child restraint DODGE POWER WAGON 2006 2.G User Guide

Pull the belt from the retractor until there is enough to
allow you to pass through the child restraint and slide
the latch plate into the buckle. Then pull on the belt
until it is all removed from the retractor. Allow the belt
to return to the retractor, pulling on the excess web-
bing to tighten the lap portion about the child re-
straint. Refer to theAutomatic Locking Retractors
(ALR) Modeearlier in this section.
•In the rear seat, you may have trouble tightening the
lap/shoulder belt on the child restraint because the
buckle or latch plate is too close to the belt path
opening on the restraint. Disconnect the latch plate
from the buckle and twist the short buckle-end belt
several times to shorten it. Insert the latch plate into
the buckle with the release button facing out.
•If the belt still can’t be tightened, or if pulling and
pushing on the restraint loosens the belt, disconnect
the latch plate from the buckle, turn the latch plate
around, and insert the latch plate into the buckle
again. If you still can’t make the child restraint secure,
try a different seating position.
•Buckle the child into the seat according to the child
restraint manufacturer’s directions.
•When your child restraint is not in use, secure it in the
vehicle with the seat belt or remove it from the vehicle.
Do not leave it loose in the vehicle. In a sudden stop or
collision, it could strike the occupants or seat backs
and cause serious personal injury.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 61
2

WARNING!
Improper installation can lead to failure of an infant
or child restraint. It could come loose in a collision.
The child could be badly injured or killed. Follow
the manufacturer’s directions exactly when install-
ing an infant or child restraint.
Lower Anchors and Tether for CHildren (LATCH)
Each vehicle is equipped with the child restraint anchor-
age system called LATCH, which stands for Lower
Anchors and Tether for CHildren. LATCH child restraint
anchorage systems are installed in the Standard Cab
passenger seat position and the Quad Cab rear seat
outboard positions. LATCH equipped seating positions
feature both lower anchor bars, located at the back of the
seat cushion, and tether strap anchorages, located behind
the seatback (refer to Child Restraint Tether Anchor later
in this section).Identification dots are located above the standard cab
front seat lower anchorages as a guide for locating lower
anchors.
NOTE:For children riding in the front seat of a Stan-
dard Cab model refer to the “Passenger Airbag On/Off
Switch” located in this section.
Standard Cab Passenger Seat
62 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Child restraint systems having attachments designed to
connect to the lower anchorages are now available. Child
restraints having tether straps and hooks for connection
to the seatback tether anchorage have been available for
some time. In fact, many child restraint manufacturers
will provide add-on tether strap kits for some of their
older products.
Because the lower anchorages are to be introduced to
passenger carrying vehicles over a period of years, child
restraint systems having attachments for those anchor-
ages will continue to have features for installation in
vehicles using the lap or lap/shoulder belt. They will also
have tether straps, and you are urged to take advantage
of all of the available attachments provided with your
child restraint in any vehicle.
NOTE:When using the LATCH attaching system to
install a child restraint, please ensure that all seat belts
not being used for occupant restraints are stowed and out
Quad Cab Rear Outboard Seats
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 63
2

of reach of children. It is recommended that before
installing the child restraint, buckle the seat belt so the
seat belt is tucked behind the child restraint and out of
reach. If the buckled seat belt interferes with the child
restraint installation, instead of tucking the seat belt
behind the child restraint, route the seat belt through the
child restraint belt path and then buckle it. This should
stow the seat belt out of the reach of an inquisitive child.
Remind all children in the vehicle that the seat belts are
not toys and should not be played with, and never leave
your child unattended in the vehicle.
NOTE:If your child restraint seat is not LATCH com-
patible, install the restraint using the vehicle seat belt.Installing the Child Restraint System
WARNING!
Do not install child restraint systems equipped with
LATCH attachments in the center position of a Quad
Cab model rear seat. The LATCH anchorages in this
seat are designed for the two outboard seating posi-
tions only. A child may be placed in the rear center
seating position of a Quad Cab model using the seat
belt and child tether anchorage. Failure to follow this
may result in serious or fatal injury.
We urge that you carefully follow the directions of the
manufacturer when installing your child restraint. Many,
but not all, restraint systems will be equipped with
separate straps on each side, with each having a hook or
connector and a means for adjusting the tension in the
strap. Forward-facing toddler restraints and some
64 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

rearward-facing infant restraints will also be equipped
with a tether strap, a hook and means for adjusting the
tension in the strap.
In general, you will first loosen the adjusters on the lower
straps and tether straps so that you can more easily attach
the hook or connector to the lower anchorages and tether
anchorages. Then tighten all three straps as you push the
child restraint rearward and downward into the seat.
Not all child restraint systems will be installed as we
have described here. Again, carefully follow the instruc-
tions that come with the child restraint system.WARNING!
Improper installation of a child restraint to the
LATCH anchorages can lead to failure of an infant or
child restraint. The child could be badly injured or
killed. Follow the manufacturer’s directions exactly
when installing an infant or child restraint.
Child Restraint Tether Anchor
Child restraints having tether straps and hooks for con-
nection to tether anchors have been available for some
time. In fact, many child restraint manufacturers will
provide add-on tether strap kits for their older products.
Regular Cab models of Ram Pickups have two tether
anchorages, one each behind the front center and right
seats. Quad Cab models have three anchorages, one
behind each of the rear seats.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 65
2

WARNING!
An incorrectly anchored tether strap could lead to
seat failure and injury to the child. In a collision, the
seat could come loose and allow the child to crash
into the inside of the vehicle or other passengers, or
even be thrown from the vehicle. Use only the
anchor positions directly behind the child seat to
secure a child restraint top tether strap. Follow the
instructions below. See your dealer for help if nec-
essary.
Tether Anchorage Points at the Right and Center
Front Seat (Regular Cab - All Seats)
1. Place the child restraint on the seat and adjust the
tether strap so that it will reach over the seat back under
the head restraint to the tether anchor directly behind the
seat.2. Lift the cover (if so equipped), and attach the hook to
the square opening in the sheet metal.
3. Install the child restraint and remove the slack in the
tether strap according to the manufacturer’s instructions.
Regular Cab Tether Strap Mounting
66 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Multiple Child Restraint Installation Sequence -
(Quad Cab Rear Seats)
1. Obtain tether straps by raising the head restraints and
reaching between the rear glass and rear seat. The tether
strap may be retained with an elastic band. Accessibility
to the tether strap is greatly improved by raising the seat
cushion to the “up” position. Remove the elastic before
use.
2. Place a child restraint on each outboard rear seat and
adjust the tether strap so that it will reach under the head
restraint to the tether anchor directly behind the seat and
then to the anchor directly behind the center rear seat.
3. Pass each tether strap hook under the head restraint
and through the loop of webbing behind the child seat.4. Route each tether strap to the anchor behind the center
seat, and attach the hooks to the metal ring.
5. Place a child restraint on the center rear seat and
adjust the tether strap so that it will reach under the head
restraint to the tether anchor directly behind the seat and
to the anchor directly behind the right seat.
6. Install each child restraint and remove the slack in the
tether strap according to the child restraint manufactur-
er’s instructions.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 67
2

B-Pillar Location........................ 301
Brake Fluid............................ 419
Brake System........................293,389
Anti-Lock........................... 294
Disc Brakes.......................... 389
Hoses.............................. 391
Master Cylinder....................... 389
Parking............................. 292
Warning Light........................ 173
Break-In Recommendations, New Vehicle........ 69
Bulb Replacement....................... 407
Bulbs,Light ............................ 406
Cab Top Clearance Lights.................. 414
Calibration, Compass..................... 139
Camper............................... 160
Capacities, Fluid........................ 417
Caps, Filler
Oil (Engine).......................... 373Power Steering........................ 380
Car Washes............................ 401
Carbon Monoxide Warning............ 71,162,322
CargoLight ............................ 125
Cassette Tape and Player Maintenance......... 211
Catalytic Converter....................323,376
CD Player.......................177,182,195
Cellular Phone.......................... 90
Center High Mounted Stop Light............ 412
Center Lap Belts......................... 42
Center Seat Storage Compartment............ 154
Certification Label....................... 324
Chart, Tire Sizing........................ 298
Check Engine Light (Malfunction Indicator Light) . 172
Child Restraint........................ 57,58
Child Restraint Tether Anchors............. 62,65
Child Seat............................ 58,64
Cigar Lighter........................... 152
Climate Control......................... 213
INDEX 453
10

Ignition............................. 15,275
Key ............................... 12,15
Lock................................ 15
Infant Restraint........................ 57,58
Inflation Pressure Tires.................... 314
Inside Rearview Mirror.................... 84
Instrument Cluster....................167,168
Instrument Panel and Controls.............. 166
Instrument Panel Lens Cleaning............. 404
Interior Appearance Care.................. 403
Interior Lights.......................... 121
Intermittent Wipers...................... 128
Introduction............................. 4
Jack Location........................... 348
Jack Operation.......................... 350
Jump Starting.......................... 356
Key, Replacement........................ 13Key, Sentry............................. 13
Key-In Reminder......................... 12
Keyless Entry System...................... 22
Keys................................ 12,17
Lane Change and Turn Signals.............. 125
LapBelts .............................. 42
Lap/Shoulder Belts....................... 34
LATCH (Lower Anchors and Tether for CHildren) . 62
Lights .............................. 72,121
Airbag............................ 55,169
Anti-Lock Warning..................173,294
Brake Warning........................ 173
Bulb Replacement...................406,407
Cap Top Clearance..................... 414
Cargo .............................. 125
Center Mounted Stop................... 412
Check Engine......................... 172
Courtesy/Reading..................... 134
458 INDEX

Programming Transmitters..............143,147
Radial Ply Tires......................... 308
Radiator Cap (Coolant Pressure Cap).......385,388
Radio Operation...................177,182,195
Radio Remote Controls.................... 210
Radio, Satellite.......................... 209
Radio (Sound Systems)..............177,182,195
Ramp Travel Index....................... 236
Rear Axle............................. 391
Rear Wheel Bearings..................... 396
Reclining Front Seats..................... 115
Recorder, Event Data...................... 56
Recreational Towing...................... 341
Shifting into Transfer Case Neutral (N)....... 342
Shifting out of Transfer Case Neutral (N)..... 343
Reformulated Gasoline.................... 317
Refrigerant............................ 380
Relays and Flashers...................... 405Reminder, Seat Belt....................... 43
Remote Keyless Entry..................... 22
Remote Sound System Controls.............. 210
Replacement Tires....................... 312
Reporting Safety Defects................... 447
Restraint, Head......................... 115
Restraints, Child....................... 57,64
RideHeight ............................ 81
Rotation, Tires.......................... 316
Safety Checks Inside Vehicle................. 72
Safety Checks Outside Vehicle............... 72
Safety Defects, Reporting.................. 447
Safety Information, Tire................... 296
Safety Tips............................. 70
Satellite Radio.......................... 209
Schedule, Maintenance.................... 422
Seat Belt Maintenance.................... 404
Seat Belt Reminder....................... 43
462 INDEX