wiper fluid DAEWOO LACETTI 2004 Service Repair Manual
[x] Cancel search | Manufacturer: DAEWOO, Model Year: 2004, Model line: LACETTI, Model: DAEWOO LACETTI 2004Pages: 2643, PDF Size: 80.54 MB
Page 2278 of 2643
SECTION : 9D
WIPERS/WASHER SYSTEMS
CAUTION : Disconnect the negative battery cable before removing or installing any electrical unit or when a tool
or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable will help
prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise noted.
TABLE OF CONTENTS
SPECIFICATIONS9D–1 . . . . . . . . . . . . . . . . . . . . . . . . . .
Fastener Tightening Specifications 9D–1. . . . . . . . . . .
SCHEMATIC AND ROUTING DIAGRAMS9D–2 . . . . .
Wipers and Washer System 9D–2. . . . . . . . . . . . . . . . .
Wipers and Washer System 9D–3. . . . . . . . . . . . . . . . .
Wipers and Washer System (HatchBack) 9D–4. . . . .
Wipers and Washer System (HatchBack) 9D–5. . . . .
DIAGNOSIS9D–6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Windshield Wipers 9D–6. . . . . . . . . . . . . . . . . . . . . . . . .
Windshield Washer System 9D–10. . . . . . . . . . . . . . . .
Rear Window Wiper (Hatchback) 9D–11. . . . . . . . . . .
Rear Window Washer System (Hatchback) 9D–13. . .
MAINTENANCE AND REPAIR9D–14 . . . . . . . . . . . . . .
ON–VEHICLE SERVICE 9D–14. . . . . . . . . . . . . . . . . . . .
Windshield Wiper Arm 9D–14. . . . . . . . . . . . . . . . . . . . . Windshield Wiper Motor 9D–14. . . . . . . . . . . . . . . . . . .
Windshield Wiper Blade 9D–15. . . . . . . . . . . . . . . . . . .
Windshield Wiper Blade Insert 9D–16. . . . . . . . . . . . . .
Windshield Washer Reservoir 9D–16. . . . . . . . . . . . . .
Windshield Washer Pump(s) 9D–17. . . . . . . . . . . . . . .
Windshield Washer Nozzles 9D–18. . . . . . . . . . . . . . . .
Windshield Washer Hoses 9D–18. . . . . . . . . . . . . . . . .
Rear Window Wiper Arm (HATCHBACK) 9D–19. . . .
Rear Window Wiper Motor (HATCHBACK) 9D–20. . .
Rear Window Washer Nozzle (HATCHBACK) 9D–20
GENERAL DESCRIPTION AND SYSTEM
OPERATION9D–22 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Windshield Wiper System 9D–22. . . . . . . . . . . . . . . . . .
Windshield Washer System 9D–22. . . . . . . . . . . . . . . .
Rear Window Wiper/Washer System 9D–22. . . . . . . .
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
ApplicationNSmLb–FtLb–In
Front Wheel Well Splash Shield Bolts1.5–13
Washer Fluid Reservoir Bolts8–71
Wiper Arm Linkage Nut5–44
Wiper Arm Nut2216–
Wiper Motor Bolts8–71
Rear Wiper Arm Nut11–97
Page 2287 of 2643
9D – 10IWIPERS/WASHER SYSTEMS
DAEWOO V–121 BL4
WINDSHIELD WASHER SYSTEM
Windshield Washer Inoperative, Wipers Work OK
StepActionValue(s)YesNo
1Activate the windshield washer switch.
Do the windshield wipers operate when the washer
switch is activated?–Go to Step 4Go to Step 2
21. Turn the ignition ON.
2. While activating the washer switch, test the
voltage at windshield wiper switch connector
terminal A4.
Is voltage equal to the specified value?11–14 vGo to Step 8Go to Step 3
3Replace windshield wiper switch.
Is the repair complete?–System OK–
4Check the windshield washer fluid reservoir.
Is there washer fluid in the fluid reservoir?–Go to Step 6Go to Step 5
5Fill the windshield washer fluid reservoir.
Is the repair complete?–System OK–
6Check the windshield washer hoses and nozzles.
Are the windshield washer hoses and nozzles
clogged or damaged?–Go to Step 7Go to Step 8
7Repair the washer hoses and the nozzles.
Is the repair complete?–System OK–
81. Turn the ignition ON.
2. With the windshield washer activated, test volt-
age at the windshield washer pump.
Is the voltage equal to the specified value?11–14 vGo to Step 10Go to Step 9
9Repair open circuit between the windshield washer
pump and the windshield wiper switch.
Is the repair complete?–System OK–
10Use an ohmmeter to measure resistance between
ground and the windshield washer pump connector
terminal 1.
Is the resistance equal to the specified value? 0 WGo to Step 12Go to Step 11
11Repair the windshield washer pump ground circuit.
Is the repair complete?–System OK–
12Replace the windshield washer pump.
Is the repair complete?–System OK–
Page 2290 of 2643
WIPERS/WASHER SYSTEMS 9D – 13
DAEWOO V–121 BL4
REAR WINDOW WASHER SYSTEM (HATCHBACK)
StepActionValue(s)YesNo
1Check the washer fluid level.
Is there fluid in the washer reservoir?–Go to Step 3Go to Step 2
2Fill the washer reservoir.
Is the repair complete?–System OK–
3Verify that the hoses are not obstructed or leaking by
disconnecting the washer hose and blowing through
it toward the reservoir and also toward the nozzle.
Are the hoses obstructed or leaking?–Go to Step 4Go to Step 5
4Repair or replace the hoses.
Is the repair complete?–System OK–
5Check the function of the rear wiper.
Does the rear wiper function correctly?–Go to Step 7Go to Step 6
6Repair the rear wiper.
Is the rear wiper repair complete?–Go to Step 7–
71. Disconnect the electrical connector at the
washer pump.
2. Use an ohmmeter to check continuity between
the BLK wire of the washer pump connector
and ground.
Does the ohmmeter indicate the specified value? 0 WGo to Step 9Go to Step 8
8Repair the open or the high–resistance ground con-
nection.
Is the repair complete?–System OK–
9Check the voltage at the washer pump connector
(LT RED wire) when the rear washer is turned ON.
Is the voltage equal to the specified value?11–14 vGo to Step 10Go to Step 11
10Replace the washer pump.
Is the repair complete?–System OK–
111. Disconnect the wiper switch.
2. Connect an ohmmeter between terminal 3 and
terminal A2 of the wiper switch.
3. Observe the ohmmeter when the switch is
moved to the rear WASH position.
Does the ohmmeter indicate the specified value? 0 WGo to Step 12Go to Step 13
12Repair the open circuit between terminal A2 of the
wiper switch connector and the rear washer pump.
Is the repair complete?–System OK–
13Replace the wiper switch.
Is the repair complete?–System OK–
Page 2294 of 2643
WIPERS/WASHER SYSTEMS 9D – 17
DAEWOO V–121 BL4
4. Disconnect the washer hose from the washer
pump.
5. Disconnect the reservoir pump electrical connector.
6. Remove the bolts and the reservoir.
Installation Procedure
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
1. Install the reservoir with the bolts.
Tighten
Tighten the washer fluid reservoir bolts to 8 NSm (71
lb–in).
2. Connect the reservoir pump electrical connector.
3. Connect the washer hose to the washer pump.
4. Install the front wheel well splash shield with the
bolts and the screws.
Tighten
Tighten the front wheel well splash shield bolts to 1.5
NSm (13 lb–in).
5. Install the front left wheel. Refer to Section 2E,
Tires and Wheels.
6. Connect the negative battery cable.
WINDSHIELD WASHER PUMP(S)
(Typical)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the front left wheel. Refer to Section 2E,
Tires and Wheels.
3. Remove the bolts and the screws and the front
wheel well splash shield.
4. Disconnect the electrical connector.
5. Disconnect the washer hose from the washer
pump.
6. Remove the washer pump.
Page 2299 of 2643
9D – 22IWIPERS/WASHER SYSTEMS
DAEWOO V–121 BL4
GENERAL DESCRIPTION
AND SYSTEM OPERATION
WINDSHIELD WIPER SYSTEM
The windshield wiper system consists of a wiper motor, a
linkage, a wiper arm and a blade, and a wiper/washer
switch. The windshield wiper circuit incorporates a self–
parking device which consists of a worm gear and a cam
plate in order to keep the circuit engaged temporarily when
the switch is turned off. The wiper system is driven by a
permanent magnet–type motor. The windshield wiper mo-
tor is mounted on the dash panel and is directly connected
to the windshield wiper linkage.
The windshield wiper motor has two speeds, LO and HI,
and also has intermittent wiper capability. The wiper
switch is an integral part of the wiper/washer switch. Wind-
shield wiper operation is actuated through the lever on the
right side of the steering column.
WINDSHIELD WASHER SYSTEM
The windshield washer system is equipped with a washerfluid reservoir, a washer fluid pump, hoses, nozzles, and
a wiper/washer switch. The windshield washer reservoir
is mounted behind the front left wheel well splash shield.
Attached to the reservoir is a washer pump, which pumps
fluid through the hoses to the two nozzles mounted on the
hood. The washer switch is an integral part of the wiper/
washer switch. Windshield washer operation is actuated
through the lever on the right side of the steering column.
REAR WINDOW WIPER/WASHER
SYSTEM
The rear window wiper system consists of a wiper motor,
a wiper arm, and a blade. The rear window wiper motor is
located inside the hatchback/tailgate door and is directly
connected to the rear window wiper. The rear window
washer system is equipped with a separate washer fluid
pump and hose. The hatchback has a hatch–mounted
rear window washer nozzle and on the wagon, the washer
nozzle is incorporated into the rear wiper motor. The rear
window washer reservoir is mounted behind the front left
wheel well splash shield. Attached to the reservoir is a
washer pump, which pumps fluid through a hose to the
rear washer nozzle.