unit.
Fuse
n
° R

ating Functions
F1 15 ARear
  wiper.
F2 -Not
  used.
F3 5 AAirbags
  and   pretensioners   control   unit.
F4 10 AAir
  conditioning,   clutch   switch,   electrochromatic   mirror,  
p

article   filter   pump   (Diesel),   diagnostic   socket,   air flow  
sen

sor
 (
Diesel).
F5 30 AElectric
  windows   panel,   passenger's   electric   window  
c

ontrol,   front   electric   window   motor.
F6 30 ADriver's
  electric   window   motor.
F7 5 ACourtesy
  lamp.
Practical information

Fuse n°R ating Functions
F8 20 AMultifunction
  screen,   audio   system,   navigation   radio,   alarm  
c

ontrol   unit,   alarm   siren.
F9 30 A12
  V   socket,   portable   navigation   support   supply.
F10 15 ASteering
  wheel   controls.
F11 15 AIgnition,
  diagnostic   socket,   automatic   gearbox   control   unit.
F12 15 ARain
  /   brightness   sensor,   trailer   relay   unit.
F13 5 AMain
  stop   switch,   engine   relay   unit.
F14 15 AParking
  sensors   control   unit,   airbag   control   unit,   instrument  
p

anel,   digital   air   conditioning,   USB   Box,   Hi-Fi   amplifier.
F15 30 ALocking.
F16 -Not
  used.
F17 40 ARear
  screen   and   door   mirrors   demisting/defrosting.
SH -PARC
  shunt.

223
Engine compartment
fusebox
The fusebox is placed in the engine compartment   near   the   battery   (left-hand   side).Access to the fuses
F Unclip  the   cover.
F  C hange   the   fuse   (see   corresponding  
par

agraph).
F
 
W
hen   you   have   finished,   close   the   cover  
c

arefully   to   ensure   the   sealing   of   the  
f

usebox.
All
 
work
 
on
 
the
 
fuses
 
in
 
this
 
box,
 
l

ocated
 
on
 
the
 
battery,
 
must
 
be
 
carried
 
o

ut
 
by
 
a
 
CITROËN
 
dealer
 
or
 
a
 
qualified
 
w

orkshop.
Practical information

Fuse table
Fuse n°R ating Functions
F1 20 AEngine
  control   unit   supply,   cooling   fan   unit   control   relay,   multifunction   engine   control   main   relay,  
injection
  pump   (Diesel).
F2 15 AHorn.
F3 10 AFront
  /   rear   wash-wipe.
F4 20 ALED
  daytime   running   lamps.
F5 15 ADiesel
  heater   (Diesel),   particle   filter   additive   pump   (Diesel),   air   flow   sensor   (Diesel),   EGR   electrovalve   (Diesel),  
b

low-by   heater   and   electrovalves   (VTi).
F6 10 AABS/DSC
  control   unit,   secondary   stop   switch.
F7 10 AElectric
  power   steering,   automatic   gearbox.
F8 25 AStarter
  control.
F9 10 ASwitching
  and   protection   unit   (Diesel).
F10 30 AFuel
  heater   (Diesel),   blow-by   heater   (Diesel),   fuel   pump   (VTi),   injectors   and   ignition   coils   (petrol).
F11 40 AHeater
 b

lower.

225
Fuse n°R ating Functions
F12 30 AWindscreen
  wipers   slow   /   fast   speed.
F13 40 ABuilt-in
  systems   inter face   supply   (ignition   positive).
F14 30 AValvetronic
  supply   (VTi).
F15 10 ARight-hand
  main   beam   headlamps.
F16 10 ALeft-hand
  main   beam   headlamps.
F17 15 ALeft-hand
  dipped   beam   headlamps.
F18 15 ARight-hand
  dipped   beam   headlamps.
F19 15 AOxygen
  sensors   and   electrovalves   (VTi),   electrovalves  
(

Diesel),   EGR   electrovalve   (Diesel).
F20 10 APumps,
  electronic   thermostat   (VTi),   timimg   electrovalve  
(

THP),   water   in   fuel   sensor   (Diesel).
F21 5 AFan
  assembly   control   supply,   ABS/DSC,   turbo   pump   (THP).
Practical information

Table of maxi-fuses
Fuse n°R ating Functions
MF1* 60 AFan
  assembly.
MF2* 30 AABS
  /   DSC   pump.
MF3* 30 AABS
  /   DSC   electrovalves.
MF4* 60 ABuilt-in
  Systems   Inter face   (BSI)   supply.
MF5* 60 ABuilt-in
  Systems   Inter face   (BSI)   supply.
MF6* 30 AAdditional
  cooling   fan   unit   (THP).
MF7* 80 ADashboard
 f

usebox.
MF8* -Not
  used.
*
  
T

he   maxi-fuses   provide   additional   protection   for   the   electrical   systems.   All   work   on   the   maxi-fuses   must   be   carried   out   by   a   CITROËN   dealer   or  
a q

ualified   workshop.

227
BatteryProcedure for charging your battery when it is flat or for starting the engine using another battery.T he   battery   is   located   under   the   bonnet.
To
  gain   access   to   it:
F
 
o
pen   the   bonnet   using   the   interior   release  
l

ever,   then   the   exterior   safety   catch,
F

s
ecure the bonnet stay,
F
 
l
ift   the   plastic   cover   on   the   (+)   terminal.
Access to the batteryAfter refitting the battery by a CITROËN   dealer   or   a   qualified  
w

orkshop,   the   Stop   &   Start   system  
w

ill only be active after a continuous
period
  of   immobilisation   of   the   vehicle,  
a

  period   which   depends   on   the   climatic  
c

onditions   and   the   state   of   charge   of  
t

he   battery   (up   to   about   8   hours).
The presence of this label, in particular
with
 
the
 
Stop
 
&
 
Start
 
system,
 
indicates
 
t

he
 
use
 
of
 
a
 
12
 
V
 
lead-acid
 
battery
 
with
 
s

pecial
 t

echnology
 a

nd
 s

pecification;
 t

he
 
involvement
 
of
 
a
 
CITROËN
 
dealer
 
o

r
 
a
 
qualified
 
workshop
 
is
 
essential
 
w

hen
 
replacing
 
or
 
disconnecting
 
the
 
b

attery.
Failure
 
t

o
 
o

bserve
 
t

his
 
r

ecommendation
 
m

ay
 
cause
 
premature
 
wear
 
of
 
the
 
b

attery.
Practical information

When the battery on your vehicle is discharged, the   engine   can   be   started   using   a   slave   battery  
(

external   or   on   another   vehicle)   and   jump   leads.
Starting using another
battery
First check that the slave battery has a nominal voltage   of   12   V   and   a   capacity   at   least   equal   to  
t

hat   of   the   discharged   battery.
Do
  not   try   to   start   the   engine   by   connecting   a  
b

attery   charger.
Do
  not   disconnect   the   (+)   terminal   when   the  
e

ngine   is   running.
F
 
C
onnect   the   red   cable   to   the   positive  
t

erminal   (+)   of   the   flat   battery   A, then to the
positive
  terminal   (+)   of   the   slave   battery   B.
F
 
C
onnect   one   end   of   the   green   or   black  
c

able   to   the   negative   terminal   (-)   of   the  
s

lave battery B   (or   earth   point   on   the   other  
v

ehicle).
F
 
C
onnect  
t
he  
o
ther  
e
nd  
o
f  
t
he  
g
reen  
o
r  
b
lack  
c

able   to   the   negative   terminal   C
(or
  the   engine   mounting)   of   the   broken-
down
  vehicle. F
 
S
tart   the   engine   of   the   other   vehicle   and  
a

llow   it   to   run   for   a   few   minutes.
F
 
O
perate   the   starter   of   the   broken-down  
v

ehicle   and   let   the   engine   run.
 I

f   the   engine   does   not   start   immediately,  
s

witch   off   the   ignition   and   wait   a   few  
m

oments   before   trying   again.
F
 
W
ait   until   the   engine   returns   to   idle,   then  
d

isconnect   the   jump   leads   in   reverse   order.Some
  functions   are   not   available   if   the  
b

attery   is   not   sufficiently   charged.