gas mileage DODGE MONACO 1965 1.G Owners Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 1965, Model line: MONACO, Model: DODGE MONACO 1965 1.GPages: 46, PDF Size: 8.12 MB
Page 14 of 46
INSTRUMENT CLUSTER DETAILS
Your instruments provide Inlormation about whars happening under the hood. That's why It 's a good idea lor you to check them frequently as you drive. Eye-ease paint is applied to the instrument cluster area to eliminate glare.
1. SPEEDOMETER-Located directly 10 front of you for easy visibility. At night the speedometer is softly lighted and glareless.
2. GASOLINE GAUGE-With ignition key in ON posillon the pointer will indicate the amount of fuel \0 gasoline tank.
3. ODOMETER-This group of numbers tells you tolal mileage the car has been driven in miles and tenths of miles.
4. TEMPERATURE GAUGE-Indicates engine coolant temperature. Pointer will normally slay near center while driving. If the pointer rises suddenly or remains on " H " while driving, stop car, turn oft engine and do not operate car until cause is located and corrected.
S. OIL PRESSURE LlGHT-A red glow informs you immediately if engine oil
pressure drops below normal. This light is
positive and unvarying, and catches your attention at once. Red light should not be on except momentarily when engine is first started or is operating at idle. If light stays on while driving, do not operate car until cause of low oil pressure is located and corrected. Light indicates lack of oil pressure, not the amount of oil in the crankcase.
6. ALTERNATOR INDICATOR-Indicates whether battery is being charged (" e ") or discharged (" 0") . Pointer will normally stay centered while driving when battery is fully charged and no lights or accessories are in use.
7. TURN SIGNAL INDICATORS-Light flashes in unison with outside lights when turn signal is applied. On Monaco models the turn signal indicators are located, instead on the front edge of each front fender.
9
Page 42 of 46
ENGINE OIL REQUIREMENTS
FIRST OIL CHANGE. The engine oil installed in your car's engine at time of assembly is h igh quality, "For Service MS" oil and
need not be removed until the first scheduled
oil change_ "Break-in" or "Flush-type" oils are no longer required in you r car's advanced
design engine and m ust be avoided.
WHEN TO ADD OIL It is not unusual for
a new engine to use a certain amount of engine oil during the break-in period. Check
oil level during each stop for gasoline. Add oil only when level on dipstick is al or below
the "ADD OIL" mark.
WHEN TO CHANGE OIL Regul.,. 011 changes .,.e required to provide proper engine operation.
Highway Driving, combined with some short
trip, slower speed operations extends the 38
effectiveness of the engine oil and permits you to change 011 at 4,000 miles Intervals.
Short Trips (less than 10 miles) and slow speeds, such as to the store, school, work
etc. and home again before the engine warms up, causes harmful condensation and sludge formation. This is typical of car operation in
city traffic. Driving under these conditions re
quires that you change 011 every 3 months regardless of mileage.
Severe Operating Conditions, such as fre
quent driving on dusty roads, or in sandy geographic areas, or unusually short trip
driving in cold weather may reasonably require 011 changes more frequently than
every three months. Under these conditions, consult and follow the advice of any Authorized Chrysler Motors Corporation Dealer's
Service Manager.
Shaded area covers region where minimum temperatures are consistently below + 10"F. during
winter months.
RE MMENDED ENGINE OIL GRADE
Multigrade Oils: SAE 20W-40 Suitable when temperatures are co nsistently abovl! + 32°F. SAE 10W·30 Suitable year-round for most parts of the United States; may be used where temperatures occasionally drop as low as -10°F . SAE 5W·20 Recommended where minimu m temperatures are consistently below + 10°F . durin g winter months, see map. Low viscosity o ils make en~ine starting easier in cold weather. Modern SAE 5W-20 grade oils may be safely used when minimum temperatures are expected to be consistently below + 10°F. Single Grade Oils. SAE 30 When temperature ranges averag e co nsistently above 32°F . SAE lOW When temperature ranges average between + 32° F . and -10°F .