roof DODGE SPRINTER 2008 2.G User Guide

258 Controls in detailDriving systems
3
Switching Parktronic on/off You can switch Parktronic on and off
manually.
The switch is located on the center con-
sole.1To switch Parktronic on/off
\1To switch off:
press upper part
1

of the switch.
The indicator lamp in the switch
comes on.
\1To switch on:
press upper part
1
of
the switch again.
The indicator lamp in the switch goes
out.
Trailer towingIf you attach a trailer, Parktronic is deac-
tivated for the rear area as soon as you
make the electrical connection between
your vehicle and the trailer.The rear view camera is a visual parking
aid. It displays the area behind your ve-
hicle on a separate monitor located on
the center console.
The rear view camera is activated when
you engage reverse gear.
The camera is located in the center of
the roof above the third brake lamp
(
\2
page 422). N54.25-2922-31Rear view camera*
nf_BA.book Page 258 Friday, January 25, 2008 3:53 PM

277 Controls in detail
Transporting
3
For more information about the maxi-
mum roof load and roof carrier systems,
please refer to the "Technical data" sec-
tion (
\2
page 599).
Before loading
\1
Check the tire pressures and correct
them if necessary (
\2
page 365).
\1
Clean the load compartment floor.
The load compartment floor must be
dry, cleanly swept and free of oil and
dust to reduce the risk of the load
slipping.
\1
If necessary, place anti-slip mats on
the load compartment floor.
Warning
G
After an accident, have a damaged load
compartment floor or damaged load sur-
face, the lashing eyes and lashing materi-
als inspected by a specialist workshop
having the necessary technical expertise
and tools to carry out the required work. The manufacturer recommends that you
use an authorized Sprinter Dealer for this
purpose. In particular, work relevant to
safety or on safety-related systems must
be carried out at a qualified specialist
workshop.
!
CAUTION
If you are using a roof carrier system,
observe the maximum roof load and
maximum load-bearing capacity of
the roof carrier system.
!
CAUTION
As soon as the anti-slip mats start to
show signs of permanent deforma-
tion, squashed areas or tears/holes,
they are unsuitable for securing loads
and must be replaced.
nf_BA.book Page 277 Friday, January 25, 2008 3:53 PM

285 Controls in detail
Transporting
3
\1
Check whether the lashing eye is
firmly in place.
\1To remove:
pull locking mechanism
1
upward and pull the lashing eye
through a recess towards the locking
mechanism and out of the load rail.
It is possible to mount a roof rack if your
vehicle is equipped with securing rails
on the roof.
1Securing railsSpecial mountings (sliding blocks) are
available as accessories. These are
available from any authorized Sprinter
Dealer.
Carrier systems
Warning
G
Handling and braking characteristics may
change when you have mounted carrier
systems on the vehicle. You could endan-
ger yourself and others.Observe the manufacturer’s installation
instructions. An incorrectly secured carri-
er system or load could:\4come loose\4fall offand thereby endanger yourself and
others.
Continued
nf_BA.book Page 285 Friday, January 25, 2008 3:53 PM

286 Controls in detailTransporting
3
Only install roof racks that have been
approved or recommended for Sprinter
vehicles. These are available in any au-
thorized Sprinter Dealer.Observe the instructions in the “Opera-
tion” section (
\2
page 303).
Warning (Continued)
G
Observe the maximum roof loads
(\2page 630), the maximum axle load
and the maximum load-bearing capacity
of the roof rack.!
CAUTION
Make sure that:
the securing bolts for the roof
rack are tightened to a torque of
6.0 – 7.4 lb-ft (8 – 10 Nm) in the slid-
ing blocks provided
the bolts do not make contact with
the rails when tightened
the sliding blocks are not positioned
near the plastic caps
the sliding blocks have the correct
cross-section
the securing rails are free of dirt on
the inside
the securing bolts are retightened
evenly after approximately 300 miles
(500 km)
This will help to avoid damage to the
vehicle.
!
CAUTION
If you wish to retrofit securing rails,
have them installed at a qualified
specialist workshop which has the
necessary specialist knowledge and
tools to carry out the work required.
You could otherwise damage the ve-
hicle.
The manufacturer recommends that
you use an authorized Sprinter Deal-
er for this purpose.
Trailer towing
nf_BA.book Page 286 Friday, January 25, 2008 3:53 PM

287 Controls in detail
Features
3
\3 Features
Storage compartments above the
windshieldStorage compartment above the roof
trim*
1Storage compartment
Interior storage compartmentsWarning
G
Only load the storage compartments in
such a way that occupants cannot be in-
jured by their contents in the event of an
accident, braking or a sudden change in
direction.
For this reason, do not transport heavy,
bulky, pointed or sharp-edged objects in
the storage spaces or compartments.
!
CAUTION
It is permissible to load the right and
left-hand storage compartments up
to a maximum of 5.5 lbs (2.5 kg)
each.
nf_BA.book Page 287 Friday, January 25, 2008 3:53 PM

288 Controls in detailFeatures
3
Storage compartments in the doorsYou can use these storage compart-
ments for the safe storage of small and
light items.Storage compartment under the twin
passenger's seat*On vehicles with a twin passenger’s
seat, the storage compartment is under
the seat cushion (
\2
page 119).
You can use the storage compartment
for the safekeeping of tools and other
small items.
Glove box1Glove box handle
2Locked*
3Unlocked*
!
CAUTION
The entire storage compartment is
permitted to hold a maximum load of
66 lbs (30 kg).
Do not store high, bulky loads in the
storage compartment. You could oth-
erwise damage the roof trim in the
event of sudden braking.
iYou can lock and unlock the glove
box using the key*.
nf_BA.book Page 288 Friday, January 25, 2008 3:53 PM

335 Operation
Battery
4
\3 BatteryYour vehicle may be equipped with two
batteries, depending on the equipment
version:\4
Starter battery in the battery recess
in the driver’s footwell
\4
Auxiliary battery in the engine com-
partment*
Warning
G
A
Risk of explosion
When batteries are being
charged, explosive detonating
gas is emitted. Only charge bat-
teries in well-ventilated areas.
D
Risk of explosion
Because of the risk of explosion,
avoid creating sparks from fire,
open flames and smoking.
Continued
Warning (Continued)
G
B
Battery acid is caustic.
Wear acid-proof protective
gloves. Neutralize splashes of
acid on skin or clothing immedi-
ately with soapy water or acid
neutralizer and clean with wa-
ter.
Continued
nf_BA.book Page 335 Friday, January 25, 2008 3:53 PM

337 Operation
Battery
4
The batteries must always be sufficiently
charged so that they achieve their in-
tended service life.
Have the battery charge status checked
more frequently if you use the vehicle
mainly for short trips or if you leave it
parked up for a long period.
If you intend to leave your vehicle
parked up for a long period, seek advice
from an authorized Sprinter Dealer and
switch off the electrical system at the
battery isolating switch (
\2
page 338).You will find further information in the
“Practical hints” section (
\2
page 573).
!
CAUTION
Switch off the engine and wait for
approximately 20 seconds before you
loosen or disconnect the terminal
clamps. You could otherwise damage
electrical system components.Care of batteries!
CAUTION
Dirty terminal clamps and battery
surfaces cause leakage current, lead-
ing to battery discharge. Always keep
the terminal clamps and battery sur-
faces clean and dry. Lightly grease
the terminal clamps, particularly the
undersides, with acid-proof grease.
!
CAUTION
Cleaning agents containing fuel can
corrode the battery casing. Only
clean with commercially available
cleaning agents and clean the bat-
tery casing with the cell caps
screwed in.
nf_BA.book Page 337 Friday, January 25, 2008 3:53 PM

397 Operation
Tires and wheels
4
Production options weightThe combined weight of those installed
regular production options weighing
over 5 lbs (2.3 kg) in excess of those
standard items which they replace, not
previously considered in curb weight or
accessory weight, including heavy duty
brakes, ride levelers, roof rack, heavy
duty battery, and special trim.PSI (P
ounds per S
quare I
nch)
A standard unit of measure for air pres-
sure. Another metric unit for air pres-
sure is bar or kilopascal (kPa).
Recommended tire inflation pressureRecommended tire inflation pressure for
normal driving conditions listed on the
tire and loading information placard
1 or
on the tire inflation pressure placard lo-
cated on the driver’s door B-pillar.
Provides best handling, tread life and
riding comfort.
RimA metal support for a tire or a tire and
tube assembly upon which the tire
beads are seated.
Side wallThe portion of a tire between the tread
and the bead.TIN (T
ire I
dentification N
umber)
Unique identifier which facilitates efforts
by tire manufacturers to notify purchas-
ers in recall situations or other safety
matters concerning tires and gives pur-
chases the means to easily identify such
tires. The TIN is comprised of the “man-
ufacturer’s identification mark”, “tire
size”, “tire type code” and “date of man-
ufacture”.
1. For vehicles with a gross weight capacity less
than 10 000 lbs (4 536 kg) (USA only).
nf_BA.book Page 397 Friday, January 25, 2008 3:53 PM

404 OperationWinter driving
4
\3 Winter drivingHave your vehicle winterproofed at the
onset of winter at an authorized Sprinter
Dealer. This service includes the follow-
ing:\4
Oil change, if the current engine oil
used has not been approved for win-
ter use
\4
The antifreeze / anti-corrosion con-
centration in the coolant is checked
\4
The addition of a concentrated
cleaning agent to the water in the
windshield washer system
\4
Battery check
\4
A tire changeYou will find information about diesel
fuel for use at low outside temperatures
in the “Technical data” section
(
\2
page 614).
Please also observe the information
about winter driving (
\2
page 406).
Winter tires should also be operated as
printed on the tire and loading informa-
tion placard
1 or on the tire inflation pres-
sure placard located on the driver’s door
B-pillar, refer to “Tires and wheels” (
\2
page 362). Not all M+S rated radial-
ply tires provide special winter perfor-
mance. Make sure the tires you use
show M+S and the mountain/snowflake
marking
.
on the tire side wall.
These tires meet specific snow traction
performance requirements of the Rub-
ber Manufacturers Association (RMA)
and the Rubber Association of Canada
(RAC) and have been designed specifi-
cally for use in snow conditions. Use of
winter tires is the only way to achieve
the maximum effectiveness of the ABS,
BAS, ASR and ESP
® in winter operation.
Winter tires1. For vehicles with a gross weight capacity less
than 10 000 lbs (4 536 kg) (USA only).
nf_BA.book Page 404 Friday, January 25, 2008 3:53 PM