section 5 DODGE RAM 1500 1998 2.G Owner's Guide

DODGE RAM 1500 1998 2.G Owner's Guide RAM 1500 1998 2.G DODGE DODGE https://www.carmanualsonline.info/img/12/5702/w960_5702-0.png DODGE RAM 1500 1998 2.G Owner's Guide

Page 480 of 2627

DODGE RAM 1500 1998 2.G Owners Guide (5) Install the appropriate seat cushion or seat
back trim cover. Make certain the seat wire harness
is correctly routed through the seat and seat back.
HEATED SEAT SENSOR
DESCRIPTION
The heated seat

Page 483 of 2627

DODGE RAM 1500 1998 2.G Owners Guide The heated seat module is an electronic micropro-
cessor controlled device designed and programmed to
use inputs from the battery, the two heated seat
switches and the two heated seat sensors to opera

Page 504 of 2627

DODGE RAM 1500 1998 2.G Owners Guide SPARK PLUG
DESCRIPTION
Resistor type spark plugs are used on all engines.
Sixteen spark plugs (2 per cylinder) are used with
5.7L V-8 engines.
DIAGNOSIS AND TESTING - SPARK PLUG
CONDITIONS
To prevent

Page 508 of 2627

DODGE RAM 1500 1998 2.G Owners Guide (4) Install ignition coil(s). Refer to Ignition Coil
Removal/Installation.
5.7L V-8
(1) Special care should be taken when installing
spark plugs into the cylinder head spark plug wells.
Be sure the pl

Page 571 of 2627

DODGE RAM 1500 1998 2.G Owners Guide (3) Install the bolts attaching headlamp unit to the
fender (Fig. 11).
(4) Align the seal and install the push pins.
(5) Connect the battery negative cable.
ADJUSTMENTS
Headlamps can be aligned using

Page 582 of 2627

DODGE RAM 1500 1998 2.G Owners Guide (4) Push the right side of the lamp in the head-
liner opening and push the lamp lens up into the
lamp to secure (Fig. 1).
DOOR AJAR SWITCH
DESCRIPTION
The door ajar switches are integral to the door

Page 587 of 2627

DODGE RAM 1500 1998 2.G Owners Guide The compass unit also will compensate for magne-
tism the body of the vehicle may acquire during nor-
mal use. However, avoid placing anything magnetic
directly on the roof of the vehicle. Magnetic mo

Page 588 of 2627

DODGE RAM 1500 1998 2.G Owners Guide SELF-DIAGNOSTIC TEST
A self-diagnostic test is built-in to the module to
determine that the electronics module is operating
properly, and that all the J1850 PCI data bus mes-
sages are being received

Page 592 of 2627

DODGE RAM 1500 1998 2.G Owners Guide NOTE: If a new module has been installed, the com-
pass will have to be calibrated and the variance set.
Refer to Compass Variation Adjustment and Com-
pass Calibration in the Standard Procedures sec-

Page 593 of 2627

DODGE RAM 1500 1998 2.G Owners Guide Reset push button twice within three seconds will
perform a global reset, and all of the trip computer
information that can be reset will be reset to zero.
With the ignition switch in the On position