brake FIAT 500 1971 1.G Workshop Manual

FIAT 500 1971 1.G Workshop Manual 500 1971 1.G FIAT FIAT https://www.carmanualsonline.info/img/10/4482/w960_4482-0.png FIAT 500 1971 1.G Workshop Manual

Page 39 of 128

FIAT 500 1971 1.G Workshop Manual 2:12 Fault diagnosis
(a) Leakage or insufficient fuel delivered
1 Air vent in tank restricted
2 Petrol pipes blocked
3 Air leaks at pipe connections
4 Pump or carburetter filters blocked
5 Pump gasket

Page 72 of 128

FIAT 500 1971 1.G Workshop Manual CHAPTER 7
REAR SUSPENSION AND WHEELS
7:1
7:2
7:3
7:4Description
Removal of rear suspension assembly
Servicing swinging arms
Coil springs
7:1 Description
The  rear  wheels are independently sprung by m

Page 73 of 128

FIAT 500 1971 1.G Workshop Manual FIG 7 : 1  Rear suspension assembly
Key to Fig 7 : 1 1 Brake shoe control cable and sheath  2 Coil spring  3  Oil  boot  4  Axle shaft 5 Bumper
6 Flexible joint 7 Swinging arm 8 Cable adjusting nut  9

Page 74 of 128

FIAT 500 1971 1.G Workshop Manual FIG 7 :2  Right rear suspension  assembly, sectioned through brake drum and arm mountings
5 Check the mating surface of the bearing inner rings on
the wheel shaft and ensure that it is perfectly smoot

Page 76 of 128

FIAT 500 1971 1.G Workshop Manual high bearing preload. To reset remove the wheel shaft
and fit a new resilient spacer. Repeat the rotation
torque test.
Swinging arm adjustment:
To adjust the swinging arm use Fiat fixture A.66064 as
s

Page 77 of 128

FIAT 500 1971 1.G Workshop Manual FIG 7:9  Adjusting  rear  wheel toe-in on 500 StationWagon
FIG 7:10 Checking left rear wheel toe-in
84
6 Insert the inner spring between the axle shaft and the
wheel shaft and couple the spline slee

Page 78 of 128

FIAT 500 1971 1.G Workshop Manual TOOL A.66062
SUPPORT C. 696/3GAUGE C.696
FIG 7:12 Checking left rear wheel toe-in
ARM C. 696/3
GAUGE C . 6 9 6
FIG 7:11 Checking left rear wheel toe-in
F500
FIG 7:13 Sectional view of right side rear

Page 79 of 128

FIAT 500 1971 1.G Workshop Manual A tolerance of —10.+ 15 is permitted providing
that the value  is the same for  both rear  wheels. It is
important that  both rear  wheels are set to the same
angle otherwise uneven tyre wear and

Page 80 of 128

FIAT 500 1971 1.G Workshop Manual CHAPTER 8
FRONT SUSPENSION AND HUBS
8:1
8:2
8:3
8:4
8:5
8:6Description
Front suspension removal and dismantling
Leaf spring
Swinging arms
Kingpin housing
Steering knuckle and wheel hub
8:1 Description

Page 84 of 128

FIAT 500 1971 1.G Workshop Manual 2  Check that the surface of the pin that is in contact with
the camber and castor adjuster shims does not show
any signs of indentation or roughness which could
affect the  accuracy of adjustment on
Page:   1-10 11-20 21-30 next >