DODGE VIPER 2006 ZB / 2.G Owners Manual

Use soap and water on dull black window trim. Polish or
cleaners may leave a white residue. If desired, you may
polish your vehicle immediately by using Mopar Auto-
mobile Polish or equivalent.
Glass Surfaces
All glass surfaces should be cleaned regularly with any
commercial household-type glass cleaner. Never use an
abrasive type cleaner.
Cleaning Plastic Instrument Cluster Lenses
When cleaning the lenses, use care to avoid scratching
the plastic.
NOTE:Never scrape the windows with squeegees,
razor blades, or other sharp instruments.
•Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If using soap, wipe clean with a clean damp
rag or chamois cloth.
•Dry with a soft tissue.
Damage to the Body Finish
Any stone chips, fractures or deep scratches in the finish
should be promptly repaired.
Minor damage can be repaired by using touch-up mate-
rials available at your dealers. More extensive damage
should be corrected in your dealer’s paint facility.
Seat Belt Maintenance
Do not bleach, dye or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage will also weaken the fabric.
If the belts need cleaning, use a mild soap solution or
lukewarm water. Do not remove the belts from the car to
wash them.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
MAINTAINING YOUR VEHICLE 201
7

Convertible Top Care — Convertible Models Only
Use a mild detergent to clean the top. Avoid heavy
scrubbing and rinse with plenty of clean water. Allow to
dry thoroughly before storage.
Carpeting
Vacuum your carpeting regularly to prevent a soil
buildup. Shampoo soiled carpeting with a reliable uphol-
stery cleaner, using a natural sponge or soft bristle brush.
After carpeting dries, vacuum it thoroughly.
Underbody Maintenance
The corrosive materials used for ice and snow removal or
dust control may accumulate on the underbody of your
vehicle. If not removed, these materials may accelerate
rusting and deterioration of underbody components such
as fuel lines, frame, floor pan, exhaust system, etc.
At least twice during the winter months hose down the
wheel wells and underside of the vehicle. Make sure youremove mud and salt from panels, crevices and ledges,
and that all drain holes and channels are free of debris.
NOTE:You can do more harm by hosing off the vehicle
without removing caked mud and debris.
The frame of your Viper is galvanized for rust-through
protection. It is also dipped in a black E-Coat to protect
the welded areas. Avoid any scratches through to bare
metal.
Commercial Car Washes
We do not recommend that you take your Viper through
a commercial car wash.
In the event that you do take your Viper to a commercial
car wash, move the Heater/Air Conditioning blower
control to the lowest setting. This will prevent the possi-
bility of water entering the system.
202 MAINTAINING YOUR VEHICLE

CAUTION!
The tires on your Viper are wider than the guide
tracks on most washes and the low ground clearance
of your vehicle may not be compatible with some car
wash equipment. You could damage your vehicle.
FUSES — Power Distribution Center
A power distribution center is located in the engine
compartment. This center contains fuses and relays.
Power Distribution Center
MAINTAINING YOUR VEHICLE 203
7

CAUTION!
•When installing the Power Distribution Center
cover, it is important to ensure the cover is prop-
erly positioned and fully latched. Failure to do so
may allow water to get into the Power Distribu-
tion Center, and possibly result in a electrical
system failure.
•When replacing a blown fuse, it is important to
use only a fuse having the correct amperage
rating. The use of a fuse with a rating other than
indicated may result in a dangerous electrical
system overload. If a properly rated fuse contin-
ues to blow, it indicates a problem in the circuit
that must be corrected.
Power Distribution Center
Cavity Fuse Circuits
1 Cartridge
Fuse 40
AmpBatt-Relay Contact, High Blower
Motor Module-ABS Pump Feed
2 Cartridge
Fuse 40
AmpABS Pump Feed
3 Cartridge
Fuse 30
Amp
GreenBattery
4 Cartridge
Fuse 20
Amp
YellowFused Feed to RS Amplifier or
Power Amplifier
204 MAINTAINING YOUR VEHICLE

Cavity Fuse Circuits
5 Cartridge
Fuse 30
Amp
GreenIgnition Switch (Run &
Accessory)-(Downstream)
6 Cartridge
Fuse 40
AmpBatt
7 Cartridge
Fuse 30
Amp
GreenBatt-Relay Contact, ABS Pump
Motor
8 Cartridge
Fuse 30
Amp
GreenBatt-Motor, Wiper
9 Cartridge
Fuse 40
AmpBatt-FuseblockCavity Fuse Circuits
10 Cartridge
Fuse 30
Amp
GreenBatt-Switch, Ignition (Run/Start/
Accy)
11 Mini
Fuse 25
Amp
ClearBatt-Relay Contact, Auto Shut-
down
12 Mini
Fuse 20
Amp
YellowSecondary Power Outlet Feed
13 Mini
Fuse 15
Amp
BlueBatt-Flasher, Hazard
MAINTAINING YOUR VEHICLE 205
7

Cavity Fuse Circuits
14 Mini
Fuse 15
Amp
BlueRear 02 Sensor to Heater Relay
15 Mini
Fuse 20
Amp
YellowElectric Heated RR. WDO (EBL)
16, 17 Mini
Fuse 20
Amp
YellowFused Feed-Cigar Lighter
18 Mini
Fuse 15
Amp
BlueBatt-Locks, Power DoorCavity Fuse Circuits
19 Mini
Fuse 15
Amp
BlueBatt
20 Mini
Fuse 15
Amp
BlueFeed-Courtesy, Dome, Visor, Illu-
minated Entry, Reading
21 Mini
Fuse 15
Amp
BlueFuse Feed to Stop Lamp Switch
22 Mini
Fuse 15
Amp
BlueBattery to AC Clutch Relay
206 MAINTAINING YOUR VEHICLE

Cavity Fuse Circuits
23, 24 Mini
Fuse 10
Amp RedAirbag, Ignition Run
25-29 ISO RE-
LAYBatt-Relay Contact, High Blower
Motor
30-34 MICRO
RELAYBatt-Relay-Starter Contact to So-
lenoid
35-39 MICRO
RELAYFeed-Auto Shutdown Relay Coil
40-44 MICRO
RELAYFeed-Horn (From Relay)
45-49 MICRO
RELAYBatt-Relay-Headlamps
50-54 MICRO
RELAYRelay-A/C Clutch Output from
Relay Contact (B+)
55-59 MICRO
RELAYLeft/Right Downstream Oxygen
Sensor Output Feed FRCavity Fuse Circuits
60, 61 Mini
Fuse 15
Amp
BlueIgnition Start/Run Relay Coil
62, 63 Mini
Fuse 15
Amp
BlueIgnition Start/Run Gauges
64, 65 Mini
Fuse 10
Amp RedIgnition Start/Run Airbag
66, 67 Mini
Fuse 20
Amp
YellowFeed-Ign Run/Acc Wiper Switch
MAINTAINING YOUR VEHICLE 207
7

Cavity Fuse Circuits
68, 69 Mini
Fuse 20
Amp
YellowLeft HID Headlamp
70, 71 Mini
Fuse 20
Amp
YellowRight HID Headlamp
72-76 MICRO
RELAYBatt-Run/Acc Relay
82-86 MICRO
RELAYHeated Rear Window (EBL) Re-
lay
87-91 MICRO
RELAYBatt-Motor, Fuel Pump RelayVEHICLE STORAGE
We recommend that you follow these guidelines before
storing your vehicle for extended periods.
•Fill the fuel tank. This will prevent water condensation
inside the gas tank.
If you plan on storing your vehicle more than 2
months, add an anti-oxidant fuel stabilizer to the fuel
tank.
•Change the oil to remove any corrosive combustion
related acids in the crankcase.
•Wash and wax the vehicle to protect the finish.
•Cover the vehicle whenever possible to prevent acci-
dental damage to the finish.
•Store the vehicle in a dry, well ventilated location.
208 MAINTAINING YOUR VEHICLE

•If the vehicle will be subjected to freezing tempera-
tures, remove the battery and store it in a dry, well
ventilated area or place a trickle charger (1.5 Amp)
with automatic shutdown / overcharge protection
connected to the battery. Do not leave the trickle
charger hooked up to the battery without being
plugged into the 110 AC voltage outlet, because this
will result in further drain on the vehicle’s battery. If
the vehicle is not going to be driven in the next 3
weeks, follow the battery recharge procedure in the
Service Manual, then disconnect the battery at the
negative terminal or use the save feature described in
Maintaining your Vehicle section under the Mainte-
nance Procedures sub-section, within Maintenance-
Free Battery.CAUTION!
Use care when disconnecting the remote positive
cable. It is connected to the battery and can short out
to any metal on the vehicle. Always tape or wrap the
exposed cable end to prevent electrical shorts.
•Disconnecting the battery causes the engine control
system to lose memory of some “learned” functions,
unless using the Battery Save feature described in
Maintaining your Vehicle section under the Mainte-
nance Procedures sub-section, within Maintenance-
Free Battery. The engine may run rough when first
started after a battery disconnect until the control
module “relearns” these functions.
MAINTAINING YOUR VEHICLE 209
7

Check the battery every 4 to 6 weeks to ensure that the
voltage is above 12.40. Voltage will drop more rapidly
in hot temperatures. If battery voltage drops below
12.40, follow the battery recharge procedure in the
Service Manual.
•Check that the radiator coolant level of protection is to
at least -20°F (-29°C).
•Block the wheels. Do not apply the Parking Brake.
•Make sure that all tires are inflated to the optimum
pressure, (29 PSI).
•Cut blocks of plywood about the same size of the tires.
Cover each block with indoor/outdoor carpeting and
place them between the tires and concrete. This will
prevent tire flat spotting.
•For long term storage, remove the tires and put the
vehicle up on blocks. Stack the tires on plywood and
cover with a tarp to prevent flat spotting.
•Move the wiper blades away from the windshield.
NOTE:To help prevent the battery from discharging
during shorter periods of inactivity, perform the follow-
ing:
1. Make sure that the trunk/liftgate, hood, doors, win-
dows and convertible top are completely closed.
2. Make sure that remote transmitter is operating and
that the battery is good.
3. Make sure that the hood, trunk/liftgate and door
switches are in adjustment. Perform the quick system
check which follows.
Use the remote transmitter to set the alarm. If the alarm
SET light comes on and flashes, the system is operating
properly. If not, there is a problem with a switch or the
system. See your dealer for service.
210 MAINTAINING YOUR VEHICLE