ESP Citroen DS5 HYBRID 2016 1.G Repair Manual

Moving off


For more information on the
electric parking brake, refer to the
corresponding section in the handbook
for the vehicle.

You can change the operating mode of the
Hybrid4 system at any time using its mode
selector.
Driving in ZEV
mode requires that particular
conditions be met.

When your vehicle vehicle moves off
in electric mode, it makes no noise. Be
very careful of pedestrians, cyclists...
as, because of this, they will not hear
you coming.

Head-up display

The colour of the speedometer varies
according to the drive train used:


- white display: Diesel engine
running,

- blue display: Diesel engine
stopped.

Using automatic mode with the
electronic gearbox optimises gear
changes and so gives more economical
driving.


)
If automatic operation of the electric
parking brake has been deactivated, pull
then release the control lever to release the
parking brake manually.

)
Progressively release the brake pedal.

)
With the parking brake released, the
vehicle then moves off.
If the parking brake is still applied and is in
automatic mode, accelerate progressively.

)
Move the gear selector to
position A
(automatic mode) or M
(manual
mode) or R
(reverse).

19Hybrid4 system

















Mode selector


The selector allows the driver to select one of the four operating modes offered by the Hybrid4
system.


)
Turn the dial to the right or left; the mode selected is confirmed by illumination of the
corresponding indicator lamp.



ZEV
mode: for 100% electric running.

SPORT
mode: to make use of the maximum
per formance of the vehicle.


4WD
mode: to force 4x4 drive in conditions of
poor grip.


AUTO
mode: for everyday use and optimised
fuel consumption.
By default, the selector is in the AUTO
position when starting the Hybrid4 system, whatever
position it was in when the ignition was switched off.


AUTO mode


This mode is designed to optimise the vehicle's
fuel consumption by managing the alternate
or simultaneous operation of the two motors
according to the conditions and driving style.
When conditions allow, an adequate battery
state of charge and moderate acceleration, the
alternator-starter motor stops the HDi Diesel
engine to provide 100% electric running.

ZEV mode
(all electric)

Zero emissions vehicle operation is assured
100 % by electric drive.
This mode allows silent and clean running
at
moderate speeds.

It can be activated when the
conditions allow, particularly
if the state of charge of high
voltage battery is sufficient (from
4 bars).
In AUTO
mode, the electric motor
:


- can power the vehicle on its own in "zero
emissions" electric running, depending
on the state of charge of the battery, if the
conditions specific to the vehicle are met
and if acceleration is moderate,

- supplements the HDi Diesel
engine
when moving off and changing
gear, during acceleration or when traction
from the front wheels is inadequate,
temporarily providing 4-wheel drive.
The electric motor can operate only at speeds
below 52 mph (85 km/h). It is no longer active
above 75 mph (120 km/h).
Refer to the special conditions for operation of
ZEV
mode.

For more information on the special
conditions for the operation of ZEV

mode, refer to the corresponding
section.

If the conditions do not allow ZEV
mode to be
selected or maintained, the message " Electric
mode is not currently available
" appears in
the screen. The ZEV
indicator lamp flashes for
a few seconds then goes off and the indicator
lamp in the AUTO
position comes on.
In ZEV
mode:


- range and acceleration capacity are
limited; the maximum speed is around
36 mph (60 km/h),

- under high load or a priority requirement
causing the start of the HDi Diesel engine,
the system changes automatically to AUTO

mode.

21Hybrid4 system

This mode will be even more effective if
the vehicle is fitted with suitable tyres,
such as winter tyres.



SPORT mode
(Diesel and
electric)
4WD mode
(4 - wheel drive)

This mode allows more dynamic driving by
providing additional performance
.
By using the capacity of the electric motor
to supplement the power of the HDi Diesel
engine, the vehicle's full power is used for
acceleration and pick-up.
This mode manages the response of the
accelerator, the electronic gearbox and the use
of the electric motor.
In SPORT
mode:


- the electric motor as an addition is
available up to 75 mph (120 km/h).


This "4-wheel drive" mode provides additional
traction
at low speed by driving all four wheels
of the vehicle simultaneously: the HDi Diesel
engine (front wheel drive) and the electric
motor (rear wheel drive) operate simultaneously
and permanently.
Their coupling is managed electronically to
optimise traction when grip is poor.
In 4WD
mode:


- the HDi Diesel engine operates
continuously; if necessary, it supplies
energy for the electric motor,

- the additional traction from the electric
motor is available up to 75 mph (120 km/h).

This mode should be used on snow
covered roads or difficult ground (mud,
sand, ...), as well as for crossing a ford,
at moderate speed.
In this mode, in severe conditions
and if the circumstances allow, it is
recommended that you accelerate
strongly to facilitate moving off and
making progress and so reduce the risk
of getting stuck.

This mode is available whatever:


- the state of charge of the high
voltage battery,

- the altitude.

Eco-driving

Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel
consumption and CO
2 emissions.

Adapted to your Hybrid4 vehicle


Use gear selector position A
, as this optimises gear changes to suit the circumstances, and
the AUTO
mode of the Hybrid4 mode selector.
When moving off, accelerate normally up to the desired speed ( POWER
zone between 20
and 40 %).
At steady speeds, drive gently with small movements of the accelerator pedal ( ECO
or
CHARGE
zone), to allow running in electric mode when driving at low speed.
Anticipate the need to slow down and use engine braking ( CHARGE
zone), so as to make
use of the recovery of "free" energy, while maintaining light pressure on the accelerator
pedal.

For information on other eco-driving practices, refer to the corresponding section of the
handbook for the vehicle.

37Practical information










Temporary puncture repair kit


This kit comprises a compressor and a sealant cartridge.
It allows you to carry out a temporary repair
to a tyre.
This makes it possible to continue to the nearest garage.

It can be used for for repairing most
punctures on the tread or shoulder of
the tyre.
The compressor can be used to check
and adjust a tyre pressure.

For more information on the use of this
temporary puncture repair kit, refer
to the corresponding section in the
handbook for the vehicle.

All of these tools are specific to your
vehicle.
Do not use them for other purposes.



Access to the kit














List of tools



1.
12 V compressor.
Contains a sealant cartridge for the
temporary repair of a tyre and can also be
used for adjusting tyre pressures.

2.
Chock.
For blocking the wheels of the vehicle.

3.
Wheel bolt cover remover.
For removing the wheel bolt head
protectors on alloy wheels.

4.
Wheel trim remover.
For removing the wheel bolt finishers on
alloy wheels.

5.
Removable towing eye.

This kit is installed in the storage box, under the
boot floor.

Recovery of the vehicle on a fl at-bed


Never recover the vehicle by towing it with two or four wheels on the ground, as there is a risk of
damage to the transmission.
However, if necessary because access to the vehicle is difficult, the vehicle can be moved a few
dozen metres, at a speed of less than 6 mph (10 km/h).

Use the towing eye only
to pull the vehicle out
or to lash it for recovery on a flat-bed lorry or
trailer.

Before doing any work, with the ignition on, press the brake pedal and place the gear selector at
position N
, then switch off the Hybrid4 system ( READY
lamp off).
Always call on professionals for recovery of the vehicle on a flat-bed lorry or trailer.









Snow chains


Recommendations


The use of snow chains is only authorised on
the front wheels.
The mode selector must be in the
4WD
position.

For information on the sizes
compatible with the tyres on your
vehicle and advice on use, refer to the
corresponding section in the handbook
for the vehicle.

39Te c h n i c a l d a t a

Electric motor



-


Te c h n o l o g y
Synchronous with permanent magnets
Max. power: EU standard (kW) *
27
Max. power speed (rpm)
2 000 to 7 500
Max. torque: EU standard (Nm)
200
Max. torque speed (rpm)
800 to 1 290
Efficiency (%)

80 to 90

High voltage batter y


Ni-MH

(Nickel Metal Hydride)
Voltage (V~)

200
Energy capacity (kWh / Ah)
1.1 / 5.5
Range (miles (km))
1.2 (2) (approximately)


















Electric motor and battery


Range varies according to the ambient climatic conditions, the driving style and conditions, the use of vehicle systems and ageing of the battery.

*
The maximum power corresponds to the value type approved on a test bed, under conditions defined by European legislation (directive 1999/99/EC).

Diesel engine and gearbox



Diesel engine



HDi 160



Gearbox


ETG6 electronic

(6- speed)


Cubic capacity (cc)

1 997
Bore x stroke (mm)

85 x 88
Max power: EU standard (kW) *
120
Max power engine speed (rpm)
3 850
Max torque: EU standard (Nm)
300
Max torque engine speed (rpm)
1 750
Fuel

Diesel
Catalytic conver ter

Ye s
Particle filter

Ye s
Engine oil capacity with filter replacement
(in litres)
5.0

*
The maximum power corresponds to the type approved value on a test bed, under conditions defined by European legislation
(directive 1999/99/EC).

4Dconcept
Diadeis
Interak
08-15
Labels are fi tted in various areas of your vehicle. They
carry safety warnings as well as vehicle identifi cation
information. Do not remove them: they form an integral part
of your vehicle.

Automobiles CITROËN declares, by application of the
provisions of the European regulation (Directive 2000/53)
relating to End of Life Vehicles, that it achieves the
objectives set by this regulation and that recycled materials
are used in the manufacture of the products that it sells.
Printed in the EU
Anglais
For any work on your vehicle, use a qualifi ed workshop
that has the technical information, competence and
equipment required, which a CITROËN dealer is able to
provide.


Reproduction or translation of all or part of this document
is prohibited without written authorisation from Automobiles
CITROËN.

We draw your attention to the following points:


- The fi tting of electrical equipment or accessories not
listed by CITROËN may cause faults and failures
with the electrical system of your vehicle. Contact
a CITROËN dealer for information on the range of
recommended accessories.

- As a safety measure, access to the diagnostic socket,
used for the vehicle's electronic systems, is reserved
strictly for CITROËN dealers or qualifi ed workshops,
equipped with the special diagnostic tool required (risk
of malfunctions of the vehicle's electronic systems that
could cause breakdowns or serious accidents). The
manufacturer cannot be held responsible if this advice is
not followed.

- Any modifi cation or adaptation not intended or
authorised by Automobiles CITROËN or carried out
without meeting the technical requirements defi ned by
the manufacturer would lead to the suspension of the
legal and contractual warranties.