bulb DODGE DURANGO 2016 3.G User Guide

▫Brake System ....................... .664
▫ Front/Rear Axle Fluid ..................666
▫ Transfer Case ....................... .667
▫ Automatic Transmission ................668
▫ Appearance Care And Protection From
Corrosion .......................... .670
 FUSES ............................. .676
▫ Power Distribution Center ...............677
 VEHICLE STORAGE ....................684
 REPLACEMENT BULBS .................685
 BULB REPLACEMENT ..................687
▫ High Intensity Discharge Headlamps (Bi-Xenon)
— If Equipped ...................... .687▫
Bi-Halogen Headlamps — If Equipped ......688
▫ Front Turn Signal .....................689
▫ Front Fog Lamps .....................690
▫ Rear Tail, Stop And Turn Signal Lamps ......690
▫ Rear Liftgate Mounted Back-up Lamps ......690
▫ Center High-Mounted Stop Lamp (CHMSL) . .691
▫ Rear License Lamp ....................691
 FLUID CAPACITIES ....................691
 FLUIDS, LUBRICANTS, AND GENUINE
PARTS ............................. .693
▫ Engine ............................ .693
▫ Chassis ........................... .695
634 MAINTAINING YOUR VEHICLE

Normally, the OBD II system will be ready. The OBD II
system maynotbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition actuated test, which
you can use prior to going to the test station. To check if
your vehicle’s OBD II system is ready, you must do the
following:
1. Cycle the ignition switch to the ON position, but do not crank or start the engine.
NOTE: If you crank or start the engine, you will have to
start this test over.
2. As soon as you cycle the ignition switch to the ON position, you will see the “Malfunction Indicator Light
(MIL)” symbol come on as part of a normal bulb
check. 3. Approximately 15 seconds later, one of two things will
happen:
• The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition or start the engine. This means that your
vehicle’s OBD II system is not readyand you should
not proceed to the I/M station.
• The MIL will not flash at all and will remain fully
illuminated until you place the ignition in the off
position or start the engine. This means that your
vehicle’s OBD II system is readyand you can proceed
to the I/M station.
If your OBD II system is not ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD II
7
MAINTAINING YOUR VEHICLE 639

REPLACEMENT BULBS
Interior Bulbs
Bulb Number
Glove Box Lamp 194
Grab Handle Lamp L002825W5W
Overhead Console Reading Lamps VT4976
Visor Vanity Lamp V26377
Rear Cargo Lamp 214–2
Underpanel Courtesy Lamps 906
Instrument Cluster (General Illumination) 103
Telltale/Hazard Lamp 74
7
MAINTAINING YOUR VEHICLE 685

Exterior Bulbs
Bulb Number
Low Beam/High Beam (Bi-Xenon) Headlamps D3S (Service at Authorized Dealer)
Low Beam/High Beam/Daytime Running Lamp
(DRL) Bi-Halogen Headlamps (Base) 9005SL+
Low Beam/High Beam (Bi-Halogen) Headlamps
(Uplevel) 9005SL+
Front Park/Turn Signal Lamps (Base) 3157NAK
Front Turn Signal Lamps (Uplevel & Premium) 3157NAK
Front Park Lamp/Daytime Running Lamp (Uplevel &
Premium) LED (Serviced at Authorized Dealer)
Front Side Marker Lamps LED (Serviced at Authorized Dealer)
Front Fog Lamps H11
Rear Tail Lamps/Sidemarker Lamps LED (Serviced at Authorized Dealer)
Rear Stop/Turn Signal Lamps LED (Serviced at Authorized Dealer)
Rear Liftgate Tail Lamps LED (Serviced at Authorized Dealer)
686 MAINTAINING YOUR VEHICLE

Bulb Number
Rear Backup Lamps 921 (W16W)
Rear License Lamps LED (Serviced at Authorized Dealer)
Center High-Mounted Stop Lamp (CHMSL) LED (Serviced at Authorized Dealer)
BULB REPLACEMENT
NOTE:Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
High Intensity Discharge Headlamps (Bi-Xenon)
— If Equipped
The headlamps are a type of high voltage discharge tube.
High voltage can remain in the circuit even with the
headlamp switch off. Because of this, you should not
attempt to service a headlamp bulb yourself. If a
headlamp bulb fails, take your vehicle to an authorized
dealer for service.
7
MAINTAINING YOUR VEHICLE 687

WARNING!
A transient high voltage occurs at the bulb sockets of
High Intensity Discharge (HID) headlamps when the
headlamp switch is turned ON. It may cause serious
electrical shock or electrocution if not serviced prop-
erly. See your authorized dealer for service.
NOTE: On vehicles equipped with High Intensity Dis-
charge (HID) headlamps, when the headlamps are
turned on, there is a blue hue to the lamps. This dimin-
ishes and becomes more white after approximately 10
seconds, as the system charges.
Bi-Halogen Headlamps — If Equipped
1. Turn the steering wheel to the left to replace the bulb from the right hand lamp, or to the right to replace the
bulb from the left hand lamp.
2. Turn the access cap located on the wheel liner coun- terclockwise to remove from liner.
3. Locate the headlamp bulb access cap through the opening in the wheel liner.
4. Firmly grasp the access cap and rotate counterclock- wise to remove lamp housing.
5. Firmly grasp the low/high beam bulb and connector assembly and rotate counterclockwise to remove from
housing.
6. Disconnect the electrical connector and then connect the replacement bulb.
688 MAINTAINING YOUR VEHICLE

7. Install the bulb and connector assembly into theheadlamp housing and rotate clockwise to lock in
place.
8. Install the bulb access cap in the headlamp housing and rotate clockwise to lock it in place.
9. Install the access cap in the wheel liner and rotate clockwise to lock it in place.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
Front Turn Signal
1. Open the hood.
2. Turn the turn signal bulb one–quarter turn counter-clockwise to remove from housing.
3. Disconnect the electrical connector and replace the bulb.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.7
MAINTAINING YOUR VEHICLE 689

Front Fog Lamps
1. Reach through the cutout in the splash shield androtate the bulb’s electrical connector one-quarter turn
counterclockwise and remove it from the fog lamp
housing.
2. Remove the bulb from the connector and install the replacement bulb.
3. Install the bulb and connector assembly into the fog lamp housing and rotate the connector one-quarter
turn clockwise to lock it in place.
CAUTION!
•Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If
the bulb comes in contact with any oily surface,
clean the bulb with rubbing alcohol.
(Continued)
CAUTION!
(Continued)
•Always use the correct bulb size and type for
replacement. An incorrect bulb size or type may
overheat and cause damage to the lamp, the socket
or the lamp wiring.
Rear Tail, Stop And Turn Signal Lamps
The rear tail, stop, and turn signal lamps are LED. See
your authorized dealer for replacement.
Rear Liftgate Mounted Back-up Lamps
1. Raise the liftgate.
2. Use a fiber stick or flat blade screw driver to pry the
lower trim from the liftgate.
3. Back-up lamps are now visible. Rotate socket(s) coun- ter clockwise.
4. Remove/replace bulb(s).
690 MAINTAINING YOUR VEHICLE

Fluid Check.......................... .664
Master Cylinder ....................... .664
Parking ............................. .505
Warning Light ........................ .299
Brake/Transmission Interlock .................481
Bulb Replacement ..................... .685, 687
Bulbs, Light .............................114
Camera, Rear ........................... .239
Capacities, Fluid ......................... .691
Caps, Filler Fuel ................................ .617
Oil (Engine) .......................... .644
Radiator (Coolant Pressure) ................661
Carbon Monoxide Warning ...............111,564
Cargo Area Cover ........................ .274
Cargo Area Features ...................... .272
Cargo Compartment ...................... .272
Light ............................... .274Luggage Carrier
....................... .279
Cargo Light ............................ .274
Cargo Tie-Downs ........................ .275
Car Washes ............................ .670
Cellular Phone .......................... .424
Center High Mounted Stop Light ..............691
Certification Label ........................ .568
Chains, Tire ............................ .549
Changing A Flat Tire ...................... .602
Chart, Tire Sizing ........................ .525
Check Engine Light (Malfunction Indicator Light) . .638
Checking Your Vehicle For Safety ..............111
Checks, Safety ............................111
Child Restraint ............................85
Child Restraints Booster Seats ...........................90
Child Restraints .........................85
Child Seat Installation ....................105
How To Stow An Unused ALR Seat Belt .......101
718 INDEX

Garage Door Opener (HomeLink)..............244
Gasoline, Clean Air ....................... .560
Gasoline (Fuel) .......................... .559
Gasoline, Reformulated .....................560
Gear Ranges ............................ .484
General Information ...................... .559
Glass Cleaning .......................... .675
Gross Axle Weight Rating ...................572
Gross Vehicle Weight Rating ..................571
GVWR ................................ .569
Hazard Warning Flasher ....................599
Headlights ............................. .687
Automatic ........................... .176
Bulb Replacement ...................... .688
Cleaning ............................ .674
On With Wipers ....................... .176
Passing ............................. .184
Replacing ............................ .688Heated Mirrors
...................... .134, 278
Heater, Engine Block ...................... .479
Hill Start Assist .......................... .512
Hitches Trailer Towing ........................ .575
Holder, Cup ............................ .264
HomeLink (Garage Door Opener) ..............244
Hood Release ........................... .173
Ignition Key..................................14
Illuminated Entry ..........................24
Immobilizer (Sentry Key) ....................18
Inside Rearview Mirror ..................124, 125
Instrument Cluster ..............294, 301, 306, 320
Instrument Panel And Controls ...............293
Instrument Panel Lens Cleaning ...............675
Interior Appearance Care ....................673
Intermittent Wipers (Delay Wipers) .............185
10
INDEX 723