compression ratio DACIA SUPERNOVA 2004 Repair Manual

E7J-A-2/60 ENGINE17
IGNITION AND INJECTION
17 - 56
DIAG
NOSING-INTERPRETING THE STATES
STATEIDLE MODE ADJUSTMENT
SUGGESTIONS There shou
ld be no defect present or memorized
Check the resistance of the step-by-step engine for the idle mode adjustment.
Change it if necessary.
Check the insulation and the continuity of the cabling along the circuits:
- pin 12 calc ulator ♦ pin B step-by-step engine
- pin 41 calc ulator ♦ pin A step-by-step engine
- pin 42 calc ulator ♦ pin C step-by-step engine
- pin 72 calc ulator ♦ pin D step-by-step engine
Remedy if necessary, and then go on with the diagnose, watching the tolerance value of
the idle mode rotation ratio.
The id le mode rotation
ra tio< minimal limit. The id le mode rotation ratio is too small.
-Check th e functioning of the enrichment adjustment.
-Clean the air supply circuit (clapper body, step-by-step engine) as they seem to be dirty.
-Ch eck th e oil level of the engine (too high a level causes splash lubrication)
-Ch eck the pressure of petrol (see if it is not too small)
-Ch eck en gine compression with the “CLIP TEHNIC” tester
-Ch eck the adjustment of the rocker-arms and the settling of the distribution.
-Ch eck the ignition system
-Ch eck the in jectors.
If all the above are correct, then the step-by-step engine will have to be replaced.
AFTER REPAIRPerform again the conformity test.
vnx.su

33
REAR BEARING ELEMENTS
BRAKE SHOES
Di smount the a uxiliary connecting rod (B)
connection from the adjustment lever (C).
Bring the adjustment lever in the initial
position. Rot a t e t he c om pre ssi on sh oe wi t h 90
degrees. Dismount the lower spring.
Remove the (front) compression shoe, then
the tensioning one. REMOUNTING
Pe rform in re verse order t he dismounting
operations.
NOTE
The adjustment of the device for the
automa tic clearance taking over, is
depending of the sp ring tensio ning
caught be tween the rear shoe and the
auxiliary connecting rod.
Measure the value H=1mm, between the
auxiliary connecting rod and the front shoe.
If the va lue H is not c orrect, replace t he
auxiliary connecting rod spring and the
shoes return springs.
33 - 11
C
vnx.su

AIR CONDITIONING
62
62 - 8
THE CONDENSER
The condenser is placed on the cooling radiator, in the front part of the vehicle and is ensuring
the exhaust of the refrigerant heat accumulated at compression.
In order to grant the optimum condenser operation, frequently check if its outside surfaces are
always clean and the air penetration is not stopped. Also, check the condenser pipes in order not
to show deformations. CONDENSER
CO
NDENSOR REPLACEMENT
DISMOUNTING
Disconnect the battery.
Drain the cooling circuit.
Dismount the pipes connected to the condenser.
Dismount the radiator-condenser assembly.
Separate t he cooling radiator from the condenser.
ATTENT ION:
A void the possible deformation of t he ducts and fi nned plates.
Replace the condenser.
REMOUNTING
Perform the dismounting operations in the reverse order.
vnx.su