key battery DODGE SPRINTER 2008 2.G Owners Manual

85 Controls in detail
Opening and closing
3
Remote control with key
1 To unlock the sliding doors and
rear doors and opens or closes the elec-
tric sliding door*
2ΠUnlocking button
3‹ Locking button
4Release button for mechanical key
5Battery check lamp.
Warning
G
Do not leave children unsupervised in the
vehicle, even if they are secured by a child
restraint system.The children could:injure themselves on parts of the vehicleunlock the door on vehicles with an elec-
tric sliding door by pressing the central
locking button, and then open the doors
and thereby injure other persons
Continued
Warning (Continued)
G
get out of the vehicle and could either in-
jure themselves when doing so or they
could be injured by passing vehiclesbe severely or even fatally injured by pro-
longed exposure to intense heat
!Do not expose the key to high levels
of electromagnetic radiation, other-
wise this may interfere with the func-
tions of the key.
Protect the key from moisture to pre-
vent malfunctions.
nf_BA.book Page 85 Friday, January 25, 2008 3:53 PM

86 Controls in detailOpening and closing
3
As a precaution, both remote controls
should always be carried.Checking the batteries
\1
Press the
Œ
or
‹
button for
longer than 2 seconds.The battery check lamp
5
comes on
briefly to indicate that the remote
control batteries are in order.
Change the batteries immediately if
the lamp
does not
light up briefly
during check (
\2
page 540).
Locking and unlocking the vehicle
with the remote control
Unlocking the driver's door
\1
Press the
Œ
button.
The turn signals flash once.
The anti-theft alarm system (ATA)* is
deactivated.
iTo prevent theft, only use the remote
control in the immediate vicinity of
the vehicle.
In an emergency, the driver’s door
and rear door can also be unlocked
manually using the key.
iIf the batteries are checked within
signal range of the vehicle, pressing
the
Œ
or
‹
but ton wil l lock or
unlock the vehicle accordingly.
iIf you unlock the vehicle using the
key and do not open a door within 40
seconds, the vehicle locks again au-
tomatically.
nf_BA.book Page 86 Friday, January 25, 2008 3:53 PM

93 Controls in detail
Opening and closing
3
If the electric drive of the sliding door is
at risk of overheating, e.g. as a result of
frequent opening and closing within a
short amount of time, the sliding door
opens completely and is locked (func-
tion override). After approx. 30 seconds,
the sliding door is again operational.
Opening / closing using the switchObserve the notes on anti-trap protec-
tion (
\2
page 98).
Sliding door switch on the center console
1To close the sliding door / to program the
key (\2page 97)
2To open the sliding door
iFollowing a battery disconnection or
malfunction, it is necessary to fully
close the sliding door once by press-
ing and holding the switch on the
center console or in the doorway
(\2
page 93) and then to fully open
and close the door once by pressing
one of the switches briefly. This re-
stores normal operation of the slid-
ing door.
iIn the event of a malfunction or if the
battery is disconnected, you can dis-
connect the sliding door from the
electric drive via the unlocking me-
chanism and then open/close the sli-
ding door manually (
\2
page 96).
N72.16-2135-31
nf_BA.book Page 93 Friday, January 25, 2008 3:53 PM

111 Controls in detail
Key positions
3
\3 Key positions
0
To remove the key, to lock the steer-
ing wheel
1
To unlock the steering wheel (power
supply for some consumers, e.g. radio)
2
To switch on the ignition (power sup-
ply for all consumers)
Preglow
1 and drive position
3
To start
1 Only vehicles with a diesel engine
iThe key can only be removed from
position
0. Also observe the notes in
the “Driving and parking” section
(
\2
page 183).
To unlock the steering, turn the
steering wheel slightly while turning
the key to position
1.
On vehicles with a battery isolating
switch, you must first switch on the
electrical system (\2
page 340).
nf_BA.book Page 111 Friday, January 25, 2008 3:53 PM

141 Controls in detail
Lighting
3
Load compartment motion detector*On panel vans equipped with a motion
detector in the load compartment, the
rear interior lighting may also switch on
if motion is detected.
The rear interior lighting can be switched
on by the motion detector with a delay of
no more than 4 seconds if:
\4
the switch on the rear interior lamp
(\2
page 139) is set to “automatic
control”
\4
the vehicle is stationary, the hand-
brake is applied and the service
brake is not applied
or
\4
the selector lever is in position
P and
the service brake is not applied
\4
the vehicle has not been locked from
the outside using the key
Warning
G
Motion detectors work with invisible in-
frared beams emitted by LEDs (Light
Emitting Diodes).
Do not view invisible infrared radiation, la-
ser class 1M, directly using optical instru-
ments.
Your eyes could otherwise be injured.
iIf the motion detector detects move-
ment in the load compartment when
the vehicle is stationary, the rear in-
terior lighting switches on for ap-
proximately 2 minutes. If new
movements are detected, the dura-
tion resumes from the beginning and
the rear interior lighting remains
switched on.
iThe motion detector switches off auto-
matically if no change is detected in the
vehicle for several hours, e.g. door
opened, ignition key turned, etc.This prevents the battery from dis-
charging.
nf_BA.book Page 141 Friday, January 25, 2008 3:53 PM

190 Controls in detailDriving and parking
3
Warning
G
Always switch off the engine and apply
the handbrake before leaving the vehicle.
The vehicle could roll away if it is not
secured.
On uphill or downhill gradients steeper
than 15%:
\4apply the handbrake
\4secure an unloaded vehicle by chock-
ing the front axle (\2page 521)
\4secure a loaded vehicle by, for exam-
ple, chocking the rear axle
(\2page 521)
!
CAUTION
Whenever you park the vehicle, al-
ways remove the key to prevent the
battery from excessively discharg-
ing.
For vehicles which are out of use for
extended periods and have a battery
isolating switch*, switch off the elec-
trical system (
\2
page 338).
Warning
G
Make sure that the exhaust system does
not come into contact with highly flamma-
ble materials, e.g. dry grass or gasoline.
The flammable material could otherwise
ignite and set vehicle components on fire.
nf_BA.book Page 190 Friday, January 25, 2008 3:53 PM

245 Controls in detail
Open air
3
Resetting the side windowsThe side windows must be reset if the
battery has been disconnected:\1
Pull the two power window switches
until the side windows are closed.
\1
Hold the switches in this position for
about 1 second.
The side windows are reset.
Sliding sunroof*Warning
G
Make sure that nobody can become
trapped as you close the sliding sunroof.The glass may shatter in the event of an
accident.If you or other occupants are not wearing
your seat belt, there is a risk of being
thrown out of the opening in the event of
the vehicle overturning. Therefore, always
wear a seat belt to reduce the risk of inju-
ries.
Continued
Warning (Continued)
G
In accidents in which the vehicle over-
turns, there is an increased risk of injury
even for occupants who have fastened
their seat belts correctly, as their head or
limbs could be thrust through the open-
ing.Remove the key from the ignition lock
even if you are only leaving the vehicle for
a short time.
nf_BA.book Page 245 Friday, January 25, 2008 3:53 PM

298 Controls in detailFeatures
3
Telephones may only be used inside the
vehicle if they are connected to a sepa-
rate exterior antenna of a type tested
and approved by the manufacturer.
iThe sockets are supplied with power
even if the key is removed from the
ignition lock. Please note that the
battery may be discharged if you
have connected an accessory, e.g. a
coolbox, and the engine is switched
off.Telephone*
Warning
G
You must observe the legal requirements
for the country in which you are driving
when operating a cell phone in the vehi-
cle.If it is permitted to operate a cell phone
while the vehicle is in motion, you must
only operate it when road and traffic con-
ditions permit. You may otherwise be dis-
tracted from the traffic conditions, cause
an accident and injure yourself and oth-
ers.
Continued
Warning (Continued)
G
Cell phones without exterior antennas
may interfere with the vehicle electronics
and thereby jeopardize the operational
safety of the vehicle. You must therefore
only use these devices when they are con-
nected to a separate exterior antenna.
nf_BA.book Page 298 Friday, January 25, 2008 3:53 PM

299 Controls in detail
Features
3
The installation of the antenna must be
approved by a qualified specialist work-
shop.
Always have maintenance work carried
out at a qualified specialist workshop,
e.g. an authorized Sprinter Dealer.
Warning
G
Only use the telephone when road, weath-
er and traffic conditions permit you to do
so. You will otherwise be too distracted. If
you are not using the hands-free system,
pull over to make a phone call.
Bear in mind that at a speed of just
30 mph (approx. 50 km/h), your vehicle
is covering a distance of 44 feet (approx.
14 m) every second.
Telephones without exterior antennas
may interfere with the vehicle electronics
and thereby jeopardize the operational
safety of the vehicle.
iObserve all legal requirements.iThe cell phone battery will be
charged depending on the charge
status and the position of the key in
the ignition lock. The cell phone dis-
play indicates the charging process.
nf_BA.book Page 299 Friday, January 25, 2008 3:53 PM

339 Operation
Battery isolating switch*
4
\1
Take the key out of the ignition lock
and wait for approximately
20 seconds.
\1
Move red slide
2
down in the direc-
tion of the arrow and disconnect
connector
1
from the ground pin.
\1
Clamp connector
1
under the ac-
celerator pedal so that it cannot
make contact with the ground pin.
The consumers of the vehicle battery
are cut off from the electrical circuit.
!
CAUTION
Make sure that the key is in
position
0 in the ignition lock and
wait at least 20 seconds before dis-
connecting or connecting the battery
isolating switch. You could otherwise
damage electrical system compo-
nents.
Switching off the electrical system
!
CAUTION
When you clamp the connector under
the accelerator pedal, make sure that
the connector does not become:
\4
dirty
\4
damaged
It may otherwise not be possible to
restore the electrical connection
when the parts are reassembled.
nf_BA.book Page 339 Friday, January 25, 2008 3:53 PM