radio DODGE CHALLENGER 2016 3.G Workshop Manual

Cleaning Headlights
Your vehicle is equipped with plastic headlights and fog
lights that are lighter and less susceptible to stone break-
age than glass headlights.
Plastic is not as scratch resistant as glass and therefore
different lens cleaning procedures must be followed.
To minimize the possibility of scratching the lenses and
reducing light output, avoid wiping with a dry cloth. To
remove road dirt, wash with a mild soap solution fol-
lowed by rinsing.
Do not use abrasive cleaning components, solvents, steel
wool or other aggressive material to clean the lenses.
Glass Surfaces
All glass surfaces should be cleaned on a regular basis
with MOPAR Glass Cleaner, or any commercial
household-type glass cleaner. Never use an abrasive typecleaner. Use caution when cleaning the inside rear win-
dow equipped with electric defrosters or windows
equipped with radio antennas. Do not use scrapers or
other sharp instrument that may scratch the elements.
When cleaning the rear view mirror, spray cleaner on the
towel or cloth that you are using. Do not spray cleaner
directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft cloth. A mild soap solution may
be used, but do not use high alcohol content or
abrasive cleaners. If soap is used, wipe clean with a
clean damp cloth.
2. Dry with a soft cloth.
7
MAINTAINING YOUR VEHICLE 565

Cavity Cartridge FuseMini-FuseDescription
23 – 10 Amp Red Fuel Door/Diagnostic Port
24 – 10 Amp Red Integrated Center Stack
25 – 10 Amp Red Tire Pressure Monitor
26 – 15 Amp Blue Cygnus Transmission Module (Charger/300)/
Electronic Shift Module (Charger/300)
27 – 25 Amp Clear Amplifier – If Equipped
31 –25 Amp Breaker Power Seats – If Equipped
32 – 15 Amp Blue HVAC Module/Cluster
33 – 15 Amp Blue Ignition Switch/RF Hub Module/Steering Col-
umn Lock (300) – If Equipped
34 – 10 Amp Red Steering Column Module/Clock (300)
35 – 5 Amp Tan Battery Sensor
36 – 15 Amp Blue Electronic Exhaust Valve – If Equipped
37 –20 Amp Yellow Radio
38 –20 Amp Yellow
Power Outlet Inside Arm Rest/Console Media Hub
576 MAINTAINING YOUR VEHICLE

Radio FrequencyGeneral Information ............16, 19, 27, 31, 40
Radio Operation ......................... .338
Radio Remote Controls .....................336
Radio (Sound Systems) .....................335
Rain Sensitive Wiper System .................151
Rear Camera ........................... .195
Rear Cupholder ......................... .216
Rear ParkSense System .....................187
Rear Seat, Folding ........................ .136
Rear Window Defroster .....................219
Rear Window Features .....................219
Recorder, Event Data .......................72
Recreational Towing ...................... .483
Reformulated Gasoline .....................461
Refrigerant ............................. .542
Release, Hood ........................... .137
Reminder, Lights On ...................... .143
Reminder, Seat Belt .........................46 Remote Control
Starting System .........................27
Remote Keyless Entry (RKE) Arm The Alarm .........................20
Lock The Doors .........................24
Panic Alarm ............................25
Programming Additional Key Fobs .........19, 25
Programming Additional Transmitters .......19, 25
Remote Keyless Entry (RKE) ................22
Unlatch The Trunk .......................24
Unlock The Doors .......................23
Remote Sound System (Radio) Controls .........336
Remote Starting Uconnect Customer Programmable
Features ......................... .290, 307
Uconnect Settings ....................290, 307
Remote Starting System ......................27
Remote Trunk Release .......................42
Replacement Bulbs ....................... .580
640 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.