ABS DODGE DURANGO 1998 1.G Workshop Manual

DODGE DURANGO 1998 1.G Workshop Manual DURANGO 1998 1.G DODGE DODGE https://www.carmanualsonline.info/img/12/5703/w960_5703-0.png DODGE DURANGO 1998 1.G Workshop Manual

Page 15 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine CHECKING ENGINE OIL PRESSURE
(1) Remove oil pressure sending unit (Fig. 3) and
install gauge assembly C-3292.
(2) Run engine until thermostat o

Page 25 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine NOTE: Piston rings are installed in the following
order:
²Oil ring expander.
²Upper oil ring side rail.
²Lower oil ring side rail.
²No. 2 I

Page 26 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (5) Install bearing cap and connecting rod on the
journal and tighten bolts to 27 N´m (20 ft. lbs.) plus a
90É turn. DO NOT rotate crankshaft

Page 27 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (9) Repeat the Plastigage measurement to verify
your bearing selection prior to final assembly.
(10) Once you have selected the proper insert,

Page 32 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine ²Throttle Position (TPS) Switch
²Idle Air Control (IAC) Motor
²Engine Oil Pressure Switch
²Engine Coolant Temperature (ECT) Sensor
²Manifo

Page 33 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (2)4X4 vehiclesInstall locknuts onto the engine
mount brackets. Tighten locknuts to 41 N´m (30 ft.
lbs.).
(3) Remove jack from under the trans

Page 35 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine INTAKE MANIFOLD
REMOVAL
(1) Disconnect negative cable from battery.
(2) Remove resonator assembly and air inlet hose.
(3) Disconnect throttle a

Page 36 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (10) Position and install heater hoses and tubes
onto intake manifold.
(11) Install the heater hoses to the heater core and
engine front cover.

Page 91 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine CRANKSHAFT MAIN BEARINGS
DESCRIPTION
Main bearings are located in the cylinder block.
One half of the main bearing is located in the crank-
sha

Page 104 of 193

DODGE DURANGO 1998 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (13) Disconnect the heater hoses and bypass hose.
(14) Remove the closed crankcase ventilation and
evaporation control systems.
(15) Remove int
Page:   1-10 11-20 next >