oil temperature DODGE SPRINTER 2008 2.G Owners Manual

149 Controls in detail
Operating system without steering wheel buttons
3
There may be a short delay before a low-
er outside temperature is displayed, for
example after leaving a garage. There
may also be a short delay before a rise in
the outside temperature is displayed.
This prevents you from seeing a temper-
ature display influenced by heat from
the engine when the vehicle is stationary
or moving slowly.
MenusFunction
Page
Calling up the service due
date*
411
Checking the engine oil level
322
Selecting/setting the auxiliary
heating switch-on time*
240
Tire pressure monitor
365
Setting the time
150
Setting the date
150
iTo return to the standard display:\4
press and hold menu button
for more than 1 second
\4
do not press a button for
10 seconds
The display accepts the changed set-
tings.
nf_BA.book Page 149 Friday, January 25, 2008 3:53 PM

157 Controls in detail
Operating system with steering wheel buttons*
3
In the Operation menu, you can select
the following functions using the
j

or
k
button:
Standard displayIn its basic setting, you will see the
odometer and the trip meter in the up-
per part of the display. This is referred to
as the standard display.
\1
If you see a different display, press
the
è
or
ÿ
button repeatedly
until the standard display appears.
Operation menuFunction
Page
Standard display with trip
meter and odometer
157
Display coolant temperature
158
Call up the service due date*
411
Tire pressure monitor
365
Check the engine oil level
(only on vehicles with a diesel
engine)
326
N54.32-2280-31
Upper part of the display1
Trip meter
2
Odometer
Lower part of the display3
Outside temperature* or digital
speedometer
4
Time
5
Selector lever position or current
shift range
nf_BA.book Page 157 Friday, January 25, 2008 3:53 PM

323 Operation
Engine compartment
4
Check the engine oil level on a regular ba-
sis, for example weekly or each time you re-
fuel.Checking the engine oil level in the
displayIn vehicles with diesel engines, you can
view the engine oil level in the display.When the oil is being checked, the vehi-
cle must
\4
be standing level
\4
be at normal operating temperature
\4
have been standing with the engine
switched off for at least five minutes
\1
Switch on the ignition (
\2
page 111).
The display is activated.
iIf the oil level exceeds the maximum
level several times during operation,
have the malfunction rectified imme-
diately at an authorized Sprinter
Dealer.
iIf no oil level reading is shown again,
check the engine oil level with the dip-
stick.
Have the engine oil level display
checked at an authorized Sprinter Deal-
er.
!
CAUTION
Have any excess oil drained or si-
phoned off at an authorized Sprinter
Dealer. Otherwise, the engine or cat-
alytic converter could be damaged.
iIf at extremely low temperatures no
engine oil level is displayed after 5
minutes, wait a further 5 minutes be-
fore repeating the engine oil level
check.
nf_BA.book Page 323 Friday, January 25, 2008 3:53 PM

326 OperationEngine compartment
4
Checking the engine oil level with the
dipstickWhen the oil is being checked, the vehi-
cle must\4
be at normal operating temperature
\4
be standing level
\4
have been standing with the engine
switched off for at least five minutes
Observe
wait. pe-
riod
\1
Carry out another
measurement after
approximately 5 min-
utes when the en-
gine is at normal
operating tempera-
ture.
\1
Carry out another
measurement after
approximately
30 minutes when the
engine has cooled
down.
N
Engine oil
level Not
when eng.
running
\1
Switch off the engine
and wait for approxi-
mately 5 minutes if
the engine is at nor-
mal operating tem-
perature.
iEngine oil level display:\4
quart(s)
in USA only
\4
liter(s)
in Canada only
N
nf_BA.book Page 326 Friday, January 25, 2008 3:53 PM

329 Operation
Engine compartment
4
The expansion tank is in the engine com-
partment. Only add coolant with the ve-
hicle standing on a level surface and
with the engine switched off. The cool-
ant temperature must have dropped be-
low 122 °F (50 °C).
1Coolant tank cap
2Brake fluid reservoir cap
3Windshield washer reservoir cap
Environmental note
H
Wh en addi n g o i l, ta ke c ar e n ot t o s pi ll a n y.
No engine oil must be allowed to enter
sewage systems, surface water, ground
water or soil.
You would otherwise be damaging the en-
vironment.
Dispose of engine oil in an environmental-
ly responsible manner. Comply with the
manufacturer’s instructions.
Coolant
N20.30-2063-31
nf_BA.book Page 329 Friday, January 25, 2008 3:53 PM

330 OperationEngine compartment
4
\1
Slowly unscrew cap
1
counter-
clockwise to reduce excess pres-
sure.
\1
Continue turning the cap and remove
it.
\1
Add coolant as far as the MAX mark.
\1
Twist cap
1
back on.
For coolant specifications, see "Service
products and capacities" (
\2
page 604).
Warning
G
When opening the coolant expansion tank
there is a risk of scalding from hot coolant
spraying out. The cooling system and the
coolant expansion tank are pressurized
when the engine is at normal operating
temperature.
Wear gloves and eye protection. Only
open the coolant expansion tank when
the coolant temperature is less than
122 °F (50 °C).
Warning
G
Coolant contains glycol and is therefore
toxic. Do not swallow coolant. Consult a
doctor immediately if any coolant is swal-
lowed.
Do not allow coolant to come into contact
with your skin, eyes or clothing. In the
event of contact with the eyes, rinse them
thoroughly with clean water. Clean skin
and clothes immediately with soap and
water. Change out of soiled clothing with-
out delay.
!
CAUTION
Check the cooling and heating sys-
tems regularly for leaks. If a large
quantity of coolant is lost, have the
cause traced and rectified at an au-
thorized Sprinter Dealer.
nf_BA.book Page 330 Friday, January 25, 2008 3:53 PM

334 OperationEngine compartment
4
Adapt the mixing ratio to the outside
temperature. Use:\4
Summerwash to protect against
smearing at temperatures above
freezing.
\4
Winterwash when there is a risk of
frost so that the water does not
freeze onto the windshield.
\1
Mix the windshield washer fluid in a
container and in the specified pro-
portions.
\1
Remove cap
3
.
\1
Fill up the windshield washer fluid.
\1
Press cap
3
back on.
Check assemblies regularly for leaks. In
the event of fluid loss (e.g. spots of oil
under the vehicle when it has been
parked), have the cause traced and rec-
tified immediately at an authorized
Sprinter Dealer which has the necessary
specialist knowledge and tools to carry
out the work required.The manufacturer recommends that you
use an authorized Sprinter Dealer for
this purpose. All work relevant to safety
or on safety-related systems must be
carried out at an authorized Sprinter
Dealer.
Warning
G
Windshield washer concentrate is highly
flammable. Fire, open flames and smok-
ing are prohibited when you are handling
windshield washer concentrate.
Vehicle assemblies
nf_BA.book Page 334 Friday, January 25, 2008 3:53 PM

404 OperationWinter driving
4
\3 Winter drivingHave your vehicle winterproofed at the
onset of winter at an authorized Sprinter
Dealer. This service includes the follow-
ing:\4
Oil change, if the current engine oil
used has not been approved for win-
ter use
\4
The antifreeze / anti-corrosion con-
centration in the coolant is checked
\4
The addition of a concentrated
cleaning agent to the water in the
windshield washer system
\4
Battery check
\4
A tire changeYou will find information about diesel
fuel for use at low outside temperatures
in the “Technical data” section
(
\2
page 614).
Please also observe the information
about winter driving (
\2
page 406).
Winter tires should also be operated as
printed on the tire and loading informa-
tion placard
1 or on the tire inflation pres-
sure placard located on the driver’s door
B-pillar, refer to “Tires and wheels” (
\2
page 362). Not all M+S rated radial-
ply tires provide special winter perfor-
mance. Make sure the tires you use
show M+S and the mountain/snowflake
marking
.
on the tire side wall.
These tires meet specific snow traction
performance requirements of the Rub-
ber Manufacturers Association (RMA)
and the Rubber Association of Canada
(RAC) and have been designed specifi-
cally for use in snow conditions. Use of
winter tires is the only way to achieve
the maximum effectiveness of the ABS,
BAS, ASR and ESP
® in winter operation.
Winter tires1. For vehicles with a gross weight capacity less
than 10 000 lbs (4 536 kg) (USA only).
nf_BA.book Page 404 Friday, January 25, 2008 3:53 PM

411 Operation
Maintenance and servicing
4
ASSYST, the A
ctive S
ervice Syst
em, in-
forms you when the next service is due.
A service that is due is displayed about a
month or 1900 miles (3000 km) in ad-
vance. A message is then displayed
while the vehicle is in motion or the igni-
tion is switched on.
Active Service System (ASSYST)*
!
CAUTION
Periods when the battery is discon-
nected will not be recorded by AS-
SYST. To make sure that you have
the vehicle serviced at the correct
time, you should therefore subtract
periods when the battery is discon-
nected from the days shown.
The service indicator does not pro-
vide information about the engine oil
level. The service indicator should
not, therefore, be confused with
theP
engine oil level display.
iThe service due date is displayed in
days or miles (kilometers), depend-
ing on the total distance driven.
The time between the individual ser-
vice due dates depends on your style
of driving. You can increase this by:\4
driving with care and at a moder-
ate engine speed
\4
avoiding short journeys where
the engine does not reach the op-
erating temperature
nf_BA.book Page 411 Friday, January 25, 2008 3:53 PM

607 *Technical data
Service products and capacities
6
Valid Mercedes-Benz oil specification
sheets:
Always refer to the following viscosity
chart for the proper viscosity grade
based on ambient temperature. Select
oil viscosity according to the lowest air
temperature expected before the next
oil change. This chart supersedes ALL previously
published viscosity charts.
For further information contact your au-
thorized Sprinter Dealer.Engine
MB sheet
Gasoline
M272
229.3, 229.31
229.5, 229.51
Diesel
OM642
228.51, 229.31,
229.51
The following oils have been
determined to meet the Chrysler Vans
LLC requirements as shown below:MB approved engine
oil
SAE
MB sheet
Castrol Syntec 5W-40
5W-40
229.3
Castrol Syntec 0W-30
European Formula
0W-30
229.5
Chevron Supreme
Synthetic Motor Oil
SAE 5W-40
5W-40
229.31
Fuchs Titan Cargo
Maxx SAE 10W-40
10W-
40
228.51
Fuchs Titan GT1 SAE
5W-30
5W-30
229.51
nf_BA.book Page 607 Friday, January 25, 2008 3:53 PM