battery DODGE SPRINTER 2008 2.G Service Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 2008, Model line: SPRINTER, Model: DODGE SPRINTER 2008 2.GPages: 666, PDF Size: 14.11 MB
Page 503 of 666
501 Practical hints
Display messages
5
k
unavailable
ASR as well as BAS have been switched off
due to undervoltage.
The battery may not be being charged.
The brake system is still available with the
normal braking effect.
\1Continue driving, but with even greater
care.
\1Have the system checked at an authorized
Sprinter Dealer as soon as possible.
ì
Please enter PIN:
You have not yet entered your details in the
telephone.
\1Enter the PIN for your SIM card.
<
Seatbelt sys.
Visit
workshop
WARNING
G
The belt system has malfunctioned.
\1Have the system checked at an authorized
Sprinter Dealer as soon as possible.
Display symbol
Display message
Possible cause / result
Possible solution
nf_BA.book Page 501 Friday, January 25, 2008 3:53 PM
Page 541 of 666
539 Practical hints
Changing the batteries
5
\3 Changing the batteriesIf the remote control batteries (remote
keyless entry) are discharged, you will
only be able to lock and unlock the vehi-
cle manually using the key.
If the batteries in the auxiliary heating
remote control are discharged, you will
only be able to switch the auxiliary heat-
ing on or off using the auxiliary heating /
heater booster switch inside the vehicle
(\2
page 238).
It is advisable to have the batteries
changed at an authorized Sprinter Deal-
er.
Warning
G
Keep batteries away from children.
Consult a doctor immediately if a battery
is swallowed.
Dispose of used batteries in an environ-
mentally responsible manner.
Danger of explosion if the battery is not
correctly replaced.
Replacements should always be either of
the same type or one which has been rec-
ommended by the manufacturer.
Environmental note
H
Batteries contain materials that can harm
the environment if disposed of improper-
ly. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.
nf_BA.book Page 539 Friday, January 25, 2008 3:53 PM
Page 542 of 666
540 Practical hintsChanging the batteries
5
You need two CR 2025 3 V cell batteries
or equivalent.
Do not touch the battery contact surfac-
es.
1Battery cover
2Release button for mechaniocal key\1
Release the mechanical key by
pressing the release button
2
.
\1
Remove the battery cover
1
.
iAlways replace all the batteries at
the same time. Suitable batteries are
available from an authorized Sprinter
Dealer. You can also have the batter-
ies changed there and return used
batteries.
Remote control
(remote keyless entry)iWhen inserting the batteries, make
sure that they are clean and lint-free.!
CAUTION
Do not operate the remote control
while the battery is being replaced.
nf_BA.book Page 540 Friday, January 25, 2008 3:53 PM
Page 543 of 666
541 Practical hints
Changing the batteries
5
\1
Remove the battery and install a new
one (note correct polarity; positive
terminal up).
\1
Press battery cover
1
until it snaps
into place.
\1
Check the function of all remote con-
trol buttons on vehicle.You need three Micro / AAA / LR03 bat-
teries or equivalent.
1Battery cover
2Batteries
\1
Remove battery cover
1
using a
suitable implement, for example a
key, and put it to one side.
\1
Remove old batteries
2
.
\1
Insert three new batteries
2
. Ob-
serve the plus and minus signs in the
remote control.
\1
Slide battery cover
1
onto the re-
mote control as illustrated.
\1
Check the auxiliary heating functions
on the vehicle using the remote control.
Auxiliary heating remote control*
N83.00-2062-31
nf_BA.book Page 541 Friday, January 25, 2008 3:53 PM
Page 546 of 666
544 Practical hintsFuel system
5
\1
Drain the fuel filter again if the
/
indicator lamp remains lit.If the fuel tank on a vehicle with diesel
engine has been run dry, there is a pos-
sibility that the engine may not start im-
mediately after refueling because air
may remain in the fuel system.
After refueling:
\1
Switch on the ignition for approxi-
mately 10 seconds.
\1
Start the engine repeatedly for no
more than 60 seconds until it runs
smoothly.
If the engine does not start:
\1
Wait approximately 2 minutes.
\1
Then start the engine repeatedly
again for no more than 60 seconds
until it runs smoothly.
If this attempt also fails, do not continue
to start the engine. Consult an autho-
rized Sprinter Dealer.
Environmental note
H
Have the drained liquid disposed of at an
authorized Sprinter Dealer.!
CAUTION
If the
/
indicator lamp remains
lit even after draining for the second
time, have the cause checked imme-
diately at an authorized Sprinter
Dealer.
Bleeding the fuel systemiToo many attempts to start the en-
gine could drain the battery.
nf_BA.book Page 544 Friday, January 25, 2008 3:53 PM
Page 575 of 666
573 Practical hints
Battery
5
\3 BatteryYour vehicle may be equipped with two
batteries, depending on the equipment
version:\4
Starter battery in the battery recess
in the driver’s footwell
\4
Auxiliary battery* in the engine com-
partment
iThe auxiliary battery* in the engine
compartment is not suitable for
jump-starting operations. Only use
the jump-starting connection in the
engine compartment if you require
jump-starting assistance or wish to
provide jump-starting assistance
(\2
page 581).
Warning
G
Observe the safety notes in the “Opera-
tion” section (\2page 335).
Do not place any metal objects on the bat-
tery. Doing so can cause a short circuit.
Use only impact-resistant batteries with a
central gas release cover to prevent cor-
rosion damage and to protect occupants
from caustic burns in the event of an acci-
dent.
nf_BA.book Page 573 Friday, January 25, 2008 3:53 PM
Page 576 of 666
574 Practical hintsBattery
5
Have the batteries removed at an autho-
rized Sprinter Dealer which has the nec-
essary specialist knowledge and tools to
carry out the work required.
The manufacturer recommends that you
use an authorized Sprinter Dealer for
this purpose.
Disconnecting the batteryWarning
G
There is a risk of a short circuit if the pos-
itive terminal of the connected battery
comes into contact with vehicle parts.
The highly explosive gas mixture could ig-
nite as a result. You and others could be
seriously injured as a result.
Continued
Warning (Continued)
G
\4Do not place any metal objects or
tools on the batteries.
\4When disconnecting the batteries, al-
ways disconnect the negative termi-
nals first and then the positive
terminals.
\4When reconnecting the batteries, al-
ways reconnect the positive terminals
first and then the negative terminals.
\4Do not loosen or disconnect the ter-
minal clamps on the batteries while
the engine is running.
nf_BA.book Page 574 Friday, January 25, 2008 3:53 PM
Page 577 of 666
575 Practical hints
Battery
5
\1
Switch off all electrical consumers.
Disconnecting the starter batteryThe starter battery is in the battery re-
cess in the driver’s footwell.Removing/installing the floor cover-
ing in the driver's footwell
1Floor covering
2Trim
3Securing screws\1To remove:
undo screws
3
and re-
move trim
2
.
\1
Remove floor covering
1
.
!
CAUTION
Switch off the engine and take the
key out of the ignition lock before
you loosen or disconnect the termi-
nal clamps. You may otherwise de-
stroy electronic components such as
the alternator.
Always disconnect the starter bat-
tery in the battery recess in the driv-
er’s footwell first.
nf_BA.book Page 575 Friday, January 25, 2008 3:53 PM
Page 578 of 666
576 Practical hintsBattery
5
\1To install:
place floor covering
1
into the driver’s footwell.
\1
Push floor covering
1
under the
plate metal bracket of the accelera-
tor pedal and align it with the driver’s
seat base and the doorway
Make sure the floor covering does
not obstruct the accelerator’s range
of movement.
\1
Position trim
2
and screw
screws
3
back in.
Removing the battery cover in the
driver’s footwell1Cover
2Securing screws\1
Undo screws
2
and slide cover
1
in the direction of the arrow.
The screws must protrude beyond
the recesses.
Warning
G
The movement of the pedals must not be ob-
structed. The vehicle’s operating and road
safety are otherwise jeopardized.
Make sure to push the floor covering under
the plate metal bracket of the accelerator
pedal. The floor covering may not slip bet-
ween the bracket and the accelerator pedal.
Otherwise, you may not be able to fully
depress the accelerator pedal, which will
restrict the vehicle’s acceleration capability,
for example when passing another vehicle.
nf_BA.book Page 576 Friday, January 25, 2008 3:53 PM
Page 579 of 666
577 Practical hints
Battery
5
\1
Remove cover
1
upward.
Starter battery in the driver’s footwell
\1
Loosen the negative terminal of the
battery first and remove it so that the
negative terminal cannot come into
contact with the pole terminal.
\1
Remove the cover from the positive
terminal.
\1
Loosen the positive terminal and fold
the positive terminal and the prefuse
box up to the side.
Disconnecting the auxiliary battery*
\1
Open the hood (
\2
page 318).
Auxiliary battery in the engine compart-
ment
nf_BA.book Page 577 Friday, January 25, 2008 3:53 PM