SCR DACIA LODGY 2019 Owner's Guide

JauneNoir Noir texte
5.9
ENG_UD33465_1
Kit de gonflage des pneumatiques (X67 - X92 - Dacia)
ENG_NU_975-6_X92_Dacia_5
With the engine running and the
handbrake engaged:
– unroll the hose from the container;
– connect the compressor hose 13 to
the container inlet 18;
– depending on the vehicle, connect the container 18 to the compressor
from the container recess 17;
– unscrew the valve cap on the rel- evant wheel and screw on the con-
tainer’s inflation adapter 11;
– adapter 12 must be connected to
the vehicle accessories socket;
– press switch 14 to inflate the tyre to the recommended pressure (please
refer to the information on “Tyre
pressure”); – after a maximum of 15 minutes, stop
inflating and read the pressure (on
pressure gauge 15).
Note: while the container is empty-
ing (approximately 30 seconds), the
pressure gauge 15 will briefly indi-
cate a pressure of up to 6 bar. The
pressure will then drop.
– adjust the pressure: to increase it, continue inflation with the kit; to
reduce it, press button 16.
If a minimum pressure of 1.8 bar is
not reached after 15 minutes, repair
is not possible; do not drive the ve-
hicle but contact an approved dealer.
TYRE INFLATION KIT (5/6)
If the vehicle is parked on
the hard shoulder, you must
warn other road users of
your vehicle’s presence
with a warning triangle or with other
devices as per the legislation apply-
ing to the country you are in.
Before using this kit, park
the vehicle at a sufficient
distance from traffic, switch
on the hazard warning
lights, apply the handbrake, ask all
passengers to leave the vehicle and
keep them away from traffic.
Inflation kit D
Depending on the vehicle, in the event
of a puncture, use the kit D located in
the boot or underneath the boot carpet.
1112
13
14
15
17
18
D
16

JauneNoir Noir texte
5.10
ENG_UD33465_1
Kit de gonflage des pneumatiques (X67 - X92 - Dacia)
ENG_NU_975-6_X92_Dacia_5
Once the tyre is correctly inflated,
remove the kit: slowly unscrew the in-
flation adapter 11 to prevent any repair
product from escaping and store the
container in plastic packaging to pre-
vent the product from escaping.
– Affix the driving recommendation label to the dashboard where it can
easily be seen by the driver;
– Put the kit away.
– At the end of this initial inflation op- eration, air will still escape from the
tyre. You must drive a short distance
in order to seal the hole.
– Start immediately and drive at be- tween 12 and 40 mph (20 and
60 km/h) in order to distribute the
product evenly in the tyre and, after
driving for 2 miles (3 km), stop and
check the pressure.
– If the pressure is greater than 1.3 bar but less than the recommended
pressure (refer to the label affixed to
the edge of the driver’s door), read-
just it. Otherwise, please contact an
authorised dealer: the tyre cannot be
repaired.Precautions when using the
kit
The kit should not be operated for more
than 15 consecutive minutes.
TYRE INFLATION KIT (6/6)
Nothing should be placed
around the driver’s feet
as such objects may slide
under the pedals during
sudden braking manoeuvres and
obstruct their use.
Following repair with the kit,
do not travel further than
120 miles (200 km). In addi-
tion, reduce your speed and
under no circumstances exceed
48 mph (80 km/h). The sticker,
which you must affix in a prominent
position on the dashboard, reminds
you of this.
Depending on the country or local
legislation, a tyre repaired with the
inflation kit may need to be replaced.
Please be aware that a
poorly tightened or miss-
ing valve cap can make the
tyres less airtight and may
lead to pressure loss.
Always use valve caps identical to
those fitted originally and tighten
them fully.
11
D

JauneNoir Noir texte
5.20
ENG_UD26662_2
Feux arrière: remplacement des lampes (X92 - Renault)
ENG_NU_975-6_X92_Dacia_5
REAR AND SIDE LIGHTS: changing bulbs (2/3)
High-level brake light
– Remove the two plastic blanking
covers 6 from the inside.
– Unclip the light using a screwdriver, by releasing the metal clips from
their housings.
– Remove light from the outside. Replace the bulb without disconnect-
ing the wiring.
Bulb type 7: W16W.
Refitting
To return it, proceed in the reverse
order to removal.
Check the tabs are correctly locked in
position.
The bulbs are under pres-
sure and may break when
replaced.
Risk of injury.
7
6

JauneNoir Noir texte
5.21
ENG_UD26662_2
Feux arrière: remplacement des lampes (X92 - Renault)
ENG_NU_975-6_X92_Dacia_5
REAR AND SIDE LIGHTS: changing bulbs (3/3)
Number plate lights 9
Unclip light 9 by pressing tab 8 using a
flat-blade screwdriver or similar.
Remove the light cover to gain access
to the bulb.
Bulb type: W5W
98
Side indicator lights 10
Unclip the side mounted indicator
light 10 (using a flat-blade screwdriver
or similar).
Turn the bulb holder 11 a quarter of a
turn and take out the bulb.
Bulb type: W5W.
11
10
The bulbs are under pres-
sure and can break when
replaced.
Risk of injury.

JauneNoir Noir texte
5.22
ENG_UD24477_1
Eclaireurs intérieurs: remplacement des lampes (X92 - Renault)
ENG_NU_975-6_X92_Dacia_5
INTERIOR LIGHTING: changing bulbs (1/2)
Courtesy light
Unclip lens 1 using a flat-blade screw-
driver or similar. Remove the bulb.
Bulb type 2: W5W.
Rear courtesy light
Remove the lens 3 using a tool such as
a flat-blade screwdriver.
Release the bulb.
Bulb type: W5W.
123
The bulbs are under pres-
sure and may break when
replaced.
Risk of injury.

JauneNoir Noir texte
5.23
ENG_UD24477_1
Eclaireurs intérieurs: remplacement des lampes (X92 - Renault)
ENG_NU_975-6_X92_Dacia_5
INTERIOR LIGHTING: changing bulbs (2/2)
Luggage compartment light
Unclip the light 4 (using a tool such as a
flat-blade screwdriver). Press tab
5 to release the lens 7 and
access bulb 6.
Bulb type: W5W.
The bulbs are under pres-
sure and may break when
replaced.
Risk of injury.
567
4

JauneNoir Noir texte
5.27
ENG_UD33424_3
Fusibles (X92 - Renault)
ENG_NU_975-6_X92_Dacia_5
FUSES (4/4)
Number Allocation
A Electric rear window
B Electric door mirrors
C Front electric window
1 LPG
2 Left-hand main beam
headlight
3 Right-hand main beam
headlight
4 Left-hand dipped beam
headlight
5 Right-hand dipped beam
headlight
6 Left-hand side lights
7 Right-hand side lights
8 Rear accessories socket
9 Rear fog lights
10 Horn
11 Automatic door lockingNumber Allocation
12 ESC
13 Courtesy light
14 ABS-ESC
15 Reverse gear, windscreen
wiper
16 Cruise control-Speed
limiter, rear windscreen,
unfastened seatbelt
warning, parking distance
control
17 Daytime running lights
18 Brake lights
19 Fuel pump, Injection
20 Airbag
21 Heated seats
22 Power-assisted steering
23 Location reserved for
additional equipment.
24 Direction indicator lightNumber Allocation
25 Passenger compartment
ECU
26 Passenger compartment
ECU
27
and 29 Steering column control
28 Not used
30 Location reserved for
additional equipment.
31 Instrument panel
32 Radio
33 Starter
34 Windscreen wiper
35 Passenger compartment
ventilation
36 Cigar lighter
37 Diagnostic socket
38 Defrosting rearview mirror
39 Front fog lights

JauneNoir Noir texte
5.28
ENG_UD13290_3
Télécommande à radiofréquence : piles (X61 - F61 - K61 - Re\
nault)
ENG_NU_975-6_X92_Dacia_5
Replacing the remote control
battery
Undo screw 1 to remove the remote
control cover. Replace battery
2 according to the di-
rection marked on the cover.
Note: It is not advisable to touch the
electronic circuit in the key cover when
replacing the battery.
Do not throw away your
used batteries; give them to
an organisation responsible
for collecting and recycling
batteries.
RADIO FREQUENCY REMOTE CONTROL: batteries
1
2
When refitting, ensure that the cover
is correctly clipped on and the screw
tightened.
The batteries are available from ap-
proved Dealers, and their service
life approximately two years.
Check that there is no dye on the
battery: risk of an incorrect electri-
cal contact.

JauneNoir Noir texte
5.31
ENG_UD24481_1
Balais d’essuie-vitres (X92 - Renault)
ENG_NU_975-6_X92_Dacia_5
WIPER BLADES
Replacing windscreen wiper
blades 1
– With the ignition switched off, lift
wiper arm 3;
– turn the blade horizontally (move- ment A);
– press tab 2 and slide the wiper blade downwards (movement D ) until
hook 4 on the wiper arm is released.
– slide the blade (movement C ) then
lift it (movement B) to release it.
12
3
4
Replacing the rear screen
wiper blade 6
– With the ignition switched off, lift
wiper arm 5;
– pivot the blade 6 until some resist-
ance is met;
– pull the blade to release it (move- ment E).
Refitting a front or rear wiper
blade
To refit the wiper blade, proceed in re-
verse order to removal. Make sure that
the blade is correctly locked in position.
Check the condition of the wiper
blades. You are responsible for their
service life:
– clean the blades, windscreen and rear screen regularly with soapy
water;
– do not use them when the wind- screen or rear screen are dry;
– free them from the windscreen or rear screen when they have not
been used for a long time.
– In frosty weather, make
sure that the wiper blades
are not stuck by ice (to
avoid the risk of the motor
overheating).
– Check the condition of the wiper
blades.
Replace the wiper blades as soon
as they begin to lose efficiency
(approximately once a year).
Whilst changing the blade, take care
not to drop the arm onto the window
after it has been removed as this
may break the window.
A
D
C
B
5
6E

JauneNoir Noir texte
5.33
ENG_UD24482_1
Remorquage: dépannage (X92 - Renault)
ENG_NU_975-6_X92_Dacia_5
Only use the front 1 and rear 4
towing points.
These towing points may only be used
for towing: never use them for lifting the
vehicle directly or indirectly.Access to towing points
Unclip cover 3 or 5 by inserting a flat-
blade screwdriver or similar under the
cover.
Tighten towing hitch 2 fully: as much
as possible by hand at first, then finish
tightening it using the wheelbrace.
Use only towing hitch 2 and the wheel-
brace located under the luggage com-
partment carpet in the tool kit (please
refer to the information on the “Tool kit”
in Section 5).
– Use a rigid towing bar.
If a rope or cable is used
(where the law allows this),
the vehicle being towed
must be able to brake.
– A vehicle must not be towed if it is not fit to be driven.
– Avoid accelerating or braking suddenly when towing, as this
may result in damage being
caused to the vehicle.
– When towing a vehicle, it is ad- visable not to exceed 15 mph
(25 km/h).
Do not leave the tools unse-
cured inside the vehicle as
they may come loose under
braking.
TOWING: breakdown (2/2)
1
4
3
5
2
2