ESP DODGE GRAND CARAVAN 2016 5.G Workshop Manual

•Blot any remaining stain with a clean, damp towel.
• For tough stains, apply MOPAR Total Clean, or a mild
soap solution to a clean, damp cloth and remove stain.
Use a fresh, damp towel to remove soap residue.
• For grease stains, apply MOPAR Multi-Purpose
Cleaner to a clean, damp cloth and remove stain. Use
a fresh, damp towel to remove soap residue.
• Do not use any harsh solvents or any other form of
protectants on Stain Repel products.
Interior Care
Use MOPAR Total Clean to clean fabric upholstery and
carpeting.
Use MOPAR Total Clean to clean vinyl upholstery.
MOPAR Total Clean is specifically recommended for
leather upholstery. Your leather upholstery can be best preserved by regular
cleaning with a damp soft cloth. Small particles of dirt
can act as an abrasive and damage the leather upholstery
and should be removed promptly with a damp cloth.
Stubborn soils can be removed easily with a soft cloth
and MOPAR Total Clean. Care should be taken to avoid
soaking your leather upholstery with any liquid. Please
do not use polishes, oils, cleaning fluids, solvents, deter-
gents, or ammonia-based cleaners to clean your leather
upholstery. Application of a leather conditioner is not
required to maintain the original condition.WARNING!
Do not use volatile solvents for cleaning purposes.
Many are potentially flammable, and if used in
closed areas they may cause respiratory harm.
7
MAINTAINING YOUR VEHICLE 643

WARNING!(Continued)
assemblies must be replaced after a collision if they
have been damaged (i.e., bent retractor, torn web-
bing, etc.).
Cleaning The Instrument Panel Cupholders
Removal
Pull the flexible liner from the cupholder drawer starting
at one edge to ease removal.
Cleaning
The liner is top shelf dishwasher safe, or you may follow
the cleaning procedure below.
Soak the liner in a mixture of medium hot tap water and
one teaspoon of mild liquid dish soap. Let soak for
approximately 30 minutes. After 30 minutes, pull the
liner from the water and dip it back into the water about
six times. This will loosen any remaining debris. Rinse the liner thoroughly under warm running water. Shake
the excess water from the liner and dry the outer surfaces
with a clean soft cloth.
Installation
Place the liner into the cupholder drawer and push the
liner into place so that the retention tabs seat into the
corresponding openings in the drawer.
FUSES
WARNING!
•
When replacing a blown fuse, always use an ap-
propriate replacement fuse with the same amp
rating as the original fuse. Never replace a fuse
with another fuse of higher amp rating. Never
replace a blown fuse with metal wires or any other
(Continued)
646 MAINTAINING YOUR VEHICLE

CAUTION!
•When installing the Totally Integrated Power Module
cover, it is important to ensure the cover is properly
positioned and fully latched. Failure to do so may
allow water to get into the Integrated Power Module,
and possibly result in a electrical system failure.
(Continued)
CAUTION! (Continued)
•When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If
a properly rated fuse continues to blow, it indicates
a problem in the circuit that must be corrected.
The numbers inside the TIPM cover correspond to the following table.
Cavity Cartridge Fuse Mini-Fuse Description
J1 40 Amp Green –Power Folding Seat
J2 30 Amp Pink –Power Liftgate Module
J3 30 Amp Pink – Rear Door Module
J4 25 Amp Clear – Driver Door Node
J5 25 Amp Clear –Passenger Door Node
648 MAINTAINING YOUR VEHICLE

Customer Assistance For The Hearing Or Speech
Impaired (TDD/TTY)
To assist customers who have hearing difficulties, the
manufacturer has installed special TDD (Telecommuni-
cation Devices for the Deaf) equipment at its customer
center. Any hearing or speech impaired customer, who
has access to a TDD or a conventional teletypewriter
(TTY) in the United States, can communicate with the
manufacturer by dialing 1-800-380-CHRY.
Canadian residents with hearing difficulties that require
assistance can use the special needs relay service offered
by Bell Canada. For TTY teletypewriter users, dial 711
and for Voice callers, dial 1-800-855-0511 to connect with
a Bell Relay Service operator.
Service Contract
You may have purchased a service contract for a vehicle
to help protect you from the high cost of unexpected
repairs after the manufacturer’s New Vehicle LimitedWarranty expires. The manufacturer stands behind only
the manufacturer’s service contracts. If you purchased a
manufacturer’s service contract, you will receive Plan
Provisions and an Owner Identification Card in the mail
within three weeks of the vehicle delivery date. If you
have any questions about the service contract, call the
manufacturer’s Service Contract National Customer
Hotline at 1-800-521-9922 (Canadian residents, call (800)
465-2001 English / (800) 387-9983 French).
The manufacturer will not stand behind any service
contract that is not the manufacturer’s service contract. It
is not responsible for any service contract other than the
manufacturer’s service contract. If you purchased a ser-
vice contract that is not a manufacturer’s service contract,
and you require service after the manufacturer’s New
Vehicle Limited Warranty expires, please refer to the
contract documents, and contact the person listed in
those documents.
9
IF YOU NEED CONSUMER ASSISTANCE 677

Temperature Grades
The temperature grades are A (the highest), B, and C,
representing the tire’s resistance to the generation of heat
and its ability to dissipate heat, when tested under
controlled conditions on a specified indoor laboratory
test wheel. Sustained high temperature can cause the
material of the tire to degenerate and reduce tire life, and
excessive temperature can lead to sudden tire failure. The
grade C corresponds to a level of performance, which all
passenger car tires must meet under the Federal Motor
Vehicle Safety Standard No. 109. Grades B and A repre-
sent higher levels of performance on the laboratory test
wheel, than the minimum required by law.
WARNING!
The temperature grade for this tire is established for
a tire that is properly inflated and not overloaded.
Excessive speed, under-inflation, or excessive load-
ing, either separately or in combination, can cause
heat buildup and possible tire failure.
682 IF YOU NEED CONSUMER ASSISTANCE

About Your Brakes....................... .488
Adding Engine Coolant (Antifreeze) ............631
Adding Fuel ............................ .543
Adding Washer Fluid ..................... .628
Additives, Fuel .......................... .538
AirBag.................................78 Advance Front Air Bag ....................80
Air Bag Operation .......................81
Air Bag Warning Light ....................90
Driver Knee Air Bag ......................82
Enhanced Accident Response ................89
Event Data Recorder (EDR) .................92
FrontAirBag...........................78
If A Deployment Occurs ...................88
Knee Impact Bolsters .....................82
Maintaining Your Air Bag System ............91
Side Air Bags ...........................83
Transporting Pets .......................117
Air Bag Deployment ........................78 Air Bag Light
..................... .90, 120, 315
Air Bag Maintenance .......................91
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . .621
Air Conditioner Maintenance .................625
Air Conditioning ......................... .440
Air Conditioning Controls ...................440
Air Conditioning Filter ..................459, 626
Air Conditioning, Operating Tips ..............458
Air Conditioning, Rear Zone ..............445, 455
Air Conditioning Refrigerant ..............625, 626
Air Conditioning System .............440, 448, 625
Air Conditioning System, Zone Control ..........440
Air Pressure, Tires ........................ .513
Alarm (Security Alarm) ..................17, 324
Alterations/Modifications, Vehicle ...............7
Antenna, Satellite Radio .....................381
Antifreeze (Engine Coolant) ...............631, 660
Disposal ............................. .634
Anti-Lock Brake System (ABS) ................489
684 INDEX

Traction Control System...................495
Electronic Speed Control (Cruise Control) ........235
Electronic Stability Control (ESC) ..............495
Electronic Throttle Control Warning Light ........321
Electronic Vehicle Information Center (EVIC) ......339
Emergency, In Case Of Hazard Warning Flasher ..................567
Jacking .......................... .581, 589
Jump Starting ......................... .600
Overheating .......................... .567
Emission Control System Maintenance ..........615
Engine Air Cleaner .......................... .621
Block Heater ......................... .468
Break-In Recommendations ................118
Checking Oil Level ..................... .618
Compartment ......................... .613
Compartment Identification ................613
Coolant (Antifreeze) ..................630, 661 Cooling
............................. .629
Exhaust Gas Caution .................119,540
Flooded, Starting ...................... .466
Fuel Requirements ...................536, 660
Oil .......................... .618, 660, 661
Oil Filter ............................ .621
Oil Selection ...................... .619, 660
Oil Synthetic ......................... .620
Overheating .......................... .567
Starting ............................. .465
Engine Oil Viscosity ...................... .620
Engine Oil Viscosity Chart ...................620
Enhanced Accident Response Feature ............89
Entry System, Illuminated ....................19
Ethanol ............................ .537, 540
Event Data Recorder ........................92
Exhaust Gas Caution ....................119,540
Exhaust System .......................119,622
10
INDEX 689