wheel torque DODGE DURANGO 2004 2.G Owners Manual

transmission into gear may seem sluggish. This is due to
the fluid partially draining from the torque converter into
the transmission. This condition is normal and will not
cause damage to the transmission. The torque converter
will refill within five seconds of shifting from Park into
any other gear position.
FOUR-WHEEL DRIVE OPERATION
NV 144 Transfer Case Operating
Information/Precautions
The NV 144 is an electric shift transfer case and is
operated by the Four-Wheel-Drive (4WD) Control
Switch, which is located on the instrument panel.
The NV 144 transfer case provides 2 mode positions:
All-Wheel Drive (AWD) and 4-Wheel-Drive LOCK.
The NV 144 transfer case is designed to be driven in for
AWD for normal street and highway conditions (all road
surfaces roads).When additional traction is required, the transfer case
4LOCK position can be used to lock the front and rear
driveshafts together and force the front and rear wheels
to rotate at the same speed. This is accomplished by
rotating the 4WD Control Switch to the 4LOCK position
- see Shifting Procedure section for specific shifting
instructions. The 4LOCK position is designed for loose,
slippery road surfaces only. Driving in the 4LOCK posi-
tion on dry hard surfaced roads may cause increased tire
wear and damage to the driveline components.Transfer Case Position Indicator Lights
Transfer case position indicator lights are located on the
instrument cluster, and indicate the current and desired
transfer case selection. If there are no indicator lights on
or flashing the transfer case position is All-Wheel Drive
(AWD).
The ªSVC 4WDº warning light monitors the electric shift
4WD system. If this light remains on after engine start up
208 STARTING AND OPERATING

WARNING!
Raising the vehicle higher than necessary can make
the vehicle unstable and cause an accident. It could
slip off the jack and hurt someone near it. Raise the
vehicle only enough to remove the tire.
6. Remove the wheel nuts and pull the wheel off. Install
the spare wheel and wheel nuts with the cone shaped end
of the nuts toward the wheel. Lightly tighten the nuts. To
avoid risk of forcing the vehicle off the jack, do not fully
tighten the nuts until the vehicle has been lowered.
NOTE:Do not oil wheel studs. For chrome wheels, do
not substitute with chrome plated wheel nuts.
7. Using the wheel wrench, finish tightening the nuts in
a crisscross pattern. Correct nut tightness is 85-115 ft. lbs.
(115-155 N´m) torque. If in doubt about the correct
tightness, have them checked with a torque wrench by
your dealer or at a service station.
WARNING!
A loose tire or jack thrown forward in a collision or
hard stop could injure someone in the vehicle.
Always stow the jack, tools and the extra tire and
wheel in the places provided.
8. Install wheel center cap and remove wheel blocks. Do
not install chrome or aluminum wheel center caps on the
spare wheel. This may result in cap damage.
9. Lower the jack to its fully closed position. Stow the
replaced tire, jack, and tools as previously described.
10. Adjust the tire pressure when possible.
NOTE:Do not oil wheel studs. For chrome wheels, do
not substitute with chrome plated wheel nuts.
278 WHAT TO DO IN EMERGENCIES

Jacking............................. 275
Load Capacity.....................226,227
Radial.............................. 234
Replacement......................... 237
Rotation............................. 241
Safety...........................221,230
Sizes............................... 223
Snow Tires........................... 240
Spare Tire........................... 273
Spinning............................ 236
Tread Wear Indicators................... 236
Wheel Mounting....................... 275
Wheel Nut Torque..................... 278
Tongue Weight/Trailer Weight.............. 256
Torque Converter Clutch.................. 207
Towing............................... 254
Disabled Vehicle....................... 282
Guide.............................. 258
Recreational.......................... 262Weight.............................. 258
Traction.............................. 267
Traction Control...................... 112,150
Traction Control Switch................... 112
Trailer Towing.......................... 254
Cooling System Tips.................... 260
Hitches............................. 257
Minimum Requirements................. 258
Trailer and Tongue Weight................ 256
Wiring.............................. 259
Trailer Towing Guide..................... 258
Trailer Weight.......................... 258
Transaxle............................. 203
Automatic........................... 203
Operation........................... 203
Transfer Case........................... 319
Fluid............................... 338
Transmission........................203,315
Automatic........................203,315
384 INDEX

Filter............................... 318
Fluid............................318,338
Maintenance.......................... 315
Transmitter Battery Service.................. 24
Transmitter, Garage Door Opener............ 126
Transmitter Programming................... 22
Tread Wear Indicators.................... 236
Trip Computer.......................... 120
Trip Odometer.......................... 153
Trip Odometer Reset Button................ 154
Turn Signals......................108,146,329
Universal Transmitter..................... 126
Unlock, Auto........................... 16
Vacuum/Vapor Harnesses.................. 311
Vanity Mirrors........................... 73
Variance, Compass....................... 125
Vehicle Identification Number................ 5Vehicle Loading......................227,250
Vehicle Modifications/Alterations.............. 6
Vehicle Storage......................... 326
Warning Lights (Instrument Cluster Description) . 146
Warnings and Cautions..................... 5
Warranty Information..................... 363
Washers, Windshield..................... 111
Washing Vehicle......................... 321
Weight Load Carrying.................... 250
Wheel Alignment and Balance............... 238
Wheel and Wheel Trim.................... 322
Wheel Changing........................ 272
Wheel Mounting........................ 275
Wheel Nut Torque....................... 278
Wind Buffeting......................... 134
Window Fogging........................ 191
Windows.............................. 27
Power............................... 27
INDEX 385
10