engine oil DODGE SPRINTER 2005 1.G Owner's Manual

220 MAINTAINING YOUR VEHICLEApproved Engine OilsNOTE: Use only engine oils that are labeled on the
container as meeting the specifications of API (American
Petroleum Institute) and/or DaimlerChrysler specification
sheets MB 228.3, 228.5, 229.3 and 229.5, such as MOPAR®
SAE 15W-40 HD Diesel Engine Oil (e.g. MOPAR® Part
No. 04798231AD), or equivalent.Always refer to the following viscosity chart for the
proper viscosity grade based on ambient temperature.
Select oil viscosity according to the lowest air
temperature expected before the next oil change.
For further information, contact your authorized
Sprinter Dealer. NOTE: This chart supercedes ALL previously
published viscosity charts.

MAINTAINING YOUR VEHICLE 221
7
Engine Oil Level1. Oil dipstick
2. Oil filler neck Check the engine oil level at regular intervals with the
vehicle standing on a level surface.
 Check engine oil level about 5 minutes after
stopping the engine, which should have reached its
regular operating temperature. The normal
operating temperature should have been reached
and maintained for some time.
 Wipe the dipstick clean with a lint-free cloth before checking.
The engine oil level must be between the
lower (MIN) and upper (MAX) marks on
the dipstick.
Add engine oil only up to the MAX mark.
Excess oil must be drained or siphoned off.

222 MAINTAINING YOUR VEHICLERibbed V-BeltThe ribbed V-belt drives the accessories, such as
generator, coolant pump and hydraulic steering pump.
The ribbed V-belt is automatically kept tensioned.
Check the state of the ribbed V-belt regularly, such as
at every engine oil level check.
The belt must not be damaged, worn, oiled or glazed.
There must be no cracks in the belt running surface.
Replace damaged belts.
Hydraulic Brake System, Clutch Mechanism Fluid
Level1. Brake fluid reservoir
Brake fluid level must be between the MIN and MAX
marks in the reservoir (1).
If the brake fluid is below the MIN mark, there may be
a fault in the hydraulic system. Have the system
checked as soon as possible by an authorized Sprinter
Dealer.

MAINTAINING YOUR VEHICLE 223
7
Brake fluidRefer to the "Recommended Fluids" chart later in this
section for recommended brake fluids.
In the course of its service life, the boiling point of the
brake fluid will fall due to the continuous absorption of
moisture from the atmosphere.
If the brakes are placed under heavy loads (e.g., on
steep hills) bubbles of steam can then form in the brake
system.
This will adversely affect the brakes' effectiveness.Engine Cooling SystemThe use of aluminum components in Sprinter engines
requires that anticorrosive/antifreeze specifically
formulated to protect aluminum parts be used. The
factory approved Service Products are suitable for
Sprinter engines and can be mixed with the original
anticorrosion/antifreeze filled in at factory.
Cooling system design and anticorrosion/antifreeze
agent used stipulate the replacement interval for the
coolant solution in your vehicle. Please observe the
replacement interval specified in the Service Booklet
for your vehicle.
Failure to use MB 325.0 an ticorrosion/antifreeze and/or
equivalent to DaimlerChrys ler material standard MS-
9769 and/or adhere to the specified replacement interval
may result in a significantly shortened service life.For coolant composition and water quality, contact
your authorized Sprinter Dealer.Engine CoolantThe coolant is a mixture of water and a corrosion
inhibitor/antifreeze additive. Within the cooling
system, the corrosion inhibitor/antifreeze ensures
 anti-corrosion protection
 antifreeze protection
 a higher boiling point.
The coolant added in the factory ensures adequate
antifreeze and anti-corrosion protection.
Refer to the "Recommended Fluids" chart for coolant
recommendations.
For reasons of anti-corrosion protection and to increase
the boiling point, the cool ant added to the cooling
system is designed for all year round operation – even
in countries with high prevailing temperatures.

226 MAINTAINING YOUR VEHICLE
If the engine is already at its regular operating
temperature:
Add coolant until the coolant level is about 0.6 inch
(1.5 cm) above the base area which is visible
through the filler opening.
 Replace and tighten the radiator cap.
If a large quantity of coolant has been lost, or if smaller
amounts are lost at regular intervals, have the engine
cooling system examined by an authorized Sprinter
Dealer.
For coolant composition and water quality, contact
your Sprinter Dealer.
WINTER OPERATIONHave your vehicle winterized by an authorized
Sprinter Dealer before the onset of winter.
 Have the engine oil changed, if the engine oil filled is not approved for winter use.
 Coolant: antifreeze/anti-corrosion concentration in the coolant checked.
 Windshield washer system: add winter concentrate to the washer fluid.
 Battery: the battery will lose capacity as temperatures drop. Only a well-charged battery will
ensure reliable engine starting even at low outside
temperatures.
 Tires: fit M+S radial tires, taking note of the maximum permissible speed of the tires fitted.

MAINTAINING YOUR VEHICLE 257
7
CAPACITIES
Engine with oil filter Engine oil Fuel tank Cooling system Windshield washer
system
Including
reserve fuel
All vehicles about 9.5 US qt
(9.0 l) about
26.4 US gal
(100 l) about
2.8 US gal
(10.5 l) about
2.7 US gal
(10.0 l) about
7.4 US qt
(7.0 l)

258 MAINTAINING YOUR VEHICLERecommended Fluids and LubricantsThe manufacturer recommends for your vehicle model
the use of DaimlerChrysler approved fluids and
lubricants, e.g. engine oil, gear oil, automatic
transmission fluid, brake fluid, power steering fluid,
coolant and anti-corrosion/anti-freeze fluid only.
WARNING!
Failure to use fluids and lubricants which meet
the standards and specifications described in this
booklet or failure to adhere to the specified re-
placement intervals may result in damage to safe-
ty-related systems of your vehicle, such as the
brake system, which could cause an accident and/
or serious injury to you and others.
Use only fluids and lubricants meeting the
standards and specifications and adhere to
specified replacement intervals.
CAUTION!
Failure to use fluids and lubricants which meet
the standards and specifications described in this
booklet or failure to adhere to the specified
replacement intervals may result in a significantly
shortened service life and/or damage to
components of your vehicle, the repair of which
will not be covered by Warranty.
Use only fluids and lubricants meeting the
standards and specifications and adhere to
specified replacement intervals.

MAINTAINING YOUR VEHICLE 259
7
The following oils have been determined to meet DaimlerChrysler requirements.aMB approved Engine Oil SAE MB Sheet
76 Pure Synthetic Motor Oil 5W-40 229.3
76 Royal Triton QLT 15W-40 228.3
Agip All Guard Motor Oil 15W-40 228.3
Agip Eurosport 5W-40 229.3
Agip Synthetic PC 5W-40 229.3
Akron Ultra Clear C1-4
1
15W-40 228.3
BP Vanellus C6 Global Plus 10W-40 228.3
Brad Penn Euro-Diesel LD 15W-40 228.3
Castrol Elixion
1
5W-30 228.5
Castrol Tection S
1
15W-40 228.3
Chevron Delo 400 Multigrade 15W-40 228.3
Diesel Special Benz M&A 15W-40 228.3
Dislub Premium 15W-40 228.3
Exxon XD-3 Extra
1
15W-40 228.3
FormulaShell Ultra 5W-40 229.3
FormulaShell Ultra AB 5W-30 229.5
Gonher Super Fleet MB-III 15W-40 228.3
Hydroclear Power-D Engine Oil 15W-40 228.3
IDO Premium 15W-40 15W-40 228.3
Kendall GT-1 Full Synthetic Motor Oil 5W-40 229.3
Long Life EF Diesel Engine Oil Multi-
grade 15W-40 228.3
Lubral Super Diesel MB-III 15W-40 228.3
Max Raloy Diesel 5W-30 228.5
MBMotorenöl000989600113 10W-40 228.5
Mexlub CF-4 MB-3P 15W-40 228.3
Mobil 1 0W-40 0W-40 229.5
Mobil Delvac 1 5W-40 228.5
Mobil Delvac 1300 Super
1
15W-40 228.3
Mobil SHC Formula MB 5W-30 229.5
MOPAR
®Part No. 04798231AD 15W-40 228.3
Motul 8100 E-Tech 0W-40 0W-40 229.3
Motul 8100 X-cess 5W-40 5W-40 229.3
Panolin Indy SV 5W-40 229.3
Pennzoil European Formula Ultra 5W-30 229.5
Pennzoil Synthetic European Formula 5W-40 229.3
Premium Synthetik Motorenöl 5W-30 229.5
QS Superfleet 15W-40 228.3
Quaker State European Formula Ultra 5W-30 229.5
Quaker State Full Synthetic European For-
mula 5W-40 229.3
Quaker State Super Series III
1
15W-40 228.3
Raloy Diesel Turbo MX 15W-40 228.3

260 MAINTAINING YOUR VEHICLE1. Engine oil also meets API classification CI-4. Other oils may meet requirements - see oil label to determine.Raloy Motor Diesel 15W-40 228.3
Repsol Turbo UHPD 10W-40 228.5
Roshfrans Voltro Diesel
1
15W-40 228.3
Shell Helix Ultra 5W-30 229.3
Shell Helix Ultra 5W-40 229.3
Shell Rimula X CH-4 15W-40 228.3
Shell Rimula X CH-4 20W-50 228.3
Shell Rotella T Multigrade
1
15W-40 228.3
Super Diesel Oil MB-3 15W-40 228.3
Supreme Duty Diesel Engine Oil Multi-
grade 15W-40 228.3
Unoil GX-7 5W-40 229.3
Ursa Premium TDX 10W-30 228.3
Ursa Premium TDX 15W-40 228.3
Valvoline SynPower MXL 0W-30 229.3

MAINTAINING YOUR VEHICLE 261
7
COMPONENT SERVICE INTERVAL PRODUCT NAME/PRODUCT NUMBER MB
SHEET
Air Conditioning
The air conditioning system of your vehicle contains R-134a, a refrigerant that does not deplete the ozone layer in the
upper atmosphere.
Refrigerant R-134a — Refrigerant R-134a 361.0 Automatic
Transmission Fluid once only at
80,000 mi
(128,000 km) Shell ATF 3403/M-115
MOPAR® Part No. 05127382AA, or equivalent
Fuchs/Shell ATF 3353 236.10
236.12
Brakes
Use brake fluid approved to DaimlerChr ysler standard MB 331.0 and/or DaimlerChrysler material standard MS-9971,
brake fluid certified to DOT 4 Plus standards, that also ma intains a minimum dry boiling point (ERBP) of 500°F (260°C),
a minimum wet boiling point (WERBP) of 356°F (180°C) and maximum viscosity of 1500 mm
2/s, conforming to FMVSS
116 and ISO 4925.
Brake Fluid 2 years Intac B026D Dry boiling point: 500°F (260°C )
Wet boiling point: 356°F (180°C),
MOPAR® MS-9971 Part No. 04549625AC, or equivalent 331.0
Engine Oil 12 months or 10,000 mi
(16,000 km) See "Approved Engine Oils"