Starter mounting bolts DODGE DURANGO 1999 1.G Workshop Manual

DODGE DURANGO 1999 1.G Workshop Manual DURANGO 1999 1.G DODGE DODGE https://www.carmanualsonline.info/img/12/5703/w960_5703-0.png DODGE DURANGO 1999 1.G Workshop Manual

Page 31 of 193

DODGE DURANGO 1999 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine ENGINE ASSEMBLY
REMOVAL
NOTE: This procedure applies to both the 4X2 and
4X4 vehicles, steps that apply to the 4X4 vehicle
only, are identified

Page 34 of 193

DODGE DURANGO 1999 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (20) Install both breathers. Connect tube to both
crankcase breathers (Fig. 44).
(21) Connect throttle and speed control cables.
(22) Install t

Page 101 of 193

DODGE DURANGO 1999 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (1) Disconnect the negative cable from the battery.
(2) Raise vehicle on hoist.
(3) Install engine lifting (support) fixture.
(4) Remove front

Page 115 of 193

DODGE DURANGO 1999 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine After the distributor has been installed, its rota-
tional position must be set using theSET SYNC
mode of the DRB scan tool. Refer to Checking

Page 116 of 193

DODGE DURANGO 1999 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine (2)Install the dowels in the cylinder block (Fig. 64).
(3) Apply small amount of Mopar Silicone Rubber
Adhesive Sealant, or equivalent in the c

Page 133 of 193

DODGE DURANGO 1999 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine TORQUE SPECIFICATIONS
TORQUE CHART 5.2L ENGINE
DESCRIPTION N´m Ft. In.
Lbs. Lbs.
Camshaft SprocketÐBolt 68 50 Ð
Camshaft Thrust PlateÐBolts

Page 161 of 193

DODGE DURANGO 1999 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine INSTALLATIONÐ4WD
(1) If engine support brackets were removed,
install them and their fasteners (Fig. 35) (Fig. 36).
Tighten support bracket to

Page 162 of 193

DODGE DURANGO 1999 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine REMOVALÐ4WD
(1) Disconnect the negative cable from the battery.
(2) Raise the vehicle on a hoist.
(3) Support the transmission with a transmis

Page 175 of 193

DODGE DURANGO 1999 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine CRANKSHAFT MAIN BEARINGS
REMOVAL
(1) Remove the oil pan.
(2) Remove the oil pump from the rear main bear-
ing cap.
(3) Identify bearing caps be

Page 176 of 193

DODGE DURANGO 1999 1.G Workshop Manual Downloaded from www.Manualslib.com manuals search engine INSTALLATION
2WD
(1) Fabricate 4 alignment dowels from 5/16x11/2
inch bolts. Cut the head off the bolts and cut a slot
into the top of the dowe
Page:   1-10 11-20 next >