Making A Second Call While Current Call Is In
Progress..............................166
Natural Speech .....................128, 152
Place/Retrieve A Call From Hold ............166
Power-Up ........................... .179
Redial .............................. .167
Toggling Between Calls ...................167
Transfer Call To And From Mobile Phone . . .142, 173
Voice Command ....................... .173
Ways To Initiate A Phone Call ..............163
Uconnect Settings ...................... .22, 23
Uconnect Voice Command ...................185
Underhood Fuses ........................ .602
Uniform Tire Quality Grades .................635
Universal Consumer Interface (UCI) Connector . . . .385
Universal Transmitter ..................... .255
Unleaded Gasoline ....................... .498
Untwisting Procedure, Seat Belt ................54Vanity Mirrors
.......................... .123
Vehicle Certification Label ...................508
Vehicle Identification Number (VIN) .............6
Vehicle Loading ....................472, 508, 509
Vehicle Modifications/Alterations ...............7
Vehicle Security Alarm (Security Alarm) ..........18
Vehicle Storage .......................... .416
Viscosity, Engine Oil ...................... .567
Voice Command ......................... .185
Warning Flasher, Hazard ....................529
Warning Lights (Instrument Cluster Description) . . .317
Warnings And Cautions ......................6
Warranty Information ..................... .633
Washer Adding Fluid ......................... .576
Washers, Windshield ................231, 234, 576
Washing Vehicle ......................... .593
10
INDEX 659
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
