ECO mode DODGE CHALLENGER SRT 2016 3.G Workshop Manual

BULB REPLACEMENT
NOTE:Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
Low Beam Headlamp, High Beam Headlamp,
Park/Turn Lamp — Models With Halogen
Headlamps — If Equipped
To replace the passenger side lamps:
1. Open the hood.
2. Remove the headlamp cover.
3. Reach behind the passenger headlamp assembly.
NOTE: The park/turn lamps can also be accessed at this
point. 4. Turn the headlamp access cap counterclockwise to
remove.
5. Remove bulb by turning it counter clockwise and disconnect.
6. Install new bulb by turning it clockwise and reconnect.
7. Reinstall headlamp access cap by turning it clockwise and then reinstall headlamp cover.
To replace the driver side lamps:
1. Open the hood.
2. Remove the air cleaner filter cover by removing three fasteners and loosening the clean air inlet clamp and
then rotate cover off to the side.
NOTE: The cover has an electrical connector that does
not need to be disconnected if the cover is rotated off to
the side.
562 MAINTAINING YOUR VEHICLE

3. Remove one fastener on the lower air box to removeand access the rear of the headlamp assembly.
4. Reach behind the passenger headlamp assembly.
5. Remove the headlamp cover.
6. Turn the headlamp access cap counterclockwise to remove.
7. Remove bulb by turn it counter clockwise and discon- nect.
8. Install new bulb by turning it clockwise and reconnect.
9. Reinstall headlamp access cap by turning it clockwise and then reinstall headlamp cover.
10. Reinstall engine air cleaner assembly.Low Beam Headlamp, High Beam Headlamp, and
Park/Turn Lamp — Models With High Intensity
Discharge (HID) Headlamps — If Equipped
HID Headlamps
The headlamps are a type of high voltage discharge tube.
High voltage can remain in the circuit even with the
headlamp switch off and the key removed. Because of
this, you should not attempt to service a headlamp bulb
yourself. If a headlamp bulb fails, take your vehicle to
an authorized dealer for service.
WARNING!
A transient high voltage occurs at the bulb sockets of
HID headlamps when the headlamp switch is turned
ON. It may cause serious electrical shock or electro-
cution if not serviced properly. See your authorized
dealer for service.
7
MAINTAINING YOUR VEHICLE 563

Customer Programmable Features.............278
Data Recorder, Event .......................70
Daytime Brightness, Interior Lights .............146
Daytime Running Lights ....................142
Dealer Service ........................... .513
Deck Lid, Emergency Release .................42
Deck Lid, Power Release .....................41
Defroster, Rear Window .....................218
Defroster, Windshield .......................96
Delay (Intermittent) Wipers ..................147
Diagnostic System, Onboard .................510
Dimmer Switch, Headlight ...................144
Dipsticks Oil (Engine) .......................... .515
Disabled Vehicle Towing ..............501, 502, 503
Disposal Antifreeze (Engine Coolant) ................533
Door Ajar .............................. .241Door Ajar Light
......................... .241
Door Locks Door Locks ......................... .23, 31
KeyFob...............................31
Remote ...............................31
Remote Keyless Entry (RKE) ................31
Door Locks, Automatic ......................33
Door Opener, Garage ...................... .199
Drive Modes ........................... .400
Driver Information Display DID ............................ .259, 262
Instrument Cluster Display .............259, 262
Driving Through Flowing, Rising, Or Shallow Standing
Water ............................... .413
Electrical Power Outlets .....................211
Electric Remote Mirrors .....................113
Electronic Brake Control System ...............421
596 INDEX