service interval DODGE MONACO 1965 1.G Owners Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 1965, Model line: MONACO, Model: DODGE MONACO 1965 1.GPages: 46, PDF Size: 8.12 MB
Page 7 of 46
EXPLANATION OF WARRANTY AND SERVICE RESPONSIBILITIES
1. PRE-DElIVERY SERVICE: For your maximum satisfac
tion, your new cor has been inspected and prepared for delivery by your authorized selling dealer in accordance with the monufodurer's recommendations.
2. WARRANTY SERVICE: Your authorized selling dealer will perform any service which may become necessary under the Manufacturers Passenger Cor Warranty, and you should go to your selling dealer for such service if possible. If you cannot return to your selling dealer, however, any Chrysler Motors Corporation Authorized Dealer will honor the Manufacturer's Passenger Car Warranty.
3. TIRE WARRANTY: Your tires are warranted separately by the tire manufacturer. This provides, you protection against defects in workmanship and material under their
lifetime warranty, and against the hazards covered by their road hazard warranty. You may use this booklet to establish the delivery dote of your car to the tire manu · faclurer's represenlative should you require rood hazord type warranty service. Ad justments under either warranty will be based on .tread wear remaining ,and list price at lime of tire failure .
4. AIQPAR BATTERY SERVICE ADJUSTMENT POLICY: If the ballery on your vehicle should fail within 1 2 months
or 12,000 miles, whichever occurs flnt after delivery, it will be replaced at no cost . Thereafter, il will be replaced on a pro-rola adlustmenl basis up 10 36 monlhs from date of original vehicle purchase. The pro·rata adjustment provides you wilh a credit toward. the purcha.e of a new Mo Par Ballery, based on the number of months remaining in the pro· rata period at Ihe lime the battery is found defeelive. Thi. warranty does nol apply if the ballery has been damaged, abused, neglected or transferred to another vehicle.
5. REQUIRED MAINTENANCE SERVICES: The engine oil and oil Alter must be changed and the carburetor air folter cleaned and replaced as specifled in the warranty to assure protect ion under the 5 year/50,000 mile engine and drive t rain warranty coverage. At least every six months, a Chry.ler Motors Corporation Authorized Dealer must certify
on the form supplied wilh Ihe vehicle Ihal (11 you have furnished the dealer evidence thaI Ihe required mainlenance services have been performed, and (21 Ihe mileage then registered on the vehicle odometer. Any competenl service garage may perform Ihi. service; but we highly retommend you permit your Authorized Selling Dealer to perform these maintenance services as part of the CertiAed Cor Core systematic maintenance program.
6. OWNER'S RESPONS/B/lITY, Maintenance services such as the following are not covered by the warranly and are Ihe responsibility of the owner:
Moint.nonc. and Adjustmenls:
Periodic lubrication and adjustments that become necessary because of use and operation of the vehicle.
Engine oil-changing or adding Engine tune-up and electrical system checks front suspension alignment and wheel balance Tire rotation Drive belt adjustments
Replacement IIems:
Oil, air and fuel Alters . spark plugs, condenser . ignition points , crankcase yentilat ion valve
7. NOTICE OF TRANSFER OF OWNERSHIP: Within 30 days after acquir ing the cor, subsequent owners should have a Chrysler Motors Corporation Authorized Dealer submit a Notice of Transfer of Ownership to Chrysler Motors Corporation certify ing the mileage and service history of the vehicle. If previou. Owners have had the Required Service. performed and the Service Record and odometer mileages properly certifled at 6 month intervals, any remaining cover · age of the Manufacturer's Passenger Cor Warranty will continue to apply. 3
Page 8 of 46
z
o
-t-U 1&1 t-
O D: IL
4
HUW YOU CAN ENJOY· PROTECTION AND DRIVING SATISFACTIO
*
REQUIRED MAINTENANCE SERVICES
The following maintenance services ore required to assure full consideration under
the 5 year/50,OOO mile coverage of the Manufacturer's Passenger Car Warranty.
FIRST Oil CHANGE: The engine oil need not be removed until the flrst scheduled oil change .
WHEN TO ADD OIL: It's not unusual for a new engine to use a certain amount of engine oil during the break-in period. Check oil level during each stop for gasoline. Add oil only when level on dip stick is at or below the "ADD OIL" mark.
SELECTION OF O IL : Use only oils "For Service MS" and of the proper SAE grade for the overage temperature in your area. See Engine Oil Recommendations. poge 38.
SERVICE INTERVALS
Page 41 of 46
E) Coolant Level: Have the coolant level checked during each stop at the gasoline station. Add water to bring level to about 11,4' below the bottom of the filler neck. Overfilling will dilute the anti·freeze and also result in coolant loss through the overflow tube. CAUTION: Driving In heavy traffic, at high altitudes, or in very hot weather may build up pressure in the cooling system. When removing the cap place a cloth over the cap, turn left to first stop, allowing steam to escape through overflow tube, then remove cap.
Thermostat Your new car is equipped with 180 degree thermostat for use with perma· nenl-type anti-freeze. If you later prefer an lcohol type anti-freeze use only a 160 degree thormoslat.
Manifold Heal Control Valve_ A cold engine will warm up faster and accelerate more moothly if the valve that controls heat flow In the manifold works freely. It is normal for I d deposits to accumulate in time on the y lve shaft causing it to tighten up'. Manifold II t Control Valve Solvent, available from your dealer, should be applied a t six month lnt Iva Is. Slide shaft in and out and rotate a
, w times to distribute the solvent. Apply only when manifold is cool.
The Carburetor A ir Filter. The special easy to change fire-resistant filter installed in your carburetor should be cleaned and inspected every 6 months and replaced once every two years, to assure good fuel economy. Clean or replace more often when car is driven in dusty or sandy areas. Replace filter if damaged. DO NOT wash or oil. Simply remove the metal container, unscrew the wing nut and lift out filter. Clean with compressed air, holding nozzle about two inches from filter.
Fuel Filter. Your new car has a filter in the fuel tank to prevent water and foreign material from entering the fuel system. There is also a fuel filter in the fuel line at the fuel pump outlet. If this filter is plugged it can limit car speed and cause hard starling. Under normal operating conditions the filter should be changed at 20,000 mile intervals, or every two years.
011 Cap Filler. The cap on the oil filler tube is a combination ventilator and permanent filter. The filter inside the cap should be kept clean to allow clean air to remove combustion product s from the crankcase. To clean the filter wash the entire cap periodically in k ero sene and relubricate with SAE 30 engine oil.
ENGINE PERFORMANCE EVALUATION
Engine operation efficiency depends on correct ignition, carburetor adjustments, and on valve lash where applicable. To obtain best engine performance, Chrysler Corporation recommends that the engine be evaluated every 10,000 miles and tuned, if necessary. Services performed during this evaluation should include the following:
SPARK PLUGS-Remove and inspect each spark plug. Most plugs can be cleaned, adjusted, and reinstalled. Rough idle, hard starling, frequent engine miss at high speeds, or apparent physical deterioration, are indications that the spark plugs should be replaced.
DISTRIBUTOR-Clean and inspect the dis· tributor cap and rotor if required (wash cap in household detergent and water solution). Check breaker points for abnormal pitting. distributor secondary wires and tower caps are clean and connected properly. See that ignition timing is set to vehicle specifications.
CARBURETOR-Remove and clean air filter. Check operation of manifold heat control valve and choke diaphragms, use solvent recommended. Clean crankcase ventilator system. Check and adjust choke fast-idle cam and fuel mixture.
BATTERY-Check specific gravity. Clean and tighten terminals; apply grease to post and terminals. Check circuit voltages.
37
Page 42 of 46
ENGINE OIL REQUIREMENTS
FIRST OIL CHANGE. The engine oil installed in your car's engine at time of assembly is h igh quality, "For Service MS" oil and
need not be removed until the first scheduled
oil change_ "Break-in" or "Flush-type" oils are no longer required in you r car's advanced
design engine and m ust be avoided.
WHEN TO ADD OIL It is not unusual for
a new engine to use a certain amount of engine oil during the break-in period. Check
oil level during each stop for gasoline. Add oil only when level on dipstick is al or below
the "ADD OIL" mark.
WHEN TO CHANGE OIL Regul.,. 011 changes .,.e required to provide proper engine operation.
Highway Driving, combined with some short
trip, slower speed operations extends the 38
effectiveness of the engine oil and permits you to change 011 at 4,000 miles Intervals.
Short Trips (less than 10 miles) and slow speeds, such as to the store, school, work
etc. and home again before the engine warms up, causes harmful condensation and sludge formation. This is typical of car operation in
city traffic. Driving under these conditions re
quires that you change 011 every 3 months regardless of mileage.
Severe Operating Conditions, such as fre
quent driving on dusty roads, or in sandy geographic areas, or unusually short trip
driving in cold weather may reasonably require 011 changes more frequently than
every three months. Under these conditions, consult and follow the advice of any Authorized Chrysler Motors Corporation Dealer's
Service Manager.
Shaded area covers region where minimum temperatures are consistently below + 10"F. during
winter months.
RE MMENDED ENGINE OIL GRADE
Multigrade Oils: SAE 20W-40 Suitable when temperatures are co nsistently abovl! + 32°F. SAE 10W·30 Suitable year-round for most parts of the United States; may be used where temperatures occasionally drop as low as -10°F . SAE 5W·20 Recommended where minimu m temperatures are consistently below + 10°F . durin g winter months, see map. Low viscosity o ils make en~ine starting easier in cold weather. Modern SAE 5W-20 grade oils may be safely used when minimum temperatures are expected to be consistently below + 10°F. Single Grade Oils. SAE 30 When temperature ranges averag e co nsistently above 32°F . SAE lOW When temperature ranges average between + 32° F . and -10°F .