open bonnet Citroen DS5 HYBRID4 RHD 2011.5 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2011.5, Model line: DS5 HYBRID4 RHD, Model: Citroen DS5 HYBRID4 RHD 2011.5 1.GPages: 358, PDF Size: 10.77 MB
Page 7 of 358

CHECKS PR ACTICAL
INFORMATIONTECHNICAL
DATAAUDIO AND
TELEMATICS
194 Te m p o r a ry puncture repair
kit
200 Changing a wheel
207 Changing a bulb
215Changing a fuse
218 12 V battery
221Energy economy mode
222Changing a wiper blade
222Recovering the vehicle
224Vehic le recovery
224Towing a trailer
226 Fitting roof bars
227 Accessories
233Opening the bonnet
234 Diesel engine
235 Running out of fuel (Diesel)
236 Checking levels
239Checks
244Electric motor
245Diesel engine
246 Diesel weights
247Dimensions
248 Identifi cation markings
252Emergency or assistance
255 eMyWay
309 Audio system
008008009009010010011011
Page 52 of 358

Underbonnet precautions/warnings
The alternator-star ter motor of your hybrid
vehicle is also supplied at high voltage. If the
vehicle ignition has not been switched off, there
is a risk of the engine restar ting at any time.
Alwa
ys ensure that theignition is switched off ( Readylamp off) before
opening the bonnet.
Also ensure that the ignition is switchedoff when refuelling to avoid the enginerestarting.
Page 85 of 358

OFF
83Access
System which protects and provides a deterrent
against theft and break-ins. It provides the
following types of monitoring:
Alarm
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open adoor, the boot or the bonnet...
- Interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.
- Tilt
The system checks for any change in
the attitude of the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or knocked.
Self-protection function
The system checks for the putting out of ser vice of its components. The alarm is triggered if the battery,the button or the wires of the siren areput out of ser vice or damaged.
For all work on the alarm system, contact a CITROËN dealer or aqualified workshop.
Locking the vehicle with full
alarm system
Activation
)Switch off the ignition and get out of the vehicle.
)
Press the locking button on the
r
emote control or lock the vehicleusing the Keyless Entry and Starting system. The monitoring system is active: the indicator
lam
p in the button flashes once per second.
After the locking button on the remote control
is pressed or the vehicle locked using the
Keyless Entry and Star ting system, the exterior
perimeter monitoring is activated after a delay of 5 seconds, the interior volumetric monitoring after 45 seconds and the anti-tilt after one
minute and 30 seconds.
If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior
perimeter monitoring will be activated after a
delay of 45 seconds.
) Press the unlocking button on
the remote control or unlock the
vehicle using the Keyless Entryand Star ting system.
Deactivation of the volumetric monitoring
The volumetric protection system is deactivated: the indicator lamp in the button goes off.
Page 220 of 358

12 V battery Procedure for charging your battery when it is flat or for starting the engine using another battery.
The presence of this label indicatesthe use of a 12 V lead-acid battery withspecial technology and specification, for which the involvement of a CITROËN dealer or qualified workshop is requiredwhen replacing or disconnecting thebattery.
Failure to observe this recommendation may cause premature wear of thebattery. The battery is located under the bonnet.
To
gain access to it: )
open the bonnet using the interior releaselever, then the exterior safety catch, )
remove the plastic cover to gain access to
the two terminals, ) unclip the fusebox to remove the battery,
if necessary.
Access to the battery
)Raise the locking tab fully.
Disconnecting the cables
Reconnectin
g the cables
)Position the open clip 1of the cable on the
positive terminal (+) of the battery. )Press ver tically on the clip 1
to position it correctly against the battery. )Lock the clip by spreading the positioning lug and then lowering the tab 2.
Do not force the tab as locking will not be possible if the clip is not positionedcorrectly; star t the procedure again.
Before doing any work on your vehicle,switch off the ignition ( Ready
lamp off)to avoid any risk of injury resulting fromautomatic operation of the engine. Y
our vehicle is fitted with a conventional 12 Vbattery, located under the bonnet, in addition
to the high voltage battery used by the hybrid
system.
In cer tain conditions, if the 12 V batter
y is
too discharged to activate the hybrid system, recharging from another conventional 12 V
battery is possible.
Do not carry out this recharge if the Readylamp is on.