engine Citroen NEMO 2011 1.G Workshop Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2011, Model line: NEMO, Model: Citroen NEMO 2011 1.GPages: 180, PDF Size: 9.06 MB
Page 166 of 180

 164
Checks
 
CHECKS 
 
 
Bleeding water from 
the Diesel filter 
   
If this warning lamp comes 
on, you must bleed the filter; 
otherwise bleed the filter 
regularly, every time the engine is 
changed. 
  To remove the water, unscrew the bleed 
screw or the water in Diesel sensor, located 
at the base of the filter. Operate until all of 
the water has flowed out. Then tighten the 
bleed screw or the water sensor. 
  HDi engines use advanced technology. All 
work requires specialist knowledge, which 
all CITROËN dealers have.  
 
 
Battery 
 
At the start of winter, have your battery 
checked by a CITROËN dealer or a qualified 
workshop.  
 
 
Air filter and passenger compartment 
filter 
  A blocked passenger compartment filter 
may reduce the performance of the 
air conditioning system and generate 
undesirable odours. The replacement 
intervals for these components are indicated 
in the servicing booklet. 
  Depending on the environment (dusty 
atmosphere...) and the use of the vehicle 
(urban driving...), change them twice as 
often if necessary, refer to the "Under the 
bonnet" section of chapter 7.  
 
 
Brake pads 
 
Brake pad wear depends on the style of 
driving, in particular for vehicles which are 
used in town, over short distances. It may 
be necessary to check the brake pad wear, 
even between services. 
  Unless there is a leak on the system, a drop 
in the brake fluid level indicates that the 
brake pads are worn.  
 
 
Brake disc/drum wear 
 
For all information on checking the brake 
disc/drum wear, contact a CITROËN dealer 
or a qualified workshop.  
 
 
Parking brake 
 
Where the parking brake travel is too great 
or there is a reduction in the performance 
of the system, the parking brake should be 
adjusted, even between services. 
  Have the system checked by a CITROËN 
dealer or a qualified workshop.  
 
 
Oil filter 
 
Change the filter regularly, in accordance 
with the servicing schedule.      
 
 
 
 
 
The presence of this label, in particular with 
the Stop & Start system, indicates the use 
of a specific 12 V lead-acid battery with 
special technology and specification, for 
which the involvement of a CITROËN dealer 
or a qualified workshop is required when 
replacing or disconnecting the battery.  
Failure to observe this recommendation may 
shorten the life of the battery.   
Page 167 of 180

 165
7
QUICK HELP
 
 
 
Checks  
 
 
 
 
 
 
 
 
Manual gearbox 
 
The gearbox does not require any 
maintenance (no oil change). 
  Refer to the Warranty and Maintenance 
Record for the details of the level checking 
interval for this component.  
  To check the main levels and certain 
components, in accordance with the 
manufacturer's servicing schedule, refer to 
the pages of the servicing booklet which 
correspond to your vehicle's engine. 
  Only use products recommended by 
CITROËN or products of equivalent quality 
and specification. 
  In order to optimise the operation of units as 
important as the braking system, CITROËN 
selects and offers specific products. 
  In order to avoid damaging the electrical 
units, high pressure washing to clean the 
engine compartment is strictly prohibited. 
   
 
 
 
 
 
Particle filter system (1.3 HDi 75) 
 
An addition to the catalytic converter, this 
filter makes an active contribution to the 
preservation of air quality by the retaining 
of the unburnt pollutant particles. Black 
exhaust fumes are thus no longer emitted. 
  This filter, fitted to the exhaust system, 
accumulates particles of soot. The engine 
control unit manages the automatic 
periodic elimination of the soot particles 
(regeneration). 
  the regeneration procedure is invoked 
according to the quantity of particles 
accumulated and the driving conditions 
of the vehicle. During this phase, you 
may notice some unusual phenomena - 
increased idling speed, cooling fan running, 
increase in smoke and higher exhaust gas 
temperature - which does not affect the 
operation of the vehicle or the environment. 
  After prolonged idling or driving at very low 
speeds, you may occasionally notice water 
vapour being emitted from the exhaust when 
accelerating. This is of no consequence 
to the running of the vehicle or to the 
environment.    
Saturation/Regeneration 
  If there is risk of blockage of the 
filter, this warning lamp comes on 
in the instrument panel. 
  This alert tells you that the 
particle filter is starting to fill up (in 
conditions of urban driving of exceptionally 
long duration: low speeds, traffic jams etc.) 
  To regenerate the filter, it is advised to drive 
as soon as possible, when traffic conditions 
and the law permit, at a speed of at least 
40 mph (around 60 km/h), with an engine 
speed above 2 000 rpm for about fifteen 
minutes (until the warning lamp and/or the 
message disappears). 
  if possible, avoid switching off the engine 
before the end of regeneration of the 
filter; repeated interruptions could cause 
premature deterioration of the engine oil. 
It is not recommended to end regeneration 
of the filter with the vehicle stationary.  
   
Operating fault 
  If this alert persists, do not ignore the 
warning; it indicates that a fault has occurred 
in the exhaust/particle filter system. 
  Have it checked by a CITROËN dealer or a 
qualified workshop.  
 
 
 
 
 
 
 
 
Electronic gearbox 
 
The gearbox does not require any 
maintenance (no oil change). 
  Refer to the servicing booklet for details of 
the checking interval for this component.  
  Because of the higher exhaust 
gas temperature resulting from the 
normal operation of the particle filter, it is 
recommended that you do not park the 
vehicle over inflammable materials (grass, 
dry leaves, pine needles,...) so as to avoid 
any risk of fire.  
Page 176 of 180

 174
 
Technical data - Maintenance 
   
Screenwash ................................... 163      
Bulbs, lighting, 
changing bulbs ....................143-147  
   
Opening the bonnet ....................... 159 
  Under the bonnet ....................160-161  
   
Identifi cation markings, 
serial number, 
paint, tyres .................................. 155     
Changing a wiper blade ................. 148  
   
Engine technical data .................64-65 
  Dimensions .......... 58-59, 60-61, 62-63 
  Weights ............................................ 66  
 
TECHNICAL DATA - MAINTENANCE 
 
 
Levels .....................................162-163 
   
 
● 
 dipstick, 
   
● 
 power steering fluid, 
   
● 
 brake  fluid, 
   
● 
 coolant, 
   
● 
 screenwash.  
 
   
Checks....................................164-165 
   
 
● 
 battery, 
   
● 
 air/passenger compartment filter, 
   
● 
 oil  filter, 
   
● 
 particle  emissions fi lter (1.3 HDi 75), 
   
● 
 parking  brake, 
   
● 
 brake  pads.  
  Emission control .....................  29, 165      
Engine fuses ...................149, 152-153