radio controls DODGE SPRINTER 2007 2.G Owners Manual

67 Controls in detail
Key positions
3
\3 Key positions0 To remove the key, to lock the steering
wheel
1 To unlock the steering wheel (power
supply for some consumers, e.g. radio)
2 To switch on the ignition (power supply
for all consumers)
Preglow
1 and drive position
3 To start
1 Only vehicles with a diesel engine
iThe key can only be removed from
position0. Also observe the notes in
the “Driving and parking” section
(\2page 110).
To unlock the steering, turn the steer-
ing wheel slightly while turning the key
to position 1.
On vehicles with a battery isolating
switch, you must first switch on the
electrical system (\2page 198).

90 Controls in detailOperating system with steering wheel buttons*
3
Several functions are combined themati-
cally in the menus.
The display changes when you press one of
the buttons on the steering wheel.
For example, the
AUDIO
menu contains
functions for controlling the radio* or CD
player*. You can use a function to call up
information or to change the settings for
the vehicle.You can think of the order of the menus
and of the functions within a menu as a cir-
cle:
\4If you keep pressing theè or ÿ
button, each menu will appear one af-
ter the other.
\4If you keep pressing thej or k
button, each function in the same
menu will appear one after the other.The
Settings
menu contains submenus in-
stead of functions with which you can call
up or change a setting. The way in which
you operate these submenus is described
in the “Settings menu” section
(\2page 96).
The number of menus depends on the op-
tional equipment installed in your vehicle.
The menus in vehicles with COMAND APS*
are described below.

92 Controls in detailOperating system with steering wheel buttons*
3
The table below shows the menus and the individual functions.
Menu 1
Menu 2
Menu 3
Menu 4
Menu 5
Menu 6
Menu 7
Operation
Audio*
Navigation*
Malfunction
memory
Settings
Trip computer
Telephone*
Commands / submenusStandard display with
trip meter and odometer
Select a radio
station
Activate route
guidance
Display
malfunctions
Reset to
factory
settings
Consumption sta-
tistics after start
Enter PIN
Display coolant tempera-
ture
Operate the
CD player/
CD changer
Instrument
cluster sub-
menu
Consumption sta-
tistics after reset
Look for a
name in the
phone book
Call up the service due
date
Clock/Date
submenu
Look for the
most recently
dialed phone
numbers
Tire pressure monitor
Lighting sub-
menu
Check the engine oil
level (only on vehicles
with a diesel engine)
Vehicle
submenuAuxiliary heat-
ing* submenuConvenience*
submenu

94 Controls in detailOperating system with steering wheel buttons*
3
The temperature displayed may climb to
250 °F (120 °C) when the vehicle is being
driven in normal conditions and if the cool-
ant contains the correct concentration of
corrosion inhibitor and antifreeze. It is ac-
ceptable for the coolant temperature to
rise to the end of the scale at high outside
temperatures and when driving in moun-
tainous terrain.You can use the functions in the
Audio

menu to control the audio equipment that
you have just switched on.
If no audio equipment is switched on, you
will see the
AUDIO off
message (Sound 5
or Sound 20) or
AUDIO off
(COMAND APS*).
Selecting a radio station
\1Switch on the radio.
See the separate operating instruc-
tions.
\1Press the è or ÿ button repeat-
edly until you see the station currently
selected.1Reception frequency
2Waveband, with memory location num-
ber if set
\1Press thej or k button repeat-
edly until you have found the desired
station.
Operating the CD player
\1Switch on the radio and select the CD
player.
See the separate operating instruc-
tions. N54.32-2251-31Audio menu*Function
Page
Select a radio station
94
Operate the CD player/CD
changer
94
iIt is only possible to save new stations
using the radio itself. See the separate
operating instructions.
You can also operate the radio in the
same way as usual.

104 Controls in detailOperating system with steering wheel buttons*
3
Setting the exterior lighting delayed
switch-off*
The
Headlamps
(headlamps delayed switch-
off) function enables you to set whether or
not the exterior lighting should remain on
in the dark after the doors have been
closed.
When you have set the delayed switch-off
and have switched off the engine, the fol-
lowing light up:
\4The parking lamps
\4The tail lamps
\4The license plate lamp
\4The front foglamps\1Press theæ or ç to select the
Lighting
submenu.
\1Press thej or k button repeat-
edly until you see the
Headlamps
mes-
sage in the display.
The current setting is highlighted.
\1Press the æ or ç button to se-
lect whether and for how long the lights
should remain on.Vehicle submenu
You can reach the
Vehicle
submenu via
the
Settings
menu (\2page 96).
Setting station selection
The
Search
function enables you to deter-
mine whether the radio (\2page 94)
should search for a new station or a previ-
ously stored station each time the radio is
switched on.
\1Press the è or ÿ button repeat-
edly until you see the
Vehicle
message
in the display.
\1Press thej or k button repeat-
edly until you see the
Search
message
in the display.
The current setting is highlighted.
iYou can reactivate this function by
opening a door within 10 minutes.
The lights are switched off after 60 sec-
onds if you do not open a door or if you
close an opened door after the engine
has been switched off.
N54.32-2270-31
Function
Page
Set station selection
104
Set the windshield wiper sensi-
tivity
105
\2\2

105 Controls in detail
Operating system with steering wheel buttons*
3
\1Press the æ or ç button to se-
lect how the radio should tune into a
station.
\4
Frequency
: The nearest station on
the waveband is selected
\4
Memory
: The nearest saved station is
selected
Setting the windshield wiper sensitivity
You can use the
Wipe sensor
function to
set the sensitivity of the rain sensor.
\1Press the è or ÿ button repeat-
edly until you see the
Vehicle
message
in the display.\1Press thej or k button repeat-
edly until you see the
Wipe sensor
mes-
sage in the display.
The current setting is highlighted.
\1Press the æ or ç button to
select the level of sensitivity of the rain
sensor.
\4
Level 1
: High sensitivity
Wiping beings in light rain
\4
Level 2
: Moderate sensitivity
\4
Level 3
: Low sensitivity
Wiping only begins in heavy rainConvenience submenu
*
You can reach the
Convenience
submenu
via the
Settings
menu (\2page 96).
Key-dependent settings
You can use the Key
function to determine
whether the settings in the:
\4Instrument cluster
\4Lighting
\4Vehicle
submenus are stored as key-dependent
settings.
\1Press the è or ÿ button repeat-
edly until you see the
Convenience
mes-
sage in the display.
\1Press thej or k button repeat-
edly until you see the
Key
message in
the display.
The current setting is highlighted. N54.32-2271-31
N54.32-2272-31
N54.32-2273-31