ignition Citroen DS5 HYBRID4 RHD 2011.5 1.G Owner's Manual

21Familiarisation
Monitoring
On switching on, the dial needles go to
the extent of their travel then return to 0.
A.With the ignition on, the bars indicate the
fuel remaining.

Instrument panel
1.
With the ignition on, the orange and redwarning lamps come on. 2.With the hybrid system active, these
warning lamps should go off.
If a warning lamp remains on, refer to thecorresponding page.


Warning lamps
55
B.
With the ignition on, the instrument panelscreen should indicate the oil level.
If the levels are not correct, top up the level which is low.
54

23Familiarisation

If this warning lamp comes on in
the instrument panel, automatic application/release is deactivated
.
The parking brake must be appliedand released manually. y
Before leaving the vehicle, check
that the the brake warning lamp and
the P warning lamp in the controllever A
are on fixed (not flashing).
120


If towing a trailer or caravan or if theslope might vary (transpor t by boat or lorry, recovery of the vehicle...) make a maximum application of the parking brake - by making a long pull on the
control lever A
- to immobilise thevehicle.

Driving safely


Electric parking brake


Manual Application/Release
Manual application
of the parking brake is possible by pulling
the control lever A. With the ignition on, manual releaseof theparking brake is possible by pressing the brake pedal
and pulling
then releasing
the control lever A
.


If an audible signal is heard on opening the driver's door with the hybrid system active, apply the parking brake
manually. Do not leave a child alone in the vehicle with the ignition on; they might release the parking brake.
Automatic Application/Release
Press the accelerator pedal, the parking brakeis released automatically and progressively as you move off.With the vehicle stationary, the parking brakeis applied automatically on switching off theignition (Readylamp off).

Stopping your vehicle and the hybrid system
When your vehicle vehicle moves off in electric mode,it makes no noise. Be verycareful of pedestrians as they will not hear you coming.
- Apply the brake until the vehicle comes to a complete stop.
- Place the gear lever in position N.- Place the electronic key inside the vehicle, then press the START/STOPswitch; the parking
brake is applied automatically if configured to do so.
- Otherwise apply the parking brake manually, the P
warning lamp must be on.



When stationary, switch off the ignition and check that the Readylamp is off beforeleaving the vehicle. Otherwise the hybrid system will still be active. See the section on"Underbonnet precautions/warnings".

33Hybrid system











Anti-theft protection
Electronic engine immobiliser
The keys contain an electronic chip which hasa secret code. When the ignition is switchedon, this code must be recognised in order for
star ting to be possible.
This electronic en
gine immobiliser locks the
engine management system a few minutes after the ignition is switched off and prevents
starting of the engine by anyone who does not have the key.
In the event of a malfunction, you are informed by a message in the instrument panel screen.In this case, your vehicle does not start; contacta CITROËN dealer as soon as possible.
Ignition on without starting
the engine
(accessory position)

With the electronic key in the reader or the
Keyless Entry and Star ting key inside the
vehicle, pressing the "START/STOP" button,
with no action on the pedals, allows the ignition
to be switched on and so activate the ancillary equipment.
)
Press the "START/STOP" button,
the instrument panel comes on but the engine does not star t.) Press the button again to switch
off the ignition and so allow the
vehicle to be locked.
Using the ancillaries for a long period introduces the risk of a flat battery.

43Hybrid system








ECO OFF switch


This function prevents the Diesel engine
being switched off and so ensures that a comfor table temperature can be maintained in
the passenger compar tment (air conditioning
running continuously).
On pressing the switch, the engine restar ts
immediately.
To return to normal operation, press the switch
a
gain.
After switching off the ignition, the vehicle
will return to normal operation (lamp in
the switch off).

49Hybrid system

The high voltage battery must not in anycircumstances be charged from an externalsource and must only be handled by a
workshop technician.
There is the risk o
f serious burns, as well as electric arcs that could cause serious injury or
even death.
A used Ni-MH (Nickel Metal Hydride) type
high voltage battery must be removed in an
appropriate manner by a repair workshop,so that its recycling presents no risk to the environment.

High voltage


The voltage used for the operation of theelectric motor is in the range 150 to 270 Volts.
Be sure to take account of the warning labels
fitted to the vehicle.
Ta k e great care regarding the high voltage and high temperatures of components carrying thecurrent.
Emergency cut-off
In the event of an accident, a cut-off system
blocks the high voltage current and cuts off
the fuel pump; your vehicle can no longer be started.To restar t the hybrid system, contact aCITROËN dealer.
Hi
gh voltage cables are routed under the
vehicle (sills); ensure that the vehicle is not
used for off-road activity (such as coveringrough ground) which could damage them.
Be
fore doing any work on the vehicle, switch off the ignition (Readylamp off).



Battery precautions

Hi
gh voltage cables
Take care to position lifting equipment (jack, hoist, ...) at the locations provided to avoid damaging the cables.

Never touch, dismantle, remove or replace the high voltage par ts, cables (orange in colour) or connectors, even in the event of an accident.

Underbonnet precautions/warnings
The alternator-star ter motor of your hybrid
vehicle is also supplied at high voltage. If the
vehicle ignition has not been switched off, there
is a risk of the engine restar ting at any time.
Alwa
ys ensure that theignition is switched off ( Readylamp off) before
opening the bonnet.
Also ensure that the ignition is switchedoff when refuelling to avoid the enginerestarting.

51Hybrid system








Vehicle recovery


Before doing any work, with the ignition on,press the brake pedal and put the gear lever in position N, then switch off the hybrid system.
Use the towing eyes only to pull a vehicle out or
to pull it onto a flat-bed.
If necessary because access to the vehicle is
difficult, it can be moved a few dozen metres ata speed not exceeding 6 mph (10 km/h).
The front or rear wheels must not be on the ground, use a flat-bed lorry or trailer to recover the vehicle.

Monitoring
Indicator and warning lamps
When the engine is star ted, these same warning lamps should go off.
If they remain on, before moving off, refer to
the information on the warning lamp concerned.
Associated warnings
The switching on of cer tain warning lamps
may be accompanied by an audible signal and
a message in the instrument panel screen.
The warning lamps may come on continuously (fixed) or flash.

Certain warning lamps may come on inone of two modes: fixed (continuous) or flashing.
Only by relating the type of illumination to the operation of the vehicle can itbe determined whether the situation is normal or a fault has occurred.
Refer to the tables on the following pages for more information. Visual indicators in
forming the driver that
a system is in operation, switched off or has a fault.
When the ignition is switched on
Certain warning lamps come on for a few seconds in the instrument panel and/or
instrument panel screen when the vehicle's
ignition is switched on.

57
Monitoring



Rear foglamps

fixed. The rear foglamps are switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamps.
Warning/indicator lampStateCauseAction/Observations



Diesel engine pre-heating fixed. The STA R T/STOP
switch has been pressed (ignition on). Wait until the warning lamp goes off before star ting.
The period of illumination of the warning lamp is
determined by the ambient conditions (up to about
thirty seconds in extreme conditions).
If the engine does not star t, switch the ignition off and
then on, wait until the warning lamp goes off again,
then start the engine.

Electric parking brake
fixed. The electric parking brake is applied. Release the electric parking brake to switch off the
warning lamp: with your foot on the brake pedal, pull
the electric brake control lever.
Obser ve the safety recommendations.
For more information on the electric parking brake,
refer to the "Driving" section.

Deactivation of the automatic functions of the electric parkingbrake


fixed. The "automatic application" (on switching off the engine) and
"automatic release" functions aredeactivated or faulty.
Activate the function (according to country) via the
vehicle configuration menu or contact a CITROËN
dealer or a qualified workshop if automatic application/
re
lease is not possible.
The parking brake can be released manually usingthe emergency release procedure.
For more in
formation on the electric parking brake,
refer to the "Driving" section.