check transmission fluid DODGE VIPER 2008 ZB II / 2.G Owners Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 2008, Model line: VIPER, Model: DODGE VIPER 2008 ZB II / 2.GPages: 303, PDF Size: 2.65 MB
Page 142 of 303
Flowing/Rising Water
WARNING!
Do not drive on or cross a road or a path where water
is flowing and/or rising (as in storm run-off). Flow-
ing water can wear away the road or path's surface
and cause your vehicle to sink into deeper water.
Furthermore, flowing and/or rising water can carry
your vehicle away swiftly. Failure to follow this
warning may result in injuries that are serious or
fatal to you, your passengers, and others around you.
Shallow Standing Water
Although your vehicle is capable of driving through
shallow standing water, consider the following before
doing so:
CAUTION!
²Always check the depth of the standing water before
driving through it. Never drive through standing water that
is deeper than the bottom of the tire rims mounted on the
vehicle.
²Determine the condition of the road or the path that is
under water and if there are any obstacles in the way before
driving through the standing water.
²Do not exceed 5 mph (8 km/h) when driving through
standing water. This will minimize wave effects.
²Driving through standing water may cause damage to your
vehicle's drivetrain components. Always inspect your ve-
hicle's fluids (i.e., engine oil, transmission, axle, etc.) for
signs of contamination (i.e., fluid that is milky or foamy in
appearance) after driving through standing water. Do not
continue to operate the vehicle if any fluid appears con-
taminated, as this may result in further damage. Such
damage is not covered by the new vehicle limited warranty.
²Getting water inside your vehicle's engine can cause it to
lockup and stall out and cause serious internal damage to
the engine. Such damage is not covered by the new vehicle
limited warranty.
STARTING AND OPERATING 141
5
Page 193 of 303
NBattery Save Feature...................210
NAir Conditioner Maintenance.............212
NPower Steering Ð Fluid Check............213
NFront & Rear Suspension Ball Joints........214
NSteering Linkage......................214
NBody Lubrication.....................215
NBody Mechanism Lubrication.............215
NWindshield Wiper Blades................217
NWindshield Washers...................217
NExhaust System......................218
NCooling System.......................219
NHoses And Vacuum/Vapor Harnesses.......224NFuel System.........................224
NBrake System........................225
NTransmission........................228
NHydraulic Clutch.....................228
NRear Axle...........................230
NWheel Bearings.......................230
NAppearance Care And Protection From
Corrosion...........................230
mFuses (Power Distribution Centers)..........234
NFuses (Power Distribution Center).........234
NFuses (Mini-Power Distribution Center).....237
mVehicle Storage........................238
192 MAINTAINING YOUR VEHICLE
Page 229 of 303
Transmission
Transmission Fluid Level Check
Check the fluid in the transmission when performing
other underhood services.
Check the fluid level by removing the fill plug located on
the left side of the transmission. The fluid level should be
at the bottom of the fill hole. Add fluid, if necessary, to
maintain the proper level. Refer to the ªFluids, Lubri-
cants, and Genuine Partsº for the correct fluid type.
CAUTION!
Using a transmission fluid other than the manufac-
turer's recommended fluid may cause deterioration
in transmission shift quality and/or damage to the
transmission. Refer to the ªFluids, Lubricants, and
Genuine Partsº for the correct fluid type.
Change Transmission Fluid
Change the fluid at the intervals specified in the Main-
tenance Schedules in this manual. If contaminated with
water, change the fluid immediately. See your authorized
dealer for service.
Hydraulic Clutch
Master Cylinder Ð Clutch Fluid Level Check
Check the fluid in the clutch master cylinder when
performing underhood services.
Clean the top of the master cylinder area before removing
the cap. If necessary, add fluid to the reservoir.
Do Not Overfill. Overfilling can cause clutch release
problems as the clutch wears. A low fluid level may
indicate a leak, in which case, hydraulic clutch linkage
replacement may be required. The fluid level in the
reservoir will rise as the clutch wears - Do Not Remove
Fluid.
228 MAINTAINING YOUR VEHICLE
Page 259 of 303
At Each Stop for Fuel
²Check the engine oil level about 5 minutes after a fully
warmed engine is shut off. Checking the oil level while
the vehicle is on level ground will improve the accu-
racy of the oil level reading. Add oil only when the
level is at or below the ADD or MIN mark.
²Check the windshield washer solvent and add if
required.
Once a Month
²Check tire pressure and look for unusual wear or
damage.
²Inspect the battery, and clean and tighten the terminals
as required.
²Check the fluid levels of the coolant reservoir, brake
master cylinder, power steering, and transmission,
and add as needed.
²Check all lights and all other electrical items for correct
operation.
At Each Oil Change
²Change the engine oil filter.
²Inspect the exhaust system.
NOTE:Also, inspect the exhaust system if you notice a
change in the sound of the exhaust system, or if the
exhaust fumes can be detected inside the vehicle.
²Inspect the brake hoses.
²Inspect the suspension components.
²Lubricate door hinges and check springs.
²Check the engine coolant level, hoses, and clamps.
²Check power steering fluid level.
258 MAINTENANCE SCHEDULES
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S
Page 295 of 303
LowTire ............................ 101
Malfunction Indicator (Check Engine)........ 98
Map Reading.......................... 84
Oil Pressure.......................... 105
Park................................ 81
Passing.............................. 84
Reading.............................. 84
Seat Belt Reminder..................... 103
Service...........................240,242
Service Engine Soon (Malfunction Indicator).... 98
Tire Pressure Monitoring (TPMS)........101,166
Turn Signal.........................82,99
Voltage............................. 106
Loading Vehicle......................... 173
Capacities........................... 173
Tires ............................... 153
Locks................................. 23
Door................................ 23
Power Door........................... 24Low Tire Indicator....................... 166
Low Tire Pressure System.................. 166
Lubricants..........................214,215
Lubrication, Body....................... 215
Luggage/Cargo Capacity.................. 173
Maintenance Free Battery.................. 206
Maintenance Procedures................... 198
Maintenance Schedule.................... 256
Light Duty Schedule ªBº................. 259
Schedule ªAº......................... 269
Schedule ªBº......................... 259
Malfunction Indicator Light (Check Engine) . . . 98,196
Manual, Service......................... 282
Manual Transmission..................... 136
Fluid Level Check...................228,253
Lubricant Selection..................... 253
Shift Speeds.......................... 138
Message Center.......................... 97
294 INDEX