boot Citroen DS4 2012 1.G Owner's Guide

) Lower the rear armrest.)
Pull the flap handle downwards. )
Lower the flap.
)
Load the objects from inside the boot.










Ski fl ap
Arrangement for storing and transporting longobjects.


Opening
)Lower the rear armrest for a morecomfortable position.
This also gives access to the ski flap.





Rear armrest Comfor t system for the rear passengers.

155
Fittings
1.Rear parcel shelf
(see details on a following page)2.Hooks
(see details on a following page)
3.12 V accessory socket (see details on a following page)4. Torch
(see details on following pages)
5.Lashing rings
6.Storage box (see details on following pages)
7.Retaining strap8.Storage net

















Boot fi ttings

To remove the shelf: )unhook the two cords, )raise the shelf slightly, then remove it.
There are several options for storing the shelf:
- either upright behind the front seats,
- or flat at the base of the boot.
Rear parcel shelf
The hooks can be used to secure shoppingbags.
Hooks


Access to the storage box

An additional hook under the shelf is used to hold up the boot floor using its cord, to facilitate access to the tools and spare wheel or the temporarypuncture repair kit...

157
Fittings
)To connect a 12 V accessory(max power: 120 W), remove the cap andconnect an appropriate adaptor. )Turn the key to the ignition on position.
12 V acc essory socket
This is a removable lamp, fitted in the boot
wall, which can be used to light the boot or as
a torch.
For the boot lamp function, refer to the
"Visibility - § Boot lamp" section.
Torch


Operation

This torch operates with NiMH type
rechargeable batteries.
It has a batter
y life of approximately 45 minutes
and charges while you are driving.
Observe the polarities when fitting therechargeable batteries. Never replace the rechargeable batterieswith normal disposable batteries.

Use
)Extract the torch from its location pulling it upwards.)Press the switch, located on the back,
to switch the torch on or off. )Unfold the suppor t, located on the back,
to set down and raise the torch; for
example, when changing a wheel.



Storing
)
Put the torch back in place in its locationstarting with the lower part.
If you have forgotten to switch off the torch,
this switches it off automatically.
Storage box
)Raise the boot carpet for access to
the storage box.
This has areas for the storage a box of spare
bulbs, a first aid kit, two warning triangles...
It also contains the vehicle tools, the temporarypuncture repair kit...
It the torch is not engaged correctly, it may not charge and may not come onwhen the boot is opened.

In the event of the electric parking brakemalfunctioning or the battery running flat, anemergency manual device can release theparking brake.)Immobilise the vehicle (or keep it
stationary, if the brake pedal is pressed),
with the engine running, by engagingfirst gear (manual gearbox), position P(automatic gearbox) or position M or R(6 -speed electronic gearbox system).
Emergency release
)
Switch off the engine but leave the ignition on. If it is not possible to immobilise the
vehicle, do not operate the control andcontact a CITROËN dealer or a qualified
workshop without delay.) Fetch the two vehicle blocks B
and the
release device C, located under the boot carpet.
)Immobilise the vehicle by placing the blocks
in front or behind the two front wheels,
opposite to the direction of the slope.)Remove the storage box under the bootcarpet for access to the emergency releasedevice.

Driving
)Pierce the protective cover Don the tube Ewith the release device. )Place the release device in the tube.)Turn the release device clockwise.For
safety reasons, it is essentialto continue
turning the device until it reaches its stop.
The parking brake is released. )Remove the release device and store it
with the blocks in the toolbox under theboot carpet.


For safety reasons, after this operationit is essential to contact a CITROËN dealer or a qualified workshop without delay to replace the protective cover.
Following an emergency unlocking,immobilisation of the vehicle is nolonger assured once the manual emergency release has been deployed
and the manual control does not allowthe re-application of your parkingbrake.
Take no action, either on the control lever A, or stopping starting the engine while the release device is engaged.
Take care not to allow moisture or dust in the proximity of the protective cover. - The operation o
f the parking brake reinitialises when the ignition is switched
off then on again. If the reinitialisation
of the parking brake proves impossible, contact a CITROËN dealer or a qualified
workshop.
- The subsequent time required for
app
lication may be longer than during
normal operation.

Temporary puncture repair kit
and a sealant car tridge which permits
temporary repair of a tyre so that you can rdrive to the nearest garage.
It is designed to repair most punctures which
could affect the tyre, located on the tyre tread or shoulder.

Access to the kit


The speed limit sticker Imust be affixed to the vehicle's steering wheel to remind you that a wheel is in temporaryuse.
Do not exceed a speed of 50 mph(80 km/h) when driving with a tyre repaired using this type of kit.


Description of the kit
A.
"Sealant" or "Air" position selector.
B. On "I"/off "O"
switch. C.
Deflation button. D.Pressure gauge (in bar or p.s.i.).
E.Compartment housing:


- a cable with adaptor for 12 V socket,

- various in
flation adaptors for
accessories, such as balls, bicycle
tyres...F
.Sealant cartridge.G. White pipe with cap for repair.
H. Black pipe for inflation.I.
Speed limit sticker.
This kit is installed in the stora
ge box, under the boot floor.

251Practical information














Changing a wheel
Procedure for changing a faulty wheel for the spare wheel using the tools provided with the vehicle.

The tools are installed in the boot under the floor.
To gain access to them: )open the boot, )raise the floor,)secure it by hooking its cord on the hook
on the rear shelf suppor t,
)with a standard size spare wheel, unclip and remove the box in the middle of the
wheel containing the tools,

or )with a "space-saver" spare wheel; lift the
wheel at the rear towards you for access
to the storage box containing the tools.

Access to the tools
List of tools

All of these tools are specific to your vehicle. Do not use them for other purposes.

Wheel with trim
When removing the wheel, detach thetrim first using the wheelbrace 1pulling at the valve passage hole.When refitting the wheel
, refit the trim starting by placing its notch facing the valve and press around its edge withthe palm of your hand.
3."Bolt cover" tool.
For removing the bolt protectors (covers)on alloy wheels.4.Socket for the security bolts (located in theglove box).
For adapting the wheelbrace to the special"security" bolts. 1
.Wheelbrace.
For removing the wheel trim and the wheel
fixing bolts.
2. Jack with integral handle.For raising the vehicle.

The spare wheel is installed in the boot under
the floor.Depending on version, the spare wheel may bea standard size steel or alloy wheel, or for some countries it is the "space saver" type.
For access to the spare wheel, refer to theparagraph "Access to the tools" on the previouspage.
Access to the spare wheel
Tyre under-infl ation detection
The spare wheel is not fitted with asensor. The punctured wheel mustbe repaired by a CITROËN dealer or aqualified workshop.



Ta k i ng out the standard wheel
)Unscrew the yellow central bolt. )Raise the spare wheel towards you from
the rear.)Take the wheel out of the boot.